dec3030638
When falcon mode support was added, it was right around when SPL_OS_BOOT was migrated to Kconfig. So first we must move the enablement to the defconfig file. Next, it turned off EXT support rather than add the information to allow for falcon mode from EXT. Add this information so that the board compiles after5d28b930f2. Fixes:d96796ca23("mx6sabresd: Add Falcon mode support") Cc: Fabio Estevam <fabio.estevam@nxp.com> Signed-off-by: Tom Rini <trini@konsulko.com>
52 lines
1.2 KiB
Plaintext
52 lines
1.2 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_MX6=y
|
|
CONFIG_SPL_GPIO_SUPPORT=y
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_TARGET_MX6SABRESD=y
|
|
CONFIG_SPL_EXT_SUPPORT=y
|
|
CONFIG_SPL_I2C_SUPPORT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_MMC_SUPPORT=y
|
|
CONFIG_SPL_SERIAL_SUPPORT=y
|
|
CONFIG_SPL_WATCHDOG_SUPPORT=y
|
|
CONFIG_VIDEO=y
|
|
CONFIG_SYS_EXTRA_OPTIONS="IMX_CONFIG=arch/arm/imx-common/spl_sd.cfg,SPL,MX6Q"
|
|
CONFIG_BOOTDELAY=3
|
|
# CONFIG_CONSOLE_MUX is not set
|
|
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
|
|
CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE=y
|
|
CONFIG_SPL=y
|
|
CONFIG_SPL_OS_BOOT=y
|
|
CONFIG_HUSH_PARSER=y
|
|
CONFIG_CMD_BOOTZ=y
|
|
# CONFIG_CMD_IMLS is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_SF=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_USB=y
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_DHCP=y
|
|
CONFIG_CMD_MII=y
|
|
CONFIG_CMD_PING=y
|
|
CONFIG_CMD_CACHE=y
|
|
CONFIG_CMD_EXT2=y
|
|
CONFIG_CMD_EXT4=y
|
|
CONFIG_CMD_EXT4_WRITE=y
|
|
CONFIG_CMD_FAT=y
|
|
CONFIG_CMD_FS_GENERIC=y
|
|
CONFIG_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_STMICRO=y
|
|
CONFIG_PCI=y
|
|
CONFIG_USB=y
|
|
CONFIG_USB_STORAGE=y
|
|
CONFIG_USB_GADGET=y
|
|
CONFIG_CI_UDC=y
|
|
CONFIG_USB_GADGET_DOWNLOAD=y
|
|
CONFIG_G_DNL_MANUFACTURER="FSL"
|
|
CONFIG_G_DNL_VENDOR_NUM=0x0525
|
|
CONFIG_G_DNL_PRODUCT_NUM=0xa4a5
|
|
# CONFIG_VIDEO_SW_CURSOR is not set
|
|
CONFIG_OF_LIBFDT=y
|