forked from Minki/linux
f4ac99011e
By default, the Marvell hardware, for each PCIe interface, exhibits the following devices: * On slot 0, a "Marvell Memory controller", identical on all PCIe interfaces, and which isn't useful when the Marvell SoC is the PCIe root complex (i.e, the normal case when we run Linux on the Marvell SoC). * On slot 1, the real PCIe card connected into the PCIe slot of the board. So, what the Marvell PCIe driver was doing in its PCI-to-PCI bridge emulation is that when the Linux PCI core was trying to access the device in slot 0, we were in fact forwarding the configuration transaction to the device in slot 1. For all other slots, we were telling the Linux PCI core that there was no device connected. However, new versions of bootloaders from Marvell change the default PCIe configuration, and make the real device appear in slot 0, and the "Marvell Memory controller" in slot 1. Therefore, this commit modifies the Marvell PCIe driver to adjust the PCIe hardware configuration to make sure that this behavior (real device in slot 0, "Marvell Memory controller" in slot 1) is the one we'll see regardless of what the bootloader has done. It allows to remove the little hack that was forwarding configuration transactions on slot 0 to slot 1, which is nice. Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com> Acked-by: Bjorn Helgaas <bhelgaas@google.com> Signed-off-by: Jason Cooper <jason@lakedaemon.net> |
||
---|---|---|
.. | ||
host | ||
hotplug | ||
pcie | ||
access.c | ||
ats.c | ||
bus.c | ||
host-bridge.c | ||
hotplug-pci.c | ||
htirq.c | ||
ioapic.c | ||
iov.c | ||
irq.c | ||
Kconfig | ||
Makefile | ||
msi.c | ||
of.c | ||
pci-acpi.c | ||
pci-driver.c | ||
pci-label.c | ||
pci-stub.c | ||
pci-sysfs.c | ||
pci.c | ||
pci.h | ||
probe.c | ||
proc.c | ||
quirks.c | ||
remove.c | ||
rom.c | ||
search.c | ||
setup-bus.c | ||
setup-irq.c | ||
setup-res.c | ||
slot.c | ||
syscall.c | ||
vpd.c | ||
xen-pcifront.c |