u-boot/configs/udoo_defconfig
Tom Rini 08574ed339 Convert CONFIG_SYS_MONITOR_LEN to Kconfig
This converts the following to Kconfig:
   CONFIG_SYS_MONITOR_LEN

To do this, we set a default of 0 for everyone because there are a
number of cases where we define CONFIG_SYS_MONITOR_LEN but the only
impact is that we set TOTAL_MALLOC_LEN to be CONFIG_SYS_MALLOC_LEN +
CONFIG_ENV_SIZE, so we must continue to allow all boards to set this
value. Update the SPL code to use 200 KB as the default raw U-Boot size
directly, if we don't have a real CONFIG_SYS_MONITOR_LEN value.

Signed-off-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
2022-11-10 10:08:55 -05:00

60 lines
1.3 KiB
Plaintext

CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_TEXT_BASE=0x17800000
CONFIG_SYS_MALLOC_LEN=0x0200000
CONFIG_SPL_GPIO=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0xC0000
CONFIG_MX6QDL=y
CONFIG_TARGET_UDOO=y
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="imx6q-udoo"
CONFIG_SPL_TEXT_BASE=0x00908000
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL=y
CONFIG_SPL_LIBDISK_SUPPORT=y
CONFIG_AHCI=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_SYS_MONITOR_LEN=409600
CONFIG_BOOTDELAY=3
CONFIG_BOOTCOMMAND="run findfdt; run distro_bootcmd"
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SYS_SPL_MALLOC=y
CONFIG_SPL_FS_EXT4=y
CONFIG_SPL_FS_LOAD_PAYLOAD_NAME="u-boot-dtb.img"
CONFIG_SPL_I2C=y
CONFIG_SPL_WATCHDOG=y
CONFIG_SYS_MAXARGS=32
CONFIG_SYS_PBSIZE=532
CONFIG_CMD_GPIO=y
CONFIG_CMD_MMC=y
# CONFIG_CMD_PINMUX is not set
CONFIG_CMD_SATA=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_SYS_MMC_ENV_DEV=2
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
CONFIG_BOUNCE_BUFFER=y
CONFIG_DWC_AHSATA=y
CONFIG_LBA48=y
CONFIG_SPL_SYS_I2C_LEGACY=y
CONFIG_FSL_USDHC=y
CONFIG_PHYLIB=y
CONFIG_PHY_MICREL=y
CONFIG_PHY_MICREL_KSZ90X1=y
CONFIG_FEC_MXC=y
CONFIG_MII=y
CONFIG_PINCTRL=y
CONFIG_PINCTRL_IMX6=y
CONFIG_DM_SCSI=y
CONFIG_MXC_UART=y
CONFIG_DM_THERMAL=y