u-boot/configs/am65x_hs_evm_a53_defconfig
Suman Anna 8162e8ac70 configs: am65x_evm_a53: Disable K3_SYSTEM_CONTROLLER
The K3 System Controller driver is used for loading and starting
the System Firmware, and is used only on R5 SPL. It need not be
enabled and built for the A53 U-Boot and SPL, so disable it from
both the GP and HS AM65x A53 defconfigs.

While at this, also remove the unneeded CONFIG_SPL_REMOTEPROC and
CONFIG_CMD_REMOTEPROC as no remoteprocs are now loaded from A53 SPL.

Signed-off-by: Suman Anna <s-anna@ti.com>
Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>
2019-07-31 13:08:07 -04:00

85 lines
2.2 KiB
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_K3=y
CONFIG_TI_SECURE_DEVICE=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_SYS_MALLOC_F_LEN=0x8000
CONFIG_SOC_K3_AM6=y
CONFIG_TARGET_AM654_A53_EVM=y
CONFIG_SPL_MMC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=2
CONFIG_SPL_STACK_R_ADDR=0x82000000
CONFIG_SPL_FS_FAT=y
CONFIG_SPL_LIBDISK_SUPPORT=y
CONFIG_DISTRO_DEFAULTS=y
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_FIT_IMAGE_POST_PROCESS=y
CONFIG_SPL_LOAD_FIT=y
CONFIG_SPL_FIT_IMAGE_POST_PROCESS=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
# CONFIG_DISPLAY_CPUINFO is not set
CONFIG_SPL_TEXT_BASE=0x80080000
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
CONFIG_SPL_STACK_R=y
CONFIG_SPL_SEPARATE_BSS=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x1400
CONFIG_SPL_I2C_SUPPORT=y
CONFIG_SPL_DM_MAILBOX=y
CONFIG_SPL_DM_RESET=y
CONFIG_SPL_POWER_DOMAIN=y
CONFIG_SPL_YMODEM_SUPPORT=y
CONFIG_CMD_ASKENV=y
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_TIME=y
# CONFIG_ISO_PARTITION is not set
# CONFIG_EFI_PARTITION is not set
CONFIG_OF_CONTROL=y
CONFIG_SPL_OF_CONTROL=y
CONFIG_DEFAULT_DEVICE_TREE="k3-am654-base-board"
CONFIG_SPL_MULTI_DTB_FIT=y
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
CONFIG_ENV_IS_IN_FAT=y
CONFIG_ENV_FAT_INTERFACE="mmc"
CONFIG_ENV_FAT_DEVICE_AND_PART="1:1"
CONFIG_DM=y
CONFIG_SPL_DM=y
CONFIG_SPL_DM_SEQ_ALIAS=y
CONFIG_CLK=y
CONFIG_SPL_CLK=y
CONFIG_CLK_TI_SCI=y
CONFIG_DMA_CHANNELS=y
CONFIG_TI_K3_NAVSS_UDMA=y
CONFIG_TI_SCI_PROTOCOL=y
CONFIG_DM_GPIO=y
CONFIG_DM_PCA953X=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_SYS_I2C_OMAP24XX=y
CONFIG_DM_MAILBOX=y
CONFIG_K3_SEC_PROXY=y
CONFIG_DM_MMC=y
CONFIG_MMC_SDHCI=y
CONFIG_MMC_SDHCI_K3_ARASAN=y
CONFIG_PINCTRL=y
# CONFIG_PINCTRL_GENERIC is not set
CONFIG_SPL_PINCTRL=y
# CONFIG_SPL_PINCTRL_GENERIC is not set
CONFIG_PINCTRL_SINGLE=y
CONFIG_POWER_DOMAIN=y
CONFIG_TI_SCI_POWER_DOMAIN=y
CONFIG_DM_RESET=y
CONFIG_RESET_TI_SCI=y
CONFIG_DM_SERIAL=y
CONFIG_SOC_TI=y
CONFIG_SYSRESET=y
CONFIG_SPL_SYSRESET=y
CONFIG_SYSRESET_TI_SCI=y
CONFIG_OF_LIBFDT_OVERLAY=y