73223f0e1b
There are already two FIT options in Kconfig but the CONFIG options are still in the header files. We need to do a proper move to fix this. Move these options to Kconfig and tidy up board configuration: CONFIG_FIT CONFIG_OF_BOARD_SETUP CONFIG_OF_SYSTEM_SETUP CONFIG_FIT_SIGNATURE CONFIG_FIT_BEST_MATCH CONFIG_FIT_VERBOSE CONFIG_OF_STDOUT_VIA_ALIAS CONFIG_RSA Unfortunately the first one is a little complicated. We need to make sure this option is not enabled in SPL by this change. Also this option is enabled automatically in the host builds by defining CONFIG_FIT in the image.h file. To solve this, add a new IMAGE_USE_FIT #define which can be used in files that are built on the host but must also build for U-Boot and SPL. Note: Masahiro's moveconfig.py script is amazing. Signed-off-by: Simon Glass <sjg@chromium.org> [trini: Add microblaze change, various configs/ re-applies] Signed-off-by: Tom Rini <trini@konsulko.com>
26 lines
772 B
Plaintext
26 lines
772 B
Plaintext
CONFIG_ARM=y
|
|
CONFIG_ARCH_SUNXI=y
|
|
CONFIG_MACH_SUN4I=y
|
|
CONFIG_DRAM_CLK=408
|
|
CONFIG_DRAM_EMR1=4
|
|
CONFIG_USB0_VBUS_PIN="PB9"
|
|
CONFIG_USB0_VBUS_DET="PH5"
|
|
CONFIG_USB0_ID_DET="PH4"
|
|
CONFIG_VIDEO_LCD_MODE="x:1024,y:768,depth:24,pclk_khz:51000,le:19,ri:300,up:6,lo:31,hs:1,vs:1,sync:3,vmode:0"
|
|
CONFIG_VIDEO_LCD_POWER="PH8"
|
|
CONFIG_VIDEO_LCD_BL_EN="PH7"
|
|
CONFIG_VIDEO_LCD_BL_PWM="PB2"
|
|
CONFIG_VIDEO_LCD_PANEL_HITACHI_TX18D42VM=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="sun4i-a10-chuwi-v7-cw0825"
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
# CONFIG_CMD_IMLS is not set
|
|
# CONFIG_CMD_FLASH is not set
|
|
# CONFIG_CMD_FPGA is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_USB_MUSB_HOST=y
|
|
CONFIG_VIDEO_LCD_SPI_CS="PA0"
|
|
CONFIG_VIDEO_LCD_SPI_SCLK="PA1"
|
|
CONFIG_VIDEO_LCD_SPI_MOSI="PA2"
|