39e8576164
The mx5 lowlevel_init.S contains board-specific code based on the reference design. Let's keep it since it avoids creating new lowlevel_init files and it may be used by many boards. But add a config to make it optional in order not to cause issues on boards not following this part of the reference design. Signed-off-by: Benoît Thébaudeau <benoit.thebaudeau@advansee.com> Cc: Stefano Babic <sbabic@denx.de> Cc: Matt Sealey <matt@genesi-usa.com> Acked-by: Stefano Babic <sbabic@denx.de>
23 lines
1.0 KiB
Plaintext
23 lines
1.0 KiB
Plaintext
U-Boot for Freescale i.MX5x
|
|
|
|
This file contains information for the port of U-Boot to the Freescale
|
|
i.MX5x SoCs.
|
|
|
|
1. CONFIGURATION OPTIONS/SETTINGS
|
|
---------------------------------
|
|
|
|
1.1 CONFIG_MX51_PLL_ERRATA: Workaround for i.MX51 PLL errata.
|
|
This option should be enabled by all boards using the i.MX51 silicon
|
|
version up until (including) 3.0 running at 800MHz.
|
|
The PLL's in the i.MX51 processor can go out of lock due to a metastable
|
|
condition in an analog flip-flop when used at high frequencies.
|
|
This workaround implements an undocumented feature in the PLL (dither
|
|
mode), which causes the effect of this failure to be much lower (in terms
|
|
of frequency deviation), avoiding system failure, or at least decreasing
|
|
the likelihood of system failure.
|
|
|
|
1.2 CONFIG_SYS_MAIN_PWR_ON: Trigger MAIN_PWR_ON upon startup.
|
|
This option should be enabled for boards having a SYS_ON_OFF_CTL signal
|
|
connected to GPIO1[23] and triggering the MAIN_PWR_ON signal like in the
|
|
reference designs.
|