08574ed339
This converts the following to Kconfig: CONFIG_SYS_MONITOR_LEN To do this, we set a default of 0 for everyone because there are a number of cases where we define CONFIG_SYS_MONITOR_LEN but the only impact is that we set TOTAL_MALLOC_LEN to be CONFIG_SYS_MALLOC_LEN + CONFIG_ENV_SIZE, so we must continue to allow all boards to set this value. Update the SPL code to use 200 KB as the default raw U-Boot size directly, if we don't have a real CONFIG_SYS_MONITOR_LEN value. Signed-off-by: Tom Rini <trini@konsulko.com> Reviewed-by: Simon Glass <sjg@chromium.org>
142 lines
3.7 KiB
Plaintext
142 lines
3.7 KiB
Plaintext
CONFIG_PPC=y
|
|
CONFIG_TEXT_BASE=0x11000000
|
|
CONFIG_SYS_MALLOC_LEN=0x100000
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_ENV_SIZE=0x2000
|
|
CONFIG_ENV_OFFSET=0x100000
|
|
CONFIG_ENV_SECT_SIZE=0x10000
|
|
CONFIG_DEFAULT_DEVICE_TREE="p2020rdb-pc_36b"
|
|
CONFIG_SPL_TEXT_BASE=0xf8f80000
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
CONFIG_MPC85xx=y
|
|
CONFIG_SYS_INIT_RAM_LOCK=y
|
|
# CONFIG_CMD_ERRATA is not set
|
|
CONFIG_TARGET_P2020RDB=y
|
|
CONFIG_ENABLE_36BIT_PHYS=y
|
|
CONFIG_SYS_MPC85XX_NO_RESETVEC=y
|
|
CONFIG_SPL_SYS_MPC85XX_NO_RESETVEC=y
|
|
CONFIG_PCIE1=y
|
|
CONFIG_PCIE2=y
|
|
CONFIG_PHYS_64BIT=y
|
|
CONFIG_SYS_MONITOR_LEN=786432
|
|
CONFIG_MP=y
|
|
CONFIG_FIT=y
|
|
CONFIG_FIT_VERBOSE=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
CONFIG_OF_STDOUT_VIA_ALIAS=y
|
|
CONFIG_SPL_SYS_MONITOR_BASE=0xF8F80000
|
|
CONFIG_SPIFLASH=y
|
|
CONFIG_BOOTDELAY=10
|
|
CONFIG_USE_BOOTCOMMAND=y
|
|
CONFIG_BOOTCOMMAND="setenv bootargs root=/dev/$bdev rw rootdelay=30 console=$consoledev,$baudrate $othbootargs;usb start;ext2load usb 0:1 $loadaddr /boot/$bootfile;ext2load usb 0:1 $fdtaddr /boot/$fdtfile;bootm $loadaddr - $fdtaddr"
|
|
CONFIG_BOARD_EARLY_INIT_F=y
|
|
CONFIG_BOARD_EARLY_INIT_R=y
|
|
# CONFIG_MISC_INIT_R is not set
|
|
# CONFIG_SPL_FRAMEWORK is not set
|
|
CONFIG_SPL_MAX_SIZE=0x20000
|
|
CONFIG_SPL_SPI_BOOT=y
|
|
CONFIG_SPL_SYS_CCSR_DO_NOT_RELOCATE=y
|
|
CONFIG_SPL_FLUSH_IMAGE=y
|
|
CONFIG_SPL_GD_ADDR=0xf8f9c000
|
|
CONFIG_SPL_RELOC_STACK=0xf8f9d000
|
|
CONFIG_SPL_RELOC_MALLOC=y
|
|
CONFIG_SPL_RELOC_MALLOC_ADDR=0xf8fa5000
|
|
CONFIG_SPL_RELOC_MALLOC_SIZE=0x5b000
|
|
CONFIG_SPL_ENV_SUPPORT=y
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_MPC8XXX_INIT_DDR=y
|
|
CONFIG_SPL_TARGET="u-boot-with-spl.bin"
|
|
CONFIG_HUSH_PARSER=y
|
|
# CONFIG_AUTO_COMPLETE is not set
|
|
CONFIG_SYS_PBSIZE=276
|
|
CONFIG_CMD_IMLS=y
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_LOADS_ECHO=y
|
|
CONFIG_SYS_LOADS_BAUD_CHANGE=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_PCI=y
|
|
CONFIG_CMD_USB=y
|
|
CONFIG_CMD_MII=y
|
|
CONFIG_CMD_PING=y
|
|
# CONFIG_CMD_HASH is not set
|
|
CONFIG_CMD_EXT2=y
|
|
CONFIG_CMD_FAT=y
|
|
CONFIG_CMD_MTDPARTS=y
|
|
CONFIG_MTDIDS_DEFAULT="nor0=fef000000.nor"
|
|
CONFIG_MTDPARTS_DEFAULT="mtdparts=fef000000.nor:256k(vsc7385-firmware),256k(dtb),4608k(kernel),9984k(fs),1280k(u-boot)"
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_IN_SPI_FLASH=y
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_USE_BOOTFILE=y
|
|
CONFIG_BOOTFILE="uImage"
|
|
CONFIG_USE_ETHPRIME=y
|
|
CONFIG_ETHPRIME="eTSEC1"
|
|
CONFIG_LBA48=y
|
|
CONFIG_DDR_CLK_FREQ=66666666
|
|
CONFIG_SYS_SPD_BUS_NUM=1
|
|
CONFIG_CHIP_SELECTS_PER_CTRL=1
|
|
CONFIG_SYS_DDR_RAW_TIMING=y
|
|
CONFIG_SYS_BR0_PRELIM_BOOL=y
|
|
CONFIG_SYS_BR0_PRELIM=0xEF001001
|
|
CONFIG_SYS_OR0_PRELIM=0xFC000FF7
|
|
CONFIG_SYS_BR2_PRELIM_BOOL=y
|
|
CONFIG_SYS_BR2_PRELIM=0xFFB00801
|
|
CONFIG_SYS_OR2_PRELIM=0xFFFE09FF
|
|
CONFIG_SYS_BR3_PRELIM_BOOL=y
|
|
CONFIG_SYS_BR3_PRELIM=0xFFA00801
|
|
CONFIG_SYS_OR3_PRELIM=0xFFF009F7
|
|
CONFIG_SPL_COMMON_INIT_DDR=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_SPL_SYS_I2C_LEGACY=y
|
|
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
|
|
CONFIG_SYS_I2C_FSL=y
|
|
CONFIG_SYS_FSL_I2C_OFFSET=0x3000
|
|
CONFIG_SYS_FSL_HAS_I2C2_OFFSET=y
|
|
CONFIG_SYS_FSL_I2C2_OFFSET=0x3100
|
|
CONFIG_SYS_I2C_EEPROM_ADDR=0x52
|
|
CONFIG_FSL_ESDHC=y
|
|
CONFIG_MTD=y
|
|
CONFIG_MTD_NOR_FLASH=y
|
|
CONFIG_FLASH_CFI_DRIVER=y
|
|
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
|
|
CONFIG_SYS_FLASH_EMPTY_INFO=y
|
|
CONFIG_FLASH_CFI_MTD=y
|
|
CONFIG_SYS_FLASH_CFI=y
|
|
CONFIG_SYS_FLASH_QUIET_TEST=y
|
|
CONFIG_SYS_MAX_FLASH_SECT=128
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SF_DEFAULT_SPEED=10000000
|
|
CONFIG_SPI_FLASH_SPANSION=y
|
|
CONFIG_PHY_ATHEROS=y
|
|
CONFIG_PHY_BROADCOM=y
|
|
CONFIG_PHY_DAVICOM=y
|
|
CONFIG_PHY_LXT=y
|
|
CONFIG_PHY_MARVELL=y
|
|
CONFIG_PHY_NATSEMI=y
|
|
CONFIG_PHY_REALTEK=y
|
|
CONFIG_PHY_SMSC=y
|
|
CONFIG_PHY_VITESSE=y
|
|
CONFIG_PHY_FIXED=y
|
|
CONFIG_DM_MDIO=y
|
|
CONFIG_PHY_GIGE=y
|
|
CONFIG_E1000=y
|
|
CONFIG_MII=y
|
|
CONFIG_TSEC_ENET=y
|
|
CONFIG_PCIE_FSL=y
|
|
CONFIG_DM_RTC=y
|
|
CONFIG_SYS_NS16550=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_FSL_ESPI=y
|
|
CONFIG_USB=y
|
|
CONFIG_USB_EHCI_FSL=y
|
|
CONFIG_USB_STORAGE=y
|
|
CONFIG_ADDR_MAP=y
|