90f0819a31
This converts the following to Kconfig: CONFIG_SPL_COMMON_INIT_DDR Signed-off-by: Tom Rini <trini@konsulko.com>
120 lines
3.1 KiB
Plaintext
120 lines
3.1 KiB
Plaintext
CONFIG_PPC=y
|
|
CONFIG_SYS_IMMR=0xFFE00000
|
|
CONFIG_SYS_TEXT_BASE=0x11001000
|
|
CONFIG_SYS_MALLOC_LEN=0x100000
|
|
CONFIG_ENV_SIZE=0x4000
|
|
CONFIG_ENV_OFFSET=0x100000
|
|
CONFIG_DEFAULT_DEVICE_TREE="p1010rdb-pb_36b"
|
|
CONFIG_SPL_TEXT_BASE=0xFF800000
|
|
CONFIG_SPL_SERIAL=y
|
|
CONFIG_TPL_TEXT_BASE=0xD0001000
|
|
CONFIG_TPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_TPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_TPL_SERIAL=y
|
|
CONFIG_SPL_DRIVERS_MISC=y
|
|
CONFIG_SPL=y
|
|
CONFIG_MPC85xx=y
|
|
CONFIG_TARGET_P1010RDB_PB=y
|
|
CONFIG_PHYS_64BIT=y
|
|
CONFIG_FIT=y
|
|
CONFIG_FIT_VERBOSE=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
CONFIG_OF_STDOUT_VIA_ALIAS=y
|
|
CONFIG_TPL_SYS_MONITOR_BASE=0xD0001000
|
|
CONFIG_BOOTDELAY=10
|
|
CONFIG_USE_BOOTCOMMAND=y
|
|
CONFIG_BOOTCOMMAND="setenv bootargs root=/dev/ram rw console=$consoledev,$baudrate $othbootargs ramdisk_size=$ramdisk_size;tftp $ramdiskaddr $ramdiskfile;tftp $loadaddr $bootfile;tftp $fdtaddr $fdtfile;bootm $loadaddr $ramdiskaddr $fdtaddr"
|
|
CONFIG_SYS_CONSOLE_IS_IN_ENV=y
|
|
CONFIG_BOARD_EARLY_INIT_F=y
|
|
CONFIG_BOARD_EARLY_INIT_R=y
|
|
CONFIG_ID_EEPROM=y
|
|
# CONFIG_SPL_FRAMEWORK is not set
|
|
CONFIG_SPL_MAX_SIZE=0x2000
|
|
CONFIG_SPL_NAND_BOOT=y
|
|
CONFIG_SPL_SYS_CCSR_DO_NOT_RELOCATE=y
|
|
CONFIG_SPL_INIT_MINIMAL=y
|
|
CONFIG_SPL_FLUSH_IMAGE=y
|
|
CONFIG_SPL_NAND_SUPPORT=y
|
|
CONFIG_TPL=y
|
|
CONFIG_TPL_MAX_SIZE=0x20000
|
|
CONFIG_TPL_DRIVERS_MISC=y
|
|
CONFIG_TPL_ENV_SUPPORT=y
|
|
CONFIG_TPL_I2C=y
|
|
CONFIG_TPL_MPC8XXX_INIT_DDR=y
|
|
CONFIG_TPL_NAND_SUPPORT=y
|
|
CONFIG_HUSH_PARSER=y
|
|
CONFIG_SYS_PBSIZE=276
|
|
CONFIG_CMD_IMLS=y
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3
|
|
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
CONFIG_CMD_USB=y
|
|
CONFIG_CMD_MII=y
|
|
CONFIG_CMD_PING=y
|
|
CONFIG_CMD_EXT2=y
|
|
CONFIG_CMD_FAT=y
|
|
CONFIG_MTDIDS_DEFAULT="nand0=ff800000.flash"
|
|
CONFIG_MTDPARTS_DEFAULT="mtdparts=ff800000.flash:2m(uboot-env),1m(dtb),5m(kernel),56m(fs),-(usr)"
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_ENV_OVERWRITE=y
|
|
CONFIG_ENV_IS_IN_NAND=y
|
|
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
|
|
CONFIG_USE_BOOTFILE=y
|
|
CONFIG_BOOTFILE="uImage"
|
|
CONFIG_USE_ETHPRIME=y
|
|
CONFIG_ETHPRIME="eTSEC1"
|
|
CONFIG_DM=y
|
|
CONFIG_SYS_SATA_MAX_DEVICE=2
|
|
CONFIG_FSL_CAAM=y
|
|
CONFIG_DDR_CLK_FREQ=66666666
|
|
CONFIG_CHIP_SELECTS_PER_CTRL=1
|
|
CONFIG_TPL_COMMON_INIT_DDR=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_SPL_SYS_I2C_LEGACY=y
|
|
CONFIG_TPL_SYS_I2C_LEGACY=y
|
|
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
|
|
CONFIG_SYS_I2C_FSL=y
|
|
CONFIG_SYS_FSL_I2C_OFFSET=0x3000
|
|
CONFIG_SYS_FSL_HAS_I2C2_OFFSET=y
|
|
CONFIG_SYS_FSL_I2C2_OFFSET=0x3100
|
|
CONFIG_SYS_I2C_EEPROM_ADDR=0x57
|
|
CONFIG_FSL_ESDHC=y
|
|
CONFIG_MTD=y
|
|
CONFIG_MTD_NOR_FLASH=y
|
|
CONFIG_FLASH_CFI_DRIVER=y
|
|
CONFIG_SYS_FLASH_USE_BUFFER_WRITE=y
|
|
CONFIG_SYS_FLASH_CFI=y
|
|
CONFIG_MTD_RAW_NAND=y
|
|
CONFIG_NAND_FSL_IFC=y
|
|
CONFIG_SYS_NAND_ONFI_DETECTION=y
|
|
CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
|
|
CONFIG_SYS_NAND_U_BOOT_OFFS=0x20000
|
|
CONFIG_DM_SPI_FLASH=y
|
|
CONFIG_SF_DEFAULT_SPEED=10000000
|
|
CONFIG_SPI_FLASH_SPANSION=y
|
|
CONFIG_PHY_ATHEROS=y
|
|
CONFIG_PHY_BROADCOM=y
|
|
CONFIG_PHY_DAVICOM=y
|
|
CONFIG_PHY_LXT=y
|
|
CONFIG_PHY_MARVELL=y
|
|
CONFIG_PHY_NATSEMI=y
|
|
CONFIG_PHY_REALTEK=y
|
|
CONFIG_PHY_SMSC=y
|
|
CONFIG_PHY_VITESSE=y
|
|
CONFIG_DM_ETH=y
|
|
CONFIG_DM_MDIO=y
|
|
CONFIG_PHY_GIGE=y
|
|
CONFIG_E1000=y
|
|
CONFIG_MII=y
|
|
CONFIG_TSEC_ENET=y
|
|
CONFIG_PCIE_FSL=y
|
|
CONFIG_DM_RTC=y
|
|
CONFIG_SYS_NS16550=y
|
|
CONFIG_SPI=y
|
|
CONFIG_DM_SPI=y
|
|
CONFIG_FSL_ESPI=y
|
|
CONFIG_USB=y
|
|
CONFIG_USB_EHCI_FSL=y
|
|
CONFIG_ADDR_MAP=y
|