u-boot/board/seco/common/Makefile

#
# SPDX-License-Identifier:	GPL-2.0+
#

obj-$(CONFIG_TARGET_SECOMX6) += mx6.o
Various Makefiles: Add SPDX-License-Identifier tags After consulting with some of the SPDX team, the conclusion is that Makefiles are worth adding SPDX-License-Identifier tags too, and most of ours have one. This adds tags to ones that lack them and converts a few that had full (or in one case, very partial) license blobs into the equivalent tag. Cc: Kate Stewart <kstewart@linuxfoundation.org> Signed-off-by: Tom Rini <trini@konsulko.com> 2015-11-10 01:06:16 +00:00			`#`
			`# SPDX-License-Identifier: GPL-2.0+`
			`#`
board/seco: Add mx6q-uq7 basic board support Add basic SECO MX6Q/uQ7 board support (Ethernet, UART, SD are supported). It also adds a Kconfig skeleton to later add more SECO board (supporting SoC and board variants). Signed-off-by: Boris Brezillon <boris.brezillon@free-electrons.com> 2015-03-04 12:13:05 +00:00
			`obj-$(CONFIG_TARGET_SECOMX6) += mx6.o`
No results found.