ca8a329a1b
This converts the following to Kconfig: CONFIG_SPL_PAD_TO CONFIG_SPL_MAX_SIZE CONFIG_TPL_PAD_TO CONFIG_TPL_MAX_SIZE Note that we need to make TPL_MAX_SIZE be hex, and so move and convert the existing places. Signed-off-by: Tom Rini <trini@konsulko.com>
103 lines
2.6 KiB
Plaintext
103 lines
2.6 KiB
Plaintext
CONFIG_ARM=y
|
|
CONFIG_SKIP_LOWLEVEL_INIT=y
|
|
CONFIG_ARCH_CPU_INIT=y
|
|
CONFIG_ARCH_OMAP2PLUS=y
|
|
CONFIG_SYS_MALLOC_F_LEN=0x400
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_ENV_SIZE=0x4000
|
|
CONFIG_ENV_OFFSET=0xC0000
|
|
CONFIG_ENV_SECT_SIZE=0x10000
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_SPL_DM_SPI=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="am437x-cm-t43"
|
|
CONFIG_SPL_TEXT_BASE=0x40300350
|
|
CONFIG_AM43XX=y
|
|
CONFIG_TARGET_CM_T43=y
|
|
CONFIG_SPL_MMC=y
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_SPL=y
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_SPL_SPI_FLASH_SUPPORT=y
|
|
CONFIG_SPL_SPI=y
|
|
CONFIG_DISTRO_DEFAULTS=y
|
|
CONFIG_BOOTCOMMAND="mmc dev 0; if mmc rescan; then if run loadbootscript; then run bootscript; fi; fi; mmc dev 1; if mmc rescan; then run emmcboot; fi;"
|
|
CONFIG_SYS_CONSOLE_INFO_QUIET=y
|
|
# CONFIG_DISPLAY_CPUINFO is not set
|
|
# CONFIG_DISPLAY_BOARDINFO is not set
|
|
# CONFIG_MISC_INIT_R is not set
|
|
CONFIG_SPL_MAX_SIZE=0x37690
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x480
|
|
CONFIG_SPL_FS_EXT4=y
|
|
CONFIG_SPL_I2C=y
|
|
CONFIG_SPL_MTD_SUPPORT=y
|
|
# CONFIG_SPL_NAND_SUPPORT is not set
|
|
CONFIG_SPL_NAND_DRIVERS=y
|
|
CONFIG_SPL_NAND_ECC=y
|
|
CONFIG_SPL_NAND_BASE=y
|
|
CONFIG_SPL_DM_SPI_FLASH=y
|
|
CONFIG_SPL_POWER=y
|
|
CONFIG_SPL_SPI_LOAD=y
|
|
CONFIG_SYS_SPI_U_BOOT_OFFS=0x40000
|
|
CONFIG_SYS_PROMPT="CM-T43 # "
|
|
CONFIG_SYS_MAXARGS=64
|
|
CONFIG_SYS_PBSIZE=1050
|
|
CONFIG_CMD_ASKENV=y
|
|
CONFIG_CMD_EEPROM=y
|
|
CONFIG_CMD_EEPROM_LAYOUT=y
|
|
CONFIG_EEPROM_LAYOUT_HELP_STRING="v2, v3"
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=4
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_GPIO=y
|
|
CONFIG_CMD_GPT=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_NAND=y
|
|
CONFIG_CMD_SPI=y
|
|
CONFIG_CMD_USB=y
|
|
# CONFIG_CMD_NFS is not set
|
|
CONFIG_CMD_EXT4_WRITE=y
|
|
CONFIG_CMD_MTDPARTS=y
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_IN_SPI_FLASH=y
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
|
|
CONFIG_VERSION_VARIABLE=y
|
|
CONFIG_BOOTP_SEND_HOSTNAME=y
|
|
CONFIG_SYS_RX_ETH_BUFFER=64
|
|
CONFIG_DM=y
|
|
CONFIG_SYS_I2C_LEGACY=y
|
|
CONFIG_SPL_SYS_I2C_LEGACY=y
|
|
CONFIG_MMC_OMAP_HS=y
|
|
CONFIG_MTD=y
|
|
CONFIG_MTD_RAW_NAND=y
|
|
CONFIG_SYS_NAND_ONFI_DETECTION=y
|
|
CONFIG_SYS_NAND_PAGE_SIZE=0x800
|
|
CONFIG_SYS_NAND_OOBSIZE=0x40
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SF_DEFAULT_SPEED=48000000
|
|
CONFIG_SPI_FLASH_ATMEL=y
|
|
CONFIG_SPI_FLASH_EON=y
|
|
CONFIG_SPI_FLASH_GIGADEVICE=y
|
|
CONFIG_SPI_FLASH_MACRONIX=y
|
|
CONFIG_SPI_FLASH_SPANSION=y
|
|
CONFIG_SPI_FLASH_STMICRO=y
|
|
CONFIG_SPI_FLASH_SST=y
|
|
CONFIG_SPI_FLASH_WINBOND=y
|
|
CONFIG_PHY_ATHEROS=y
|
|
CONFIG_MII=y
|
|
CONFIG_DRIVER_TI_CPSW=y
|
|
CONFIG_POWER_LEGACY=y
|
|
CONFIG_POWER_I2C=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_OMAP3_SPI=y
|
|
CONFIG_USB=y
|
|
CONFIG_USB_XHCI_HCD=y
|
|
CONFIG_USB_XHCI_DWC3=y
|
|
CONFIG_USB_XHCI_OMAP=y
|