leandrof/linux
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
acd195800f
linux/drivers/net/wireless/ath/ath10k
History
Vasanthakumar Thiagarajan acd195800f ath10k: delay device access after cold reset 
It is observed that during cold reset pcie access right
after a write operation to SOC_GLOBAL_RESET_ADDRESS causes
Data Bus Error and system hard lockup. The reason
for bus error is that pcie needs some time to get
back to stable state for any transaction during cold reset. Add
delay of 20 msecs after write of SOC_GLOBAL_RESET_ADDRESS
to fix this issue. This patch is tested on QCA988X. This is
also tested on QCA99X0 which is WIP.

Signed-off-by: Vasanthakumar Thiagarajan <vthiagar@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
2015-07-24 10:42:14 +03:00
..
bmi.c
bmi.h ath10k: Fix BMI communication timeout for QCA99X0 2015-06-30 15:12:46 +03:00
ce.c ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
ce.h ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
core.c ath10k: configure frag desc memory to target for qca99X0 2015-07-02 08:47:23 +03:00
core.h ath10k: fix hw roc expiration notifcation 2015-07-11 19:06:22 +03:00
debug.c ath10k: print htt op_version upon driver boot 2015-06-16 13:06:47 +03:00
debug.h ath10k: enable pci soc powersaving 2015-05-22 13:39:28 +03:00
debugfs_sta.c
hif.h
htc.c ath10k: replenish htc tx credits always 2015-04-09 14:58:16 +03:00
htc.h
htt_rx.c ath10k: add 10.4 fw specific htt msg definitions 2015-07-02 08:47:18 +03:00
htt_tx.c ath10k: configure frag desc memory to target for qca99X0 2015-07-02 08:47:23 +03:00
htt.c ath10k: configure frag desc memory to target for qca99X0 2015-07-02 08:47:23 +03:00
htt.h ath10k: configure frag desc memory to target for qca99X0 2015-07-02 08:47:23 +03:00
hw.c ath10k: fix QCA61X4 boot up 2015-07-11 19:06:15 +03:00
hw.h ath10k: add 10.4 fw specific htt msg definitions 2015-07-02 08:47:18 +03:00
Kconfig
mac.c Merge ath-next from ath.git. 2015-07-21 11:36:56 +03:00
mac.h ath10k: fix per-vif queue locking 2015-07-11 19:06:26 +03:00
Makefile ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
p2p.c ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
p2p.h ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
pci.c ath10k: delay device access after cold reset 2015-07-24 10:42:14 +03:00
pci.h ath10k: Make target cpu address to CE address conversion chip specific 2015-06-30 15:12:40 +03:00
rx_desc.h ath10k: add hw rate definitions 2015-03-30 15:09:15 +03:00
spectral.c ath10k: increase relay buffer size of spectral scan 2015-05-11 17:50:42 +03:00
spectral.h
swap.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
swap.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
targaddrs.h ath10k: Add hw register/values for QCA99X0 chip 2015-06-30 15:12:37 +03:00
testmode_i.h
testmode.c
testmode.h
thermal.c ath10k: don't call quiet mode if it's not implemented 2015-04-01 20:21:17 +03:00
thermal.h ath10k: configure thermal throttle while powering up 2015-03-23 17:16:37 +02:00
trace.c
trace.h ath10k: add extra check for frame tracing 2015-04-17 09:33:48 +03:00
txrx.c ath10k: txrx: remove unreachable negative return check and fixup type 2015-06-16 13:14:54 +03:00
txrx.h
wmi-ops.h ath10k: implement adaptive qcs command 2015-04-01 20:30:52 +03:00
wmi-tlv.c ath10k: fix per-vif queue locking 2015-07-11 19:06:26 +03:00
wmi-tlv.h ath10k: implement tx pause wmi event 2015-04-01 20:31:08 +03:00
wmi.c ath10k: don't set cck/ofdm scan flags 2015-07-11 19:06:19 +03:00
wmi.h ath10k: set max spatial stream to 4 for 10.4 fw 2015-07-02 08:47:21 +03:00
wow.c ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00
wow.h ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00