* Add FEC support for TQM8540 board.
Interfaces are named as follows: "ENET1" - TSEC2, "ENET2" - FEC * Patch by Martin Krause, 04 Apr 2005: Update default configuration for CMC_PU2 board.
This commit is contained in:
wdenk
parent
8aa1a2d115
commit
3dd7f0f0ca
@ -2,6 +2,12 @@
|
||||
Changes for U-Boot 1.1.3:
|
||||
======================================================================
|
||||
|
||||
* Add FEC support for TQM8540 board.
|
||||
Interfaces are named as follows: "ENET1" - TSEC2, "ENET2" - FEC
|
||||
|
||||
* Patch by Martin Krause, 04 Apr 2005:
|
||||
Update default configuration for CMC_PU2 board.
|
||||
|
||||
* Patch by Steven Scholz, 04 Apr 2005:
|
||||
- remove all references to CONFIG_INIT_CRITICAL for ARM based boards
|
||||
- introduce two new configuration options instead:
|
||||
|
||||
@ -277,7 +277,21 @@ static int init_phy(struct eth_device *dev)
|
||||
struct phy_info *curphy;
|
||||
|
||||
/* Assign a Physical address to the TBI */
|
||||
priv->regs->tbipa=TBIPA_VALUE;
|
||||
|
||||
{
|
||||
volatile tsec_t *regs = (volatile tsec_t *)(TSEC_BASE_ADDR);
|
||||
regs->tbipa = TBIPA_VALUE;
|
||||
regs = (volatile tsec_t *)(TSEC_BASE_ADDR + TSEC_SIZE);
|
||||
regs->tbipa = TBIPA_VALUE;
|
||||
asm("msync");
|
||||
}
|
||||
|
||||
/* Reset MII (due to new addresses) */
|
||||
priv->phyregs->miimcfg = MIIMCFG_RESET;
|
||||
asm("msync");
|
||||
priv->phyregs->miimcfg = MIIMCFG_INIT_VALUE;
|
||||
asm("msync");
|
||||
while(priv->phyregs->miimind & MIIMIND_BUSY);
|
||||
|
||||
if(0 == relocated)
|
||||
relocate_cmds();
|
||||
@ -793,19 +807,50 @@ struct phy_info phy_info_dm9161 = {
|
||||
},
|
||||
};
|
||||
|
||||
uint mii_parse_lxt971_sr2(uint mii_reg, struct tsec_private *priv)
|
||||
{
|
||||
unsigned int speed;
|
||||
if (priv->link) {
|
||||
speed = mii_reg & MIIM_LXT971_SR2_SPEED_MASK;
|
||||
|
||||
switch (speed) {
|
||||
case MIIM_LXT971_SR2_10HDX:
|
||||
priv->speed = 10;
|
||||
priv->duplexity = 0;
|
||||
break;
|
||||
case MIIM_LXT971_SR2_10FDX:
|
||||
priv->speed = 10;
|
||||
priv->duplexity = 1;
|
||||
break;
|
||||
case MIIM_LXT971_SR2_100HDX:
|
||||
priv->speed = 100;
|
||||
priv->duplexity = 0;
|
||||
default:
|
||||
priv->speed = 100;
|
||||
priv->duplexity = 1;
|
||||
break;
|
||||
}
|
||||
} else {
|
||||
priv->speed = 0;
|
||||
priv->duplexity = 0;
|
||||
}
|
||||
|
||||
return 0;
|
||||
}
|
||||
|
||||
static struct phy_info phy_info_lxt971 = {
|
||||
0x0001378e,
|
||||
"LXT971",
|
||||
4,
|
||||
(struct phy_cmd []) { /* config */
|
||||
{ MIIM_CONTROL, MIIM_CONTROL_INIT, mii_cr_init }, /* autonegotiate */
|
||||
{ MIIM_CR, MIIM_CR_INIT, mii_cr_init }, /* autonegotiate */
|
||||
{ miim_end, }
|
||||
},
|
||||
(struct phy_cmd []) { /* startup - enable interrupts */
|
||||
/* { 0x12, 0x00f2, NULL }, */
|
||||
{ 0x14, 0xd422, NULL }, /* LED config */
|
||||
{ MIIM_STATUS, miim_read, NULL },
|
||||
{ MIIM_STATUS, miim_read, mii_parse_sr },
|
||||
{ MIIM_STATUS, miim_read, &mii_parse_sr },
|
||||
{ MIIM_LXT971_SR2, miim_read, &mii_parse_lxt971_sr2 },
|
||||
{ miim_end, }
|
||||
},
|
||||
(struct phy_cmd []) { /* shutdown - disable interrupts */
|
||||
|
||||
@ -142,6 +142,14 @@
|
||||
#define MIIM_DM9161_10BTCSR 0x12
|
||||
#define MIIM_DM9161_10BTCSR_INIT 0x7800
|
||||
|
||||
/* LXT971 Status 2 registers */
|
||||
#define MIIM_LXT971_SR2 17 /* Status Register 2 */
|
||||
#define MIIM_LXT971_SR2_SPEED_MASK 0xf000
|
||||
#define MIIM_LXT971_SR2_10HDX 0x1000 /* 10 Mbit half duplex selected */
|
||||
#define MIIM_LXT971_SR2_10FDX 0x2000 /* 10 Mbit full duplex selected */
|
||||
#define MIIM_LXT971_SR2_100HDX 0x4000 /* 100 Mbit half duplex selected */
|
||||
#define MIIM_LXT971_SR2_100FDX 0x8000 /* 100 Mbit full duplex selected */
|
||||
|
||||
#define MIIM_READ_COMMAND 0x00000001
|
||||
|
||||
#define MRBLR_INIT_SETTINGS PKTSIZE_ALIGN
|
||||
|
||||
@ -291,7 +291,7 @@
|
||||
#define TSEC1_PHYIDX 0
|
||||
#define TSEC2_PHYIDX 0
|
||||
|
||||
#undef CONFIG_MPC85XX_FEC
|
||||
#define CONFIG_MPC85XX_FEC 1
|
||||
#define FEC_PHY_ADDR 0
|
||||
#define FEC_PHYIDX 0
|
||||
|
||||
|
||||
@ -140,14 +140,13 @@
|
||||
#define PHYS_SDRAM 0x20000000
|
||||
#define PHYS_SDRAM_SIZE 0x1000000 /* 16 megs */
|
||||
|
||||
#define CFG_MEMTEST_START PHYS_SDRAM
|
||||
#define CFG_MEMTEST_END CFG_MEMTEST_START + PHYS_SDRAM_SIZE - 262144
|
||||
#define CFG_MEMTEST_START PHYS_SDRAM
|
||||
#define CFG_MEMTEST_END CFG_MEMTEST_START + PHYS_SDRAM_SIZE - 262144
|
||||
|
||||
#define CONFIG_DRIVER_ETHER
|
||||
#define CONFIG_NET_RETRY_COUNT 20
|
||||
#define CONFIG_AT91C_USE_RMII
|
||||
|
||||
#define CONFIG_HAS_DATAFLASH 1
|
||||
#define CFG_SPI_WRITE_TOUT (5*CFG_HZ)
|
||||
#define CFG_MAX_DATAFLASH_BANKS 2
|
||||
#define CFG_MAX_DATAFLASH_PAGES 16384
|
||||
@ -206,4 +205,48 @@ struct bd_info_ext {
|
||||
#error CONFIG_USE_IRQ not supported
|
||||
#endif
|
||||
|
||||
#define CFG_DEVICE_NULLDEV 1 /* enble null device */
|
||||
#define CONFIG_SILENT_CONSOLE 1 /* enable silent startup */
|
||||
|
||||
#define CONFIG_AUTOBOOT_KEYED
|
||||
#define CONFIG_AUTOBOOT_PROMPT "autoboot in %d seconds\n"
|
||||
#define CONFIG_AUTOBOOT_STOP_STR "R" /* default password */
|
||||
|
||||
#define CONFIG_VERSION_VARIABLE 1 /* include version env variable */
|
||||
|
||||
#define CONFIG_EXTRA_ENV_SETTINGS \
|
||||
"net_nfs=tftp $(loadaddr) $(bootfile);run nfsargs addip addcons " \
|
||||
"addmtd;bootm\0" \
|
||||
"nfsargs=setenv bootargs root=/dev/nfs rw " \
|
||||
"nfsroot=$(serverip):$(rootpath)\0" \
|
||||
"net_cramfs=tftp $(loadaddr) $(bootfile); run flashargs addip " \
|
||||
"addcons addmtd; bootm\0" \
|
||||
"flash_cramfs=run flashargs addip addcons addmtd; bootm 10030000\0" \
|
||||
"flashargs=setenv bootargs root=/dev/mtdblock3 ro\0" \
|
||||
"addip=setenv bootargs $(bootargs) ethaddr=$(ethaddr) " \
|
||||
"ip=$(ipaddr):$(serverip):$(gatewayip):$(netmask):" \
|
||||
"$(hostname)::off\0" \
|
||||
"addcons=setenv bootargs $(bootargs) console=ttyS0,$(baudrate)\0" \
|
||||
"addmtd=setenv bootargs $(bootargs) mtdparts=cmc_pu2:128k(uboot)ro," \
|
||||
"64k(environment),768k(linux),4096k(root),-\0" \
|
||||
"load=tftp $(loadaddr) $(loadfile)\0" \
|
||||
"update=protect off 10000000 1001ffff;erase 10000000 1001ffff; " \
|
||||
"cp.b $(loadaddr) 10000000 $(filesize);" \
|
||||
"protect on 10000000 1001ffff\0" \
|
||||
"updatel=era 10030000 100effff;tftp $(loadaddr) $(bootfile); " \
|
||||
"cp.b $(loadaddr) 10030000 $(filesize)\0" \
|
||||
"updatec=era 100f0000 104effff;tftp $(loadaddr) $(cramfsimage); " \
|
||||
"cp.b $(loadaddr) 100f0000 $(filesize)\0" \
|
||||
"updatej=era 104f0000 107fffff;tftp $(loadaddr) $(jffsimage); " \
|
||||
"cp.b $(loadaddr) 104f0000 $(filesize)\0" \
|
||||
"cramfsimage=cramfs_cmc-pu2.img\0" \
|
||||
"jffsimage=jffs2_cmc-pu2.img\0" \
|
||||
"loadfile=u-boot_cmc-pu2.bin\0" \
|
||||
"bootfile=uImage_cmc-pu2\0" \
|
||||
"loadaddr=0x20800000\0" \
|
||||
"hostname=CMC-TC-PU2\0" \
|
||||
"bootcmd=run dhcp_start;run flash_cramfs\0" \
|
||||
"autoload=n\0" \
|
||||
"dhcp_start=echo no DHCP\0" \
|
||||
"ipaddr=192.168.0.190\0"
|
||||
#endif /* __CONFIG_H */
|
||||
|
||||
Loading…
Reference in New Issue
Block a user