4f67b93fb7
We enabled CONFIG_ISO_PARTITION by default for distro boot, so that U-Boot could load distro images that usually get shipped as iso images. These images usually come with a board agnostic boot environment. However, there is very little point in having ISO support enabled (for anyone really) in SPL, as the whole idea of SPL is to load U-Boot proper which again is board specific. So the fact that we enable ISO support in U-Boot proper does not mean at all that we want ISO support in U-Boot SPL. Hence, let's remove the Kconfig dependency. Along the way, let's also clean up all those default configs that disabled SPL ISO support. Signed-off-by: Alexander Graf <agraf@suse.de>
36 lines
823 B
Plaintext
36 lines
823 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_TEGRA=y
|
|
CONFIG_SYS_TEXT_BASE=0x80110000
|
|
CONFIG_TEGRA30=y
|
|
CONFIG_TARGET_TEC_NG=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="tegra30-tec-ng"
|
|
CONFIG_FIT=y
|
|
CONFIG_OF_SYSTEM_SETUP=y
|
|
CONFIG_CONSOLE_MUX=y
|
|
CONFIG_SYS_STDIO_DEREGISTER=y
|
|
CONFIG_SYS_PROMPT="Tegra30 (TEC-NG) # "
|
|
# CONFIG_CMD_IMI is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_SF=y
|
|
CONFIG_CMD_SPI=y
|
|
CONFIG_CMD_USB=y
|
|
# CONFIG_CMD_SETEXPR is not set
|
|
# CONFIG_CMD_NFS is not set
|
|
CONFIG_CMD_EXT4_WRITE=y
|
|
# CONFIG_SPL_DOS_PARTITION is not set
|
|
# CONFIG_SPL_EFI_PARTITION is not set
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPI_FLASH=y
|
|
CONFIG_SPI_FLASH_WINBOND=y
|
|
CONFIG_SYS_NS16550=y
|
|
CONFIG_TEGRA20_SLINK=y
|
|
CONFIG_USB=y
|
|
CONFIG_DM_USB=y
|
|
CONFIG_USB_EHCI_HCD=y
|
|
CONFIG_USB_STORAGE=y
|
|
CONFIG_USB_HOST_ETHER=y
|
|
CONFIG_USB_ETHER_SMSC95XX=y
|