forked from Minki/linux
1c7b874d33
The Programmable Multibit ECC (PMECC) controller is a programmable binary BCH(Bose, Chaudhuri and Hocquenghem) encoder and decoder. This controller can be used to support both SLC and MLC NAND Flash devices. It supports to generate ECC to correct 2, 4, 8, 12 or 24 bits of error per sector of data. To use PMECC in this driver, the user needs to set the address and size of PMECC, PMECC error location controllers and ROM. And also needs to pass the correction capability, the sector size and ROM lookup table offsets via dt. This driver has been tested on AT91SAM9X5-EK and AT91SAM9N12-EK with JFFS2, YAFFS2, UBIFS and mtd-utils. Signed-off-by: Hong Xu <hong.xu@atmel.com> Signed-off-by: Josh Wu <josh.wu@atmel.com> Tested-by: Richard Genoud <richard.genoud@gmail.com> Acked-by: Nicolas Ferre <nicolas.ferre@atmel.com> Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com> Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
152 lines
5.5 KiB
C
152 lines
5.5 KiB
C
/*
|
|
* Error Corrected Code Controller (ECC) - System peripherals regsters.
|
|
* Based on AT91SAM9260 datasheet revision B.
|
|
*
|
|
* Copyright (C) 2007 Andrew Victor
|
|
* Copyright (C) 2007 - 2012 Atmel Corporation.
|
|
*
|
|
* This program is free software; you can redistribute it and/or modify it
|
|
* under the terms of the GNU General Public License as published by the
|
|
* Free Software Foundation; either version 2 of the License, or (at your
|
|
* option) any later version.
|
|
*/
|
|
|
|
#ifndef ATMEL_NAND_ECC_H
|
|
#define ATMEL_NAND_ECC_H
|
|
|
|
#define ATMEL_ECC_CR 0x00 /* Control register */
|
|
#define ATMEL_ECC_RST (1 << 0) /* Reset parity */
|
|
|
|
#define ATMEL_ECC_MR 0x04 /* Mode register */
|
|
#define ATMEL_ECC_PAGESIZE (3 << 0) /* Page Size */
|
|
#define ATMEL_ECC_PAGESIZE_528 (0)
|
|
#define ATMEL_ECC_PAGESIZE_1056 (1)
|
|
#define ATMEL_ECC_PAGESIZE_2112 (2)
|
|
#define ATMEL_ECC_PAGESIZE_4224 (3)
|
|
|
|
#define ATMEL_ECC_SR 0x08 /* Status register */
|
|
#define ATMEL_ECC_RECERR (1 << 0) /* Recoverable Error */
|
|
#define ATMEL_ECC_ECCERR (1 << 1) /* ECC Single Bit Error */
|
|
#define ATMEL_ECC_MULERR (1 << 2) /* Multiple Errors */
|
|
|
|
#define ATMEL_ECC_PR 0x0c /* Parity register */
|
|
#define ATMEL_ECC_BITADDR (0xf << 0) /* Bit Error Address */
|
|
#define ATMEL_ECC_WORDADDR (0xfff << 4) /* Word Error Address */
|
|
|
|
#define ATMEL_ECC_NPR 0x10 /* NParity register */
|
|
#define ATMEL_ECC_NPARITY (0xffff << 0) /* NParity */
|
|
|
|
/* PMECC Register Definitions */
|
|
#define ATMEL_PMECC_CFG 0x000 /* Configuration Register */
|
|
#define PMECC_CFG_BCH_ERR2 (0 << 0)
|
|
#define PMECC_CFG_BCH_ERR4 (1 << 0)
|
|
#define PMECC_CFG_BCH_ERR8 (2 << 0)
|
|
#define PMECC_CFG_BCH_ERR12 (3 << 0)
|
|
#define PMECC_CFG_BCH_ERR24 (4 << 0)
|
|
|
|
#define PMECC_CFG_SECTOR512 (0 << 4)
|
|
#define PMECC_CFG_SECTOR1024 (1 << 4)
|
|
|
|
#define PMECC_CFG_PAGE_1SECTOR (0 << 8)
|
|
#define PMECC_CFG_PAGE_2SECTORS (1 << 8)
|
|
#define PMECC_CFG_PAGE_4SECTORS (2 << 8)
|
|
#define PMECC_CFG_PAGE_8SECTORS (3 << 8)
|
|
|
|
#define PMECC_CFG_READ_OP (0 << 12)
|
|
#define PMECC_CFG_WRITE_OP (1 << 12)
|
|
|
|
#define PMECC_CFG_SPARE_ENABLE (1 << 16)
|
|
#define PMECC_CFG_SPARE_DISABLE (0 << 16)
|
|
|
|
#define PMECC_CFG_AUTO_ENABLE (1 << 20)
|
|
#define PMECC_CFG_AUTO_DISABLE (0 << 20)
|
|
|
|
#define ATMEL_PMECC_SAREA 0x004 /* Spare area size */
|
|
#define ATMEL_PMECC_SADDR 0x008 /* PMECC starting address */
|
|
#define ATMEL_PMECC_EADDR 0x00c /* PMECC ending address */
|
|
#define ATMEL_PMECC_CLK 0x010 /* PMECC clock control */
|
|
#define PMECC_CLK_133MHZ (2 << 0)
|
|
|
|
#define ATMEL_PMECC_CTRL 0x014 /* PMECC control register */
|
|
#define PMECC_CTRL_RST (1 << 0)
|
|
#define PMECC_CTRL_DATA (1 << 1)
|
|
#define PMECC_CTRL_USER (1 << 2)
|
|
#define PMECC_CTRL_ENABLE (1 << 4)
|
|
#define PMECC_CTRL_DISABLE (1 << 5)
|
|
|
|
#define ATMEL_PMECC_SR 0x018 /* PMECC status register */
|
|
#define PMECC_SR_BUSY (1 << 0)
|
|
#define PMECC_SR_ENABLE (1 << 4)
|
|
|
|
#define ATMEL_PMECC_IER 0x01c /* PMECC interrupt enable */
|
|
#define PMECC_IER_ENABLE (1 << 0)
|
|
#define ATMEL_PMECC_IDR 0x020 /* PMECC interrupt disable */
|
|
#define PMECC_IER_DISABLE (1 << 0)
|
|
#define ATMEL_PMECC_IMR 0x024 /* PMECC interrupt mask */
|
|
#define PMECC_IER_MASK (1 << 0)
|
|
#define ATMEL_PMECC_ISR 0x028 /* PMECC interrupt status */
|
|
#define ATMEL_PMECC_ECCx 0x040 /* PMECC ECC x */
|
|
#define ATMEL_PMECC_REMx 0x240 /* PMECC REM x */
|
|
|
|
/* PMERRLOC Register Definitions */
|
|
#define ATMEL_PMERRLOC_ELCFG 0x000 /* Error location config */
|
|
#define PMERRLOC_ELCFG_SECTOR_512 (0 << 0)
|
|
#define PMERRLOC_ELCFG_SECTOR_1024 (1 << 0)
|
|
#define PMERRLOC_ELCFG_NUM_ERRORS(n) ((n) << 16)
|
|
|
|
#define ATMEL_PMERRLOC_ELPRIM 0x004 /* Error location primitive */
|
|
#define ATMEL_PMERRLOC_ELEN 0x008 /* Error location enable */
|
|
#define ATMEL_PMERRLOC_ELDIS 0x00c /* Error location disable */
|
|
#define PMERRLOC_DISABLE (1 << 0)
|
|
|
|
#define ATMEL_PMERRLOC_ELSR 0x010 /* Error location status */
|
|
#define PMERRLOC_ELSR_BUSY (1 << 0)
|
|
#define ATMEL_PMERRLOC_ELIER 0x014 /* Error location int enable */
|
|
#define ATMEL_PMERRLOC_ELIDR 0x018 /* Error location int disable */
|
|
#define ATMEL_PMERRLOC_ELIMR 0x01c /* Error location int mask */
|
|
#define ATMEL_PMERRLOC_ELISR 0x020 /* Error location int status */
|
|
#define PMERRLOC_ERR_NUM_MASK (0x1f << 8)
|
|
#define PMERRLOC_CALC_DONE (1 << 0)
|
|
#define ATMEL_PMERRLOC_SIGMAx 0x028 /* Error location SIGMA x */
|
|
#define ATMEL_PMERRLOC_ELx 0x08c /* Error location x */
|
|
|
|
/* Register access macros for PMECC */
|
|
#define pmecc_readl_relaxed(addr, reg) \
|
|
readl_relaxed((addr) + ATMEL_PMECC_##reg)
|
|
|
|
#define pmecc_writel(addr, reg, value) \
|
|
writel((value), (addr) + ATMEL_PMECC_##reg)
|
|
|
|
#define pmecc_readb_ecc_relaxed(addr, sector, n) \
|
|
readb_relaxed((addr) + ATMEL_PMECC_ECCx + ((sector) * 0x40) + (n))
|
|
|
|
#define pmecc_readl_rem_relaxed(addr, sector, n) \
|
|
readl_relaxed((addr) + ATMEL_PMECC_REMx + ((sector) * 0x40) + ((n) * 4))
|
|
|
|
#define pmerrloc_readl_relaxed(addr, reg) \
|
|
readl_relaxed((addr) + ATMEL_PMERRLOC_##reg)
|
|
|
|
#define pmerrloc_writel(addr, reg, value) \
|
|
writel((value), (addr) + ATMEL_PMERRLOC_##reg)
|
|
|
|
#define pmerrloc_writel_sigma_relaxed(addr, n, value) \
|
|
writel_relaxed((value), (addr) + ATMEL_PMERRLOC_SIGMAx + ((n) * 4))
|
|
|
|
#define pmerrloc_readl_sigma_relaxed(addr, n) \
|
|
readl_relaxed((addr) + ATMEL_PMERRLOC_SIGMAx + ((n) * 4))
|
|
|
|
#define pmerrloc_readl_el_relaxed(addr, n) \
|
|
readl_relaxed((addr) + ATMEL_PMERRLOC_ELx + ((n) * 4))
|
|
|
|
/* Galois field dimension */
|
|
#define PMECC_GF_DIMENSION_13 13
|
|
#define PMECC_GF_DIMENSION_14 14
|
|
|
|
#define PMECC_LOOKUP_TABLE_SIZE_512 0x2000
|
|
#define PMECC_LOOKUP_TABLE_SIZE_1024 0x4000
|
|
|
|
/* Time out value for reading PMECC status register */
|
|
#define PMECC_MAX_TIMEOUT_MS 100
|
|
|
|
#endif
|