u-boot/configs/cm_fx6_defconfig

123 lines
3.0 KiB
Plaintext
Raw Permalink Normal View History

CONFIG_ARM=y
CONFIG_ARCH_MX6=y
CONFIG_TEXT_BASE=0x17800000
CONFIG_SYS_MALLOC_LEN=0xa00000
CONFIG_SPL_GPIO=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_NR_DRAM_BANKS=2
CONFIG_ENV_SIZE=0x2000
CONFIG_ENV_OFFSET=0xC0000
CONFIG_ENV_SECT_SIZE=0x10000
arm: mx6: Make all i.MX6 SoCs user-selectable We have a number of platforms that are a combination of a carrier board and System-on-Module (SoM) that in turn allows for the board to have different SoCs on it. In some cases, this is handled via board-specific Kconfig options. In other cases we make use of CONFIG_SYS_EXTRA_OPTIONS. This latter case however can lead to invalid configurations as we will not in turn get options that in Kconfig are selected by or depend on that setting. To resolve this, make the SoC option a choice in Kconfig and make boards depend on what they can support. This change opens us up for further clean-ups in the cases where a single CONFIG_TARGET_xxx can support different SoCs and today they do not, or do not cleanly do so. Reported-by: Matt Porter <mporter@konsulko.com> Cc: Stefano Babic <sbabic@denx.de> Cc: Fabio Estevam <festevam@gmail.com> Cc: "NXP i.MX U-Boot Team" <uboot-imx@nxp.com> Cc: Soeren Moch <smoch@web.de> Cc: Markus Niebel <Markus.Niebel@tq-group.com> Cc: Igor Opaniuk <igor.opaniuk@toradex.com> Cc: Heiko Schocher <hs@denx.de> Cc: Hannes Schmelzer <hannes.schmelzer@br-automation.com> Cc: Otavio Salvador <otavio@ossystems.com.br> Cc: Nikita Kiryanov <nikita@compulab.co.il> Cc: Andreas Geisreiter <ageisreiter@dh-electronics.de> Cc: Ludwig Zenz <lzenz@dh-electronics.de> Cc: Lukasz Majewski <lukma@denx.de> Cc: Akshay Bhat <akshaybhat@timesys.com> Cc: Ken Lin <Ken.Lin@advantech.com.tw> Cc: Ian Ray <ian.ray@ge.com> Cc: Tim Harvey <tharvey@gateworks.com> Cc: Jagan Teki <jagan@amarulasolutions.com> Cc: Raffaele RECALCATI <raffaele.recalcati@bticino.it> Cc: Simone CIANNI <simone.cianni@bticino.it> Cc: Adam Ford <aford173@gmail.com> Cc: Marcin Niestroj <m.niestroj@grinn-global.com> Cc: "Eric Bénard" <eric@eukrea.com> Cc: Baruch Siach <baruch@tkos.co.il> Cc: Jason Liu <jason.hui.liu@nxp.com> Cc: Ye Li <ye.li@nxp.com> Cc: Eric Nelson <eric@nelint.com> Cc: Troy Kisky <troy.kisky@boundarydevices.com> Cc: Peng Fan <peng.fan@nxp.com> Cc: Parthiban Nallathambi <parthiban@linumiz.com> Cc: Marek Vasut <marex@denx.de> Cc: "Sébastien Szymanski" <sebastien.szymanski@armadeus.com> Cc: Christian Gmeiner <christian.gmeiner@gmail.com> Cc: Niel Fourie <lusus@denx.de> Cc: Martyn Welch <martyn.welch@collabora.com> Cc: Richard Hu <richard.hu@technexion.com> Cc: Stefan Roese <sr@denx.de> Cc: Boris Brezillon <bbrezillon@kernel.org> Cc: Arkadiusz Karas <arkadiusz.karas@somlabs.com> Cc: Breno Lima <breno.lima@nxp.com> Cc: Francesco Montefoschi <francesco.montefoschi@udoo.org> Cc: Silvio Fricke <open-source@softing.de> Tested-by: Matt Porter <mporter@konsulko.com> [colibri_imx6] Signed-off-by: Tom Rini <trini@konsulko.com> Reviewed-by: Marcin Niestroj <m.niestroj@grinn-global.com>
2020-08-18 11:43:50 +00:00
CONFIG_MX6QDL=y
CONFIG_TARGET_CM_FX6=y
CONFIG_SYS_I2C_MXC_I2C1=y
CONFIG_SYS_I2C_MXC_I2C2=y
CONFIG_SYS_I2C_MXC_I2C3=y
CONFIG_DEFAULT_DEVICE_TREE="imx6q-cm-fx6"
CONFIG_SPL_TEXT_BASE=0x00908000
CONFIG_SYS_PROMPT="CM-FX6 # "
CONFIG_SPL_MMC=y
CONFIG_SPL_SERIAL=y
CONFIG_SPL=y
CONFIG_SPL_SPI_FLASH_SUPPORT=y
CONFIG_SPL_SPI=y
# CONFIG_CMD_BMODE is not set
CONFIG_AHCI=y
CONFIG_DISTRO_DEFAULTS=y
CONFIG_SYS_MONITOR_LEN=409600
CONFIG_OF_BOARD_SETUP=y
CONFIG_BOOTDELAY=3
CONFIG_BOOTCOMMAND="run findfdt; run distro_bootcmd; run legacy_bootcmd"
CONFIG_USE_PREBOOT=y
CONFIG_PREBOOT="usb start;sf probe"
CONFIG_MISC_INIT_R=y
CONFIG_SYS_SPL_MALLOC=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x80
CONFIG_SPL_I2C=y
CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_SPI_U_BOOT_OFFS=0x10000
CONFIG_SPL_WATCHDOG=y
CONFIG_SYS_MAXARGS=32
CONFIG_SYS_PBSIZE=538
# CONFIG_CMD_XIMG is not set
CONFIG_CMD_GREPENV=y
CONFIG_CMD_EEPROM=y
CONFIG_CMD_EEPROM_LAYOUT=y
CONFIG_EEPROM_LAYOUT_HELP_STRING="v2, v3"
CONFIG_SYS_I2C_EEPROM_BUS=2
CONFIG_SYS_EEPROM_PAGE_WRITE_BITS=4
CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS=5
# CONFIG_CMD_FLASH is not set
CONFIG_CMD_GPIO=y
CONFIG_CMD_I2C=y
# CONFIG_CMD_LOADB is not set
# CONFIG_CMD_LOADS is not set
CONFIG_CMD_MMC=y
CONFIG_CMD_SATA=y
CONFIG_CMD_USB=y
# CONFIG_CMD_SETEXPR is not set
CONFIG_SYS_DISABLE_AUTOLOAD=y
CONFIG_CMD_BMP=y
CONFIG_CMD_CACHE=y
CONFIG_CMD_EXT4_WRITE=y
CONFIG_CMD_MTDPARTS=y
CONFIG_MTDIDS_DEFAULT="nor0=spi0.0"
CONFIG_MTDPARTS_DEFAULT="mtdparts=spi0.0:768k(uboot),256k(uboot-environment),-(reserved)"
CONFIG_OF_CONTROL=y
CONFIG_SPL_OF_CONTROL=y
CONFIG_ENV_OVERWRITE=y
CONFIG_ENV_IS_IN_SPI_FLASH=y
CONFIG_SYS_RELOC_GD_ENV_ADDR=y
CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG=y
CONFIG_USE_ETHPRIME=y
CONFIG_ETHPRIME="FEC0"
CONFIG_ARP_TIMEOUT=200
CONFIG_SPL_DM=y
CONFIG_BOUNCE_BUFFER=y
CONFIG_DWC_AHSATA=y
# CONFIG_DWC_AHSATA_AHCI is not set
CONFIG_LBA48=y
CONFIG_SYS_I2C_LEGACY=y
CONFIG_SPL_SYS_I2C_LEGACY=y
CONFIG_SYS_I2C_MXC=y
CONFIG_SYS_MXC_I2C3_SPEED=400000
CONFIG_SYS_I2C_EEPROM_ADDR=0x50
CONFIG_FSL_USDHC=y
CONFIG_MTD=y
CONFIG_MTD_RAW_NAND=y
CONFIG_NAND_MXS=y
CONFIG_SYS_NAND_ONFI_DETECTION=y
CONFIG_DM_SPI_FLASH=y
CONFIG_SF_DEFAULT_SPEED=25000000
CONFIG_SPI_FLASH_ATMEL=y
CONFIG_SPI_FLASH_EON=y
CONFIG_SPI_FLASH_GIGADEVICE=y
CONFIG_SPI_FLASH_MACRONIX=y
CONFIG_SPI_FLASH_SPANSION=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_SST=y
CONFIG_SPI_FLASH_WINBOND=y
CONFIG_SPI_FLASH_MTD=y
CONFIG_PHYLIB=y
CONFIG_PHY_ATHEROS=y
CONFIG_FEC_MXC=y
CONFIG_MII=y
CONFIG_DM_PMIC=y
CONFIG_DM_REGULATOR=y
CONFIG_SPECIFY_CONSOLE_INDEX=y
CONFIG_MXC_UART=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
CONFIG_MXC_SPI=y
CONFIG_USB=y
CONFIG_USB_KEYBOARD=y
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
CONFIG_VIDEO=y
CONFIG_VIDEO_LOGO=y
CONFIG_VIDEO_IPUV3=y
CONFIG_IMX_HDMI=y
CONFIG_SPLASH_SCREEN=y
CONFIG_SPLASH_SOURCE=y
CONFIG_FDT_FIXUP_PARTITIONS=y