u-boot/configs/ls1043ardb_defconfig

CONFIG_ARM=y
CONFIG_TARGET_LS1043ARDB=y
CONFIG_SYS_EXTRA_OPTIONS="SYS_FSL_DDR4"
CONFIG_SYS_NS16550=y
CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-rdb"
CONFIG_OF_CONTROL=y
armv8/ls1043ardb: Add LS1043ARDB board support LS1043ARDB Specification: ------------------------- Memory subsystem: * 2GByte DDR4 SDRAM (32bit bus) * 128 Mbyte NOR flash single-chip memory * 512 Mbyte NAND flash * 16 Mbyte high-speed SPI flash * SD connector to interface with the SD memory card Ethernet: * XFI 10G port * QSGMII with 4x 1G ports * Two RGMII ports PCIe: * PCIe2 (Lanes C) to mini-PCIe slot * PCIe3 (Lanes D) to PCIe slot USB 3.0: two super speed USB 3.0 type A ports UART: supports two UARTs up to 115200 bps for console Signed-off-by: Hou Zhiqiang <B48286@freescale.com> Signed-off-by: Li Yang <leoli@freescale.com> Signed-off-by: Mingkai Hu <Mingkai.Hu@freescale.com> Signed-off-by: York Sun <yorksun@freescale.com> Signed-off-by: Gong Qianyu <Qianyu.Gong@freescale.com> 2015-10-26 11:47:52 +00:00			`CONFIG_ARM=y`
			`CONFIG_TARGET_LS1043ARDB=y`
common: add CMD_GPIO to Kconfig Add CMD_GPIO to Kconfig and run tools/moveconfig.py . Signed-off-by: Thomas Chou <thomas@wytron.com.tw> Reviewed-by: Simon Glass <sjg@chromium.org> 2015-11-11 13:39:33 +00:00			`CONFIG_SYS_EXTRA_OPTIONS="SYS_FSL_DDR4"`
ns16550: move CONFIG_SYS_NS16550 to Kconfig Move CONFIG_SYS_NS16550 to Kconfig, and run moveconfig.py. Signed-off-by: Thomas Chou <thomas@wytron.com.tw> 2015-11-19 13:48:14 +00:00			`CONFIG_SYS_NS16550=y`
armv8/ls1043ardb: dts: add dtb support Reuse dts files from ls1043a linux kernel. Some parts in dts files may not be needed by U-Boot. Signed-off-by: Gong Qianyu <Qianyu.Gong@freescale.com> Reviewed-by: York Sun <yorksun@freescale.com> 2015-11-11 09:58:36 +00:00			`CONFIG_DEFAULT_DEVICE_TREE="fsl-ls1043a-rdb"`
			`CONFIG_OF_CONTROL=y`