8d8ee47e03
Today in initr_reloc_global_data() we use some non-obvious tests to determine if we need to relocate the env_addr within gd or not. In order to facilitate migration of other symbols to Kconfig we need to introduce a new symbol for this particular use case. Cc: Wolfgang Denk <wd@denx.de> Cc: Joe Hershberger <joe.hershberger@ni.com> Signed-off-by: Tom Rini <trini@konsulko.com>
43 lines
1.2 KiB
Plaintext
43 lines
1.2 KiB
Plaintext
CONFIG_ARM=y
|
|
# CONFIG_SYS_THUMB_BUILD is not set
|
|
CONFIG_ARCH_OMAP2PLUS=y
|
|
CONFIG_SYS_TEXT_BASE=0x80100000
|
|
CONFIG_TARGET_SNIPER=y
|
|
CONFIG_NR_DRAM_BANKS=2
|
|
CONFIG_SPL=y
|
|
CONFIG_SPL_TEXT_BASE=0x40200000
|
|
CONFIG_DISTRO_DEFAULTS=y
|
|
# CONFIG_USE_BOOTCOMMAND is not set
|
|
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
|
|
# CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=2
|
|
# CONFIG_SPL_FS_EXT4 is not set
|
|
# CONFIG_SPL_NAND_SUPPORT is not set
|
|
CONFIG_SYS_PROMPT="sniper # "
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
# CONFIG_CMD_SETEXPR is not set
|
|
# CONFIG_CMD_NFS is not set
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_USB_FUNCTION_FASTBOOT=y
|
|
CONFIG_FASTBOOT_BUF_ADDR=0x82000000
|
|
CONFIG_FASTBOOT_BUF_SIZE=0x2000000
|
|
CONFIG_FASTBOOT_FLASH=y
|
|
CONFIG_FASTBOOT_FLASH_MMC_DEV=0
|
|
CONFIG_SYS_OMAP24_I2C_SPEED=400000
|
|
CONFIG_TWL4030_INPUT=y
|
|
CONFIG_MMC_OMAP_HS=y
|
|
CONFIG_CONS_INDEX=3
|
|
CONFIG_USB=y
|
|
CONFIG_USB_MUSB_GADGET=y
|
|
CONFIG_USB_MUSB_OMAP2PLUS=y
|
|
CONFIG_TWL4030_USB=y
|
|
CONFIG_USB_GADGET=y
|
|
CONFIG_USB_GADGET_MANUFACTURER="Texas Instruments"
|
|
CONFIG_USB_GADGET_VENDOR_NUM=0x0451
|
|
CONFIG_USB_GADGET_PRODUCT_NUM=0xd022
|
|
CONFIG_OF_LIBFDT=y
|