u-boot/configs/lx2160aqds_tfa_defconfig
Tom Rini 08574ed339 Convert CONFIG_SYS_MONITOR_LEN to Kconfig
This converts the following to Kconfig:
   CONFIG_SYS_MONITOR_LEN

To do this, we set a default of 0 for everyone because there are a
number of cases where we define CONFIG_SYS_MONITOR_LEN but the only
impact is that we set TOTAL_MALLOC_LEN to be CONFIG_SYS_MALLOC_LEN +
CONFIG_ENV_SIZE, so we must continue to allow all boards to set this
value. Update the SPL code to use 200 KB as the default raw U-Boot size
directly, if we don't have a real CONFIG_SYS_MONITOR_LEN value.

Signed-off-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
2022-11-10 10:08:55 -05:00

120 lines
3.1 KiB
Plaintext

CONFIG_ARM=y
CONFIG_SKIP_LOWLEVEL_INIT=y
CONFIG_GIC_V3_ITS=y
CONFIG_TARGET_LX2160AQDS=y
CONFIG_TFABOOT=y
CONFIG_TEXT_BASE=0x82000000
CONFIG_SYS_MALLOC_LEN=0x202000
CONFIG_SYS_MALLOC_F_LEN=0x6000
CONFIG_NR_DRAM_BANKS=3
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0x500000
CONFIG_ENV_SECT_SIZE=0x20000
CONFIG_DM_GPIO=y
CONFIG_DEFAULT_DEVICE_TREE="fsl-lx2160a-qds"
CONFIG_FSPI_AHB_EN_4BYTE=y
CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
CONFIG_SEC_FIRMWARE_ARMV8_PSCI=y
CONFIG_ENV_ADDR=0x20500000
CONFIG_AHCI=y
CONFIG_OF_BOARD_FIXUP=y
CONFIG_FSL_USE_PCA9547_MUX=y
CONFIG_VID=y
CONFIG_VID_FLS_ENV="lx2160aqds_vdd_mv"
CONFIG_VOL_MONITOR_LTC3882_READ=y
CONFIG_VOL_MONITOR_LTC3882_SET=y
CONFIG_SYS_FSL_NUM_CC_PLLS=4
CONFIG_FSL_QIXIS=y
CONFIG_REMAKE_ELF=y
CONFIG_SYS_MONITOR_LEN=958464
CONFIG_MP=y
CONFIG_FIT_VERBOSE=y
CONFIG_OF_BOARD_SETUP=y
CONFIG_OF_STDOUT_VIA_ALIAS=y
CONFIG_DYNAMIC_SYS_CLK_FREQ=y
CONFIG_BOOTDELAY=10
CONFIG_USE_BOOTARGS=y
CONFIG_BOOTARGS="console=ttyAMA0,115200 root=/dev/ram0 earlycon=pl011,mmio32,0x21c0000 ramdisk_size=0x2000000 default_hugepagesz=1024m hugepagesz=1024m hugepages=2 pci=pcie_bus_perf"
CONFIG_BOARD_EARLY_INIT_R=y
CONFIG_MISC_INIT_R=y
CONFIG_RESET_PHY_R=y
CONFIG_SYS_MAXARGS=64
CONFIG_SYS_PBSIZE=532
CONFIG_CMD_GREPENV=y
CONFIG_CMD_EEPROM=y
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=3
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
CONFIG_CMD_DM=y
CONFIG_CMD_GPIO=y
CONFIG_CMD_GPT=y
CONFIG_CMD_I2C=y
CONFIG_CMD_MMC=y
CONFIG_CMD_PCI=y
CONFIG_CMD_USB=y
CONFIG_CMD_WDT=y
CONFIG_CMD_CACHE=y
CONFIG_OF_CONTROL=y
CONFIG_OF_LIST="fsl-lx2160a-qds-3-x-x fsl-lx2160a-qds-7-x-x fsl-lx2160a-qds-19-x-x fsl-lx2160a-qds-20-x-x fsl-lx2160a-qds-3-11-x fsl-lx2160a-qds-7-11-x fsl-lx2160a-qds-7-11-x fsl-lx2160a-qds-19-11-x fsl-lx2160a-qds-20-11-x"
CONFIG_MULTI_DTB_FIT=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_MMC=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_USE_ETHPRIME=y
CONFIG_ETHPRIME="DPMAC17@rgmii-id"
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_SATA=y
CONFIG_SATA_CEVA=y
CONFIG_FSL_CAAM=y
CONFIG_DYNAMIC_DDR_CLK_FREQ=y
CONFIG_DIMM_SLOTS_PER_CTLR=2
CONFIG_DDR_ECC=y
CONFIG_ECC_INIT_VIA_DDRCONTROLLER=y
CONFIG_SYS_FSL_DDR_INTLV_256B=y
CONFIG_MPC8XXX_GPIO=y
CONFIG_DM_I2C=y
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
CONFIG_I2C_MUX=y
CONFIG_I2C_MUX_PCA954x=y
CONFIG_SYS_I2C_EEPROM_ADDR=0x57
CONFIG_FSL_ESDHC=y
CONFIG_ESDHC_DETECT_QUIRK=y
CONFIG_MTD=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SPI_FLASH_EON=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_MT35XU=y
CONFIG_SPI_FLASH_SST=y
# CONFIG_SPI_FLASH_USE_4K_SECTORS is not set
CONFIG_PHYLIB=y
CONFIG_PHY_AQUANTIA=y
CONFIG_PHY_CORTINA=y
CONFIG_SYS_CORTINA_NO_FW_UPLOAD=y
CONFIG_PHY_REALTEK=y
CONFIG_PHY_VITESSE=y
CONFIG_FSL_MEMAC=y
CONFIG_SYS_MEMAC_LITTLE_ENDIAN=y
CONFIG_DM_MDIO_MUX=y
CONFIG_E1000=y
CONFIG_MII=y
CONFIG_MDIO_MUX_I2CREG=y
CONFIG_NVME_PCI=y
CONFIG_PCI=y
CONFIG_PCIE_LAYERSCAPE_RC=y
CONFIG_PCIE_LAYERSCAPE_GEN4=y
CONFIG_DM_RTC=y
CONFIG_RTC_PCF2127=y
CONFIG_DM_SCSI=y
CONFIG_DM_SERIAL=y
CONFIG_PL01X_SERIAL=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_FSL_DSPI=y
CONFIG_NXP_FSPI=y
CONFIG_USB=y
CONFIG_USB_XHCI_HCD=y
CONFIG_USB_XHCI_DWC3=y
CONFIG_USB_MAX_CONTROLLER_COUNT=2
CONFIG_WDT=y
CONFIG_WDT_SBSA=y
CONFIG_EFI_LOADER_BOUNCE_BUFFER=y