linux/drivers/net/wireless/ath/ath10k
Yanbo Li b8d55fca9e ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode
The QCA99X0 4 addresses RX packets pad 2 bytes at the beginning of
MSDU instead the end of ieee80211 header to keep alignment. The currently RX
data path can't parse the header correctly in this case. This patch fixes it
for QCA99X0.

Signed-off-by: Yanbo Li <yanbol@qca.qualcomm.com>
[kvalo@qca.qualcomm.com: checkpatch fixes and naming changes]
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
2015-11-23 17:12:18 +02:00
..
bmi.c
bmi.h ath10k: select board data based on BMI chip id and board id 2015-10-14 08:58:35 +03:00
ce.c ath10k: remove shadow copy of CE descriptors for source ring 2015-10-29 12:59:04 +02:00
ce.h ath10k: remove shadow copy of CE descriptors for source ring 2015-10-29 12:59:04 +02:00
core.c ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode 2015-11-23 17:12:18 +02:00
core.h ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode 2015-11-23 17:12:18 +02:00
debug.c ath10k: debugfs file to enable Bluetooth coexistence feature 2015-11-04 19:37:32 +02:00
debug.h ath10k: make fw stats prints specific to firmware version 2015-10-19 17:42:03 +03:00
debugfs_sta.c ath10k: add support to send delba 2015-01-13 16:13:47 +02:00
hif.h ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htc.c ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htc.h ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htt_rx.c ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode 2015-11-23 17:12:18 +02:00
htt_tx.c ath10k: fix peerid configuration in htt tx desc for htt version < 3.4 2015-11-12 21:19:16 +02:00
htt.c ath10k: enable raw encap mode and software crypto engine 2015-07-29 11:28:24 +03:00
htt.h ath10k: fix peerid configuration in htt tx desc for htt version < 3.4 2015-11-12 21:19:16 +02:00
hw.c ath10k: add cycle/rx_clear counters frequency to hw_params 2015-08-17 16:46:21 +03:00
hw.h ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode 2015-11-23 17:12:18 +02:00
Kconfig ath10k: ATH10K_DEBUGFS depends on DEBUG_FS 2014-09-10 14:17:45 +03:00
mac.c ath10k: fix the wrong RX rate idx report at 11G mode 2015-11-16 21:48:53 +02:00
mac.h ath10k: fix the wrong RX rate idx report at 11G mode 2015-11-16 21:48:53 +02:00
Makefile ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
p2p.c ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
p2p.h ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
pci.c ath10k: add support for pktlog in QCA99X0 2015-11-04 19:36:41 +02:00
pci.h ath10k: disable PCI PS for QCA988X and QCA99X0 2015-10-19 17:38:01 +03:00
rx_desc.h ath10k: add support for qca99x0 Rx descriptors 2015-07-24 10:44:55 +03:00
spectral.c ath10k: add spectral scan support for 10.4 fw 2015-08-26 11:09:12 +03:00
spectral.h ath10k: refactor phyerr event handlers 2015-08-17 17:43:29 +03:00
swap.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
swap.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
targaddrs.h ath10k: add QCA9377 chipset support 2015-10-29 13:02:33 +02:00
testmode_i.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
testmode.c ath10k: add FW API support to test mode 2015-10-29 12:48:01 +02:00
testmode.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
thermal.c ath10k: add thermal throttling support for 10.4 firmware 2015-11-04 19:31:46 +02:00
thermal.h ath10k: configure thermal throttle while powering up 2015-03-23 17:16:37 +02:00
trace.c
trace.h ath10k: add extra check for frame tracing 2015-04-17 09:33:48 +03:00
txrx.c ath10k: use pre-allocated DMA buffer in Tx 2015-10-06 15:04:12 +03:00
txrx.h
wmi-ops.h ath10k: enable adaptive CCA 2015-10-28 21:33:03 +02:00
wmi-tlv.c ath10k: add abstraction layer for peer flags 2015-11-04 19:30:08 +02:00
wmi-tlv.h ath10k: add abstraction layer for peer flags 2015-11-04 19:30:08 +02:00
wmi.c ath10k: fix peer assoc complete WMI command for 10.4 2015-11-12 21:19:13 +02:00
wmi.h ath10k: fix peer assoc complete WMI command for 10.4 2015-11-12 21:19:13 +02:00
wow.c ath10k: fix hw reconfig on wow failure 2015-08-13 14:22:49 +03:00
wow.h ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00