e4aa8edb6e
Add CMD_GPIO to Kconfig and run tools/moveconfig.py . Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Reviewed-by: Simon Glass <sjg@chromium.org>
18 lines
476 B
Plaintext
18 lines
476 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_MACH_SUN7I=y
|
|
CONFIG_DRAM_CLK=408
|
|
CONFIG_DRAM_ZQ=122
|
|
CONFIG_USB1_VBUS_PIN="PH11"
|
|
CONFIG_GMAC_TX_DELAY=3
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun7i-a20-pcduino3-nano"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL=y
|
|
CONFIG_SYS_EXTRA_OPTIONS="SUNXI_GMAC,RGMII,AHCI,SATAPWR=SUNXI_GPH(2)"
|
|
# CONFIG_CMD_IMLS is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_CMD_FPGA is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_ETH_DESIGNWARE=y
|
|
CONFIG_USB_EHCI_HCD=y
|