u-boot/board/rockchip/evb_rk3328/README
Kever Yang 625ec503cb rockchip: rk3328: add evb-rk3328 support
evb-rk3328 is an evb from Rockchip based on rk3328 SoC:
- 2 USB2.0 Host port;
- 1 USB3.0 Host port;
- 1 HDMI port;
- 2 10/100M eth port;
- 2GB ddr;
- 16GB eMMC;
- UART to USB debug port;

Signed-off-by: William Zhang <william.zhang@rock-chips.com>
Signed-off-by: Kever Yang <kever.yang@rock-chips.com>
Acked-by: Simon Glass <sjg@chromium.org>
2017-03-16 16:03:46 -06:00

71 lines
1.8 KiB
Plaintext

Introduction
============
RK3328 key features we might use in U-Boot:
* CPU: ARMv8 64bit quad-core Cortex-A53
* IRAM: 36KB
* DRAM: 4GB-16MB dual-channel
* eMMC: support eMMC 5.0/5.1, suport HS400, HS200, DDR50
* SD/MMC: support SD 3.0, MMC 4.51
* USB: USB2.0 EHCI host port *2
* Display: RGB/HDMI/DP/MIPI/EDP
evb key features:
* regulator: pwm regulator for CPU B/L
* PMIC: rk808
* debug console: UART2
In order to support Arm Trust Firmware(ATF), we need to use the
miniloader from rockchip which:
* do DRAM init
* load and verify ATF image
* load and verify U-Boot image
Here is the step-by-step to boot to U-Boot on rk3328.
Get the Source and prebuild binary
==================================
> mkdir ~/evb_rk3328
> cd ~/evb_rk3328
> git clone https://github.com/ARM-software/arm-trusted-firmware.git
> git clone https://github.com/rockchip-linux/rkbin
> git clone https://github.com/rockchip-linux/rkflashtool
Compile ATF
===============
> cd arm-trusted-firmware
> make realclean
> make CROSS_COMPILE=aarch64-linux-gnu- PLAT=rk3328 bl31
Compile U-Boot
==================
> cd ../u-boot
> make CROSS_COMPILE=aarch64-linux-gnu- evb-rk3328_defconfig all
Compile rkflashtool
=======================
> cd ../rkflashtool
> make
Package image for miniloader
================================
> cd ..
> cp arm-trusted-firmware/build/rk3328/release/bl31.bin rkbin/rk33
> ./rkbin/tools/trust_merger rkbin/tools/RK3328TRUST.ini
> ./rkbin/tools/loaderimage --pack --uboot u-boot/u-boot-dtb.bin uboot.img
> mkdir image
> mv trust.img ./image/
> mv uboot.img ./image/rk3328evb-uboot.bin
Flash image
===============
Power on(or reset with RESET KEY) with MASKROM KEY preesed, and then:
> ./rkflashtool/rkflashloader rk3328evb
You should be able to get U-Boot log message in console/UART2 now.