linux/drivers/net/wireless/ath/ath10k
Michal Kazior 6d2d51ecff ath10k: wake up queue upon vif creation
Vif's vdev_id is used as queue number. However due
to the tx pausing design in ath10k it was possible
for a new interface to be created with its tx
queue stopped (via ieee80211_stop_queues). This
could in turn leave the interface inoperable until
ath10k_mac_tx_unlock() was called.

This problem only affected multi-vif scenarios when
new interfaces were created some time later after
other interfaces have been running for some time
and had Tx queue full at some point prior.

Possible manifestation of the bug was
authentication timeout for a client vif.

Fixes: 96d828d45e ("ath10k: rework tx queue locking")
Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
2015-08-17 16:40:25 +03:00
..
bmi.c ath10k: improve logging to include dev id 2014-08-26 19:04:48 +03:00
bmi.h ath10k: Fix BMI communication timeout for QCA99X0 2015-06-30 15:12:46 +03:00
ce.c ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
ce.h ath10k: Extend CE src desc flags for interrupt indication 2015-06-30 15:12:44 +03:00
core.c ath10k: fix memory alloc failure in qca99x0 during wmi svc rdy event 2015-07-30 16:54:28 +03:00
core.h ath10k: fix memory alloc failure in qca99x0 during wmi svc rdy event 2015-07-30 16:54:28 +03:00
debug.c ath10k: initialize fw_features var 2015-08-13 14:22:07 +03:00
debug.h ath10k: enable pci soc powersaving 2015-05-22 13:39:28 +03:00
debugfs_sta.c ath10k: add support to send delba 2015-01-13 16:13:47 +02:00
hif.h ath10k: remove transfer_id from ath10k_hif_cb::tx_completion 2014-12-01 09:13:36 +02:00
htc.c ath10k: replenish htc tx credits always 2015-04-09 14:58:16 +03:00
htc.h ath10k: fix use of multiple blank lines 2014-09-18 10:45:20 +03:00
htt_rx.c ath10k: enable raw encap mode and software crypto engine 2015-07-29 11:28:24 +03:00
htt_tx.c ath10k: initialize msdu ext. descriptor before use 2015-07-30 17:05:29 +03:00
htt.c ath10k: enable raw encap mode and software crypto engine 2015-07-29 11:28:24 +03:00
htt.h ath10k: enable raw encap mode and software crypto engine 2015-07-29 11:28:24 +03:00
hw.c ath10k: fix QCA61X4 boot up 2015-07-11 19:06:15 +03:00
hw.h ath10k: increase max client to 512 in qca99x0 2015-07-30 16:54:57 +03:00
Kconfig ath10k: ATH10K_DEBUGFS depends on DEBUG_FS 2014-09-10 14:17:45 +03:00
mac.c ath10k: wake up queue upon vif creation 2015-08-17 16:40:25 +03:00
mac.h ath10k: fix per-vif queue locking 2015-07-11 19:06:26 +03:00
Makefile ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
p2p.c ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
p2p.h ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
pci.c ath10k: add QCA99X0 to supported device list 2015-07-30 17:04:00 +03:00
pci.h ath10k: Make target cpu address to CE address conversion chip specific 2015-06-30 15:12:40 +03:00
rx_desc.h ath10k: add support for qca99x0 Rx descriptors 2015-07-24 10:44:55 +03:00
spectral.c ath10k: increase relay buffer size of spectral scan 2015-05-11 17:50:42 +03:00
spectral.h ath10k: clean up phyerr code 2014-09-23 12:31:54 +03:00
swap.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
swap.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
targaddrs.h ath10k: Add hw register/values for QCA99X0 chip 2015-06-30 15:12:37 +03:00
testmode_i.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
testmode.c ath10k: introduce wmi ops 2014-12-08 17:39:08 +02:00
testmode.h ath10k: add testmode 2014-09-11 23:42:36 +03:00
thermal.c ath10k: don't call quiet mode if it's not implemented 2015-04-01 20:21:17 +03:00
thermal.h ath10k: configure thermal throttle while powering up 2015-03-23 17:16:37 +02:00
trace.c
trace.h ath10k: add extra check for frame tracing 2015-04-17 09:33:48 +03:00
txrx.c ath10k: Improve performance by reducing tx_lock contention 2015-07-29 11:27:24 +03:00
txrx.h ath10k: fix Rx aggregation reordering 2014-07-25 11:15:39 +03:00
wmi-ops.h ath10k: Support different txbf configuration schemes 2015-08-13 14:21:10 +03:00
wmi-tlv.c ath10k: Support different txbf configuration schemes 2015-08-13 14:21:10 +03:00
wmi-tlv.h ath10k: implement tx pause wmi event 2015-04-01 20:31:08 +03:00
wmi.c ath10k: Support different txbf configuration schemes 2015-08-13 14:21:10 +03:00
wmi.h ath10k: Enable MU MIMO txbf support for QCA99X0 2015-08-13 14:21:18 +03:00
wow.c ath10k: fix hw reconfig on wow failure 2015-08-13 14:22:49 +03:00
wow.h ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00