forked from Minki/linux
1ef535c6ba
Add support for the XUSB pad controller found on Tegra194 SoCs. It is mostly similar to the same IP found on Tegra186, but the number of pads exposed differs, as do the programming sequences. Because most of the Tegra194 XUSB PADCTL registers definition and programming sequence are the same as Tegra186, Tegra194 XUSB PADCTL can share the same driver, xusb-tegra186.c, with Tegra186 XUSB PADCTL. Tegra194 XUSB PADCTL supports up to USB 3.1 Gen 2 speed, however, it is possible for some platforms have long signal trace that could not provide sufficient electrical environment for Gen 2 speed. This patch adds a "maximum-speed" property to usb3 ports which can be used to specify the maximum supported speed for any particular USB 3.1 port. For a port that is not capable of SuperSpeedPlus, "maximum-speed" property should carry "super-speed". Signed-off-by: JC Kuo <jckuo@nvidia.com> Acked-by: Thierry Reding <treding@nvidia.com> Signed-off-by: Thierry Reding <treding@nvidia.com>
11 lines
485 B
Makefile
11 lines
485 B
Makefile
# SPDX-License-Identifier: GPL-2.0-only
|
|
obj-$(CONFIG_PHY_TEGRA_XUSB) += phy-tegra-xusb.o
|
|
|
|
phy-tegra-xusb-y += xusb.o
|
|
phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_124_SOC) += xusb-tegra124.o
|
|
phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_132_SOC) += xusb-tegra124.o
|
|
phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_210_SOC) += xusb-tegra210.o
|
|
phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_186_SOC) += xusb-tegra186.o
|
|
phy-tegra-xusb-$(CONFIG_ARCH_TEGRA_194_SOC) += xusb-tegra186.o
|
|
obj-$(CONFIG_PHY_TEGRA194_P2U) += phy-tegra194-p2u.o
|