68fc449033
Set free_count to zero before walking through ai->erase list in wl_init(). As U-Boot has no workqueue/threads, it immediately calls erase_worker(), which increase for each erased block free_count. Without this patch, free_count gets after this initialized to zero in wl_init(), so the free_count variable always has the maybe wrong value 0. Detected this behaviour on the dxr2 board, where the UBI fastmap gets not written when attaching/dettaching on an empty NAND. It drops instead the error message: could not find any anchor PEB With this patch, fastmap gets written on dettach. Signed-off-by: Heiko Schocher <hs@denx.de> Reviewed-by: Boris Brezillon <boris.brezillon@free-electrons.com> |
||
---|---|---|
.. | ||
nand | ||
onenand | ||
spi | ||
ubi | ||
altera_qspi.c | ||
at45.c | ||
cfi_flash.c | ||
cfi_mtd.c | ||
dataflash.c | ||
ftsmc020.c | ||
jedec_flash.c | ||
Kconfig | ||
Makefile | ||
mtd_uboot.c | ||
mtd-uclass.c | ||
mtdconcat.c | ||
mtdcore.c | ||
mtdcore.h | ||
mtdpart.c | ||
mw_eeprom.c | ||
st_smi.c | ||
stm32_flash.c | ||
stm32_flash.h |