u-boot/configs/zynq_zc770_xm011_x16_defconfig
Tom Rini c76c93a3d5 configs: Rename CONFIG_IMAGE_FORMAT_LEGACY to CONFIG_LEGACY_IMAGE_FORMAT
The name CONFIG_LEGACY_IMAGE_FORMAT reads slightly better along with
allowing us to avoid a rather nasty Kbuild/Kconfig issue down the line
with CONFIG_IS_ENABLED(IMAGE_FORMAT_LEGACY).  In a few places outside of
cmd/ switch to using CONFIG_IS_ENABLED() to test what is set.

Signed-off-by: Tom Rini <trini@konsulko.com>
2019-07-11 14:11:18 -04:00

47 lines
1.2 KiB
Plaintext

CONFIG_ARM=y
CONFIG_SPL_SYS_DCACHE_OFF=y
CONFIG_ARCH_ZYNQ=y
CONFIG_SYS_TEXT_BASE=0x4000000
CONFIG_SPL_STACK_R_ADDR=0x200000
CONFIG_SPL=y
CONFIG_DEBUG_UART_BASE=0xe0001000
CONFIG_DEBUG_UART_CLOCK=50000000
CONFIG_IDENT_STRING=" Xilinx Zynq ZC770 XM011 x16"
# CONFIG_SPL_FS_FAT is not set
CONFIG_DEBUG_UART=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_SYS_CUSTOM_LDSCRIPT=y
CONFIG_SYS_LDSCRIPT="arch/arm/mach-zynq/u-boot.lds"
CONFIG_FIT=y
CONFIG_FIT_SIGNATURE=y
CONFIG_FIT_VERBOSE=y
CONFIG_LEGACY_IMAGE_FORMAT=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_OS_BOOT=y
CONFIG_SYS_PROMPT="Zynq> "
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_FPGA_LOADBP=y
CONFIG_CMD_FPGA_LOADFS=y
CONFIG_CMD_FPGA_LOADMK=y
CONFIG_CMD_FPGA_LOADP=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_NAND_LOCK_UNLOCK=y
# CONFIG_CMD_SETEXPR is not set
# CONFIG_CMD_NET is not set
CONFIG_CMD_CACHE=y
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_DEFAULT_DEVICE_TREE="zynq-zc770-xm011-x16"
CONFIG_SPL_DM_SEQ_ALIAS=y
CONFIG_BLK=y
CONFIG_FPGA_XILINX=y
CONFIG_FPGA_ZYNQPL=y
CONFIG_DM_GPIO=y
# CONFIG_MMC is not set
CONFIG_MTD_DEVICE=y
CONFIG_NAND=y
CONFIG_NAND_ZYNQ=y
CONFIG_DEBUG_UART_ZYNQ=y
CONFIG_DEBUG_UART_ANNOUNCE=y
CONFIG_ZYNQ_SERIAL=y