f34ccce50a
CONFIG_SYS_FSL_ESDHC_FORCE_VSELECT is not the correct method to set I/O to 1.8. To boards that does not support vqmmc-supply, use vs18_enable in fsl_esdhc_cfg. If regulator is supported, use fixed 1.8V regulator for vqmmc-supply. Signed-off-by: Peng Fan <peng.fan@nxp.com> Cc: Jaehoon Chung <jh80.chung@samsung.com> Cc: York Sun <york.sun@nxp.com> Cc: Stefano Babic <sbabic@denx.de>
23 lines
864 B
Plaintext
23 lines
864 B
Plaintext
Freescale esdhc-specific options
|
|
|
|
- CONFIG_FSL_ESDHC_ADAPTER_IDENT
|
|
Support Freescale adapter card type identification. This is implemented by
|
|
operating Qixis FPGA relevant registers. The STAT_PRES1 register has SDHC
|
|
Card ID[0:2] bits showing the type of card installed in the SDHC Adapter Slot.
|
|
|
|
SDHC Card ID[0:2] Adapter Card Type
|
|
0b000 reserved
|
|
0b001 eMMC Card Rev4.5
|
|
0b010 SD/MMC Legacy Card
|
|
0b011 eMMC Card Rev4.4
|
|
0b100 reserved
|
|
0b101 MMC Card
|
|
0b110 SD Card Rev2.0/3.0
|
|
0b111 No card is present
|
|
- CONFIG_SYS_FSL_ESDHC_LE
|
|
ESDHC IP is in little-endian mode. Accessing ESDHC registers can be
|
|
determined by ESDHC IP's endian mode or processor's endian mode.
|
|
- CONFIG_SYS_FSL_ESDHC_BE
|
|
ESDHC IP is in big-endian mode. Accessing ESDHC registers can be determined
|
|
by ESDHC IP's endian mode or processor's endian mode.
|