forked from Minki/linux
2ad2af0816
I noticed that phy_pm_runtime_get_sync() and phy_pm_runtime_put() are not currently doing anything for phy-mapphone-mdm6600, only the sysfs interface for works for "auto" and "on". This is because of the shared GPIO pins between mdm6600 USB port and n_gsm port. We have not enabled runtime PM for the phy driver until after we've booted up mdm6600 properly to the USB mode. Otherwise phy_create() would have called pm_runtime_enable() and pm_runtime_no_callbacks() automatically on init. Let's fix this by registering the phy a bit later after we've powered up the mdm6600 USB port. And as the PM runtime support is only needed for the n_gsm mode and not for USB, we can allow the device to idle between phy_mdm6600_power_on() and phy_mdm6600_power_off(). Note that for suspend, runtime_pm is already disabled for the phy so we need to check for pm_runtime_enabled(). Cc: Johan Hovold <jhovold@gmail.com> Cc: Pavel Machek <pavel@ucw.cz> Cc: Sebastian Reichel <sre@kernel.org> Signed-off-by: Tony Lindgren <tony@atomide.com> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| phy-cpcap-usb.c | ||
| phy-mapphone-mdm6600.c | ||