u-boot/board/variscite/dart_6ul
Simon Glass 401d1c4f5d common: Drop asm/global_data.h from common header
Move this out of the common header and include it only where needed.  In
a number of cases this requires adding "struct udevice;" to avoid adding
another large header or in other cases replacing / adding missing header
files that had been pulled in, very indirectly.   Finally, we have a few
cases where we did not need to include <asm/global_data.h> at all, so
remove that include.

Signed-off-by: Simon Glass <sjg@chromium.org>
Signed-off-by: Tom Rini <trini@konsulko.com>
2021-02-02 15:33:42 -05:00
..
dart_6ul.c common: Drop asm/global_data.h from common header 2021-02-02 15:33:42 -05:00
Kconfig imx: Add variscite DART-6UL Evaluation Kit 2019-04-25 19:16:24 +02:00
MAINTAINERS imx: Add variscite DART-6UL Evaluation Kit 2019-04-25 19:16:24 +02:00
Makefile imx: Add variscite DART-6UL Evaluation Kit 2019-04-25 19:16:24 +02:00
README imx: Add variscite DART-6UL Evaluation Kit 2019-04-25 19:16:24 +02:00
spl.c arm: dart6ul: enable DM_ETH for the dart6ul 2021-01-23 11:30:31 +01:00

How to use U-Boot on variscite DART-6UL Evaluation Kit
------------------------------------------------------

- Configure and build U-Boot for DART-6UL iMX6ULL:

    $ make mrproper
    $ make variscite_dart6ul_defconfig
    $ make

  This will generate SPL and u-boot-dtb.img images.

Boot from MMC/SD:
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

    $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Boot mode settings:

  Boot switch position: SW1 -> 0
			SW2 -> 0

Boot from eMMC:
- if bootpart is not enabled by default, to enable under Linux
	echo 0 >/sys/block/mmcblk1boot0/force_ro
	mmc bootpart enable 1 1 /dev/mmcblk1boot0

- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
    $ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync

- Boot mode settings:

  Boot switch position: SW1 -> 0
			SW2 -> 1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.