forked from Minki/linux
48969a5623
Some Android x86 tablets with a Bay Trail (BYT) SoC and a Crystal Cove PMIC, which does not support charger-detection, rely on a TUSB1211 phy for charger-detection. Add support for charger detection on TUSB1211 phy-s and export the information about the detected charger through the standard power_supply class interface. power_supply class charger IC drivers like the bq24190_charger.c driver will then pick this up and set their input_current_limit based on this. Note the "linux,phy_charger_detect" property used to enable this is a special kernel-internal (so not part of the dt-bindings) property used by dwc3 platform code to indicate that the phy needs to do charger-detection. Changes by Hans de Goede: - Use "linux,phy_charger_detect" property to enable charger-detect - Switch from a linear flow to a state-machine, with retries on ulpi communication errors - Use SW_CONTROL bit to disable the FSM when detection is finished - Do a phy-reset on disconnect to work around the phy often refusing ulpi_read()/_write() commands after a disconnect - Use power_supply_reg_notifier() for Vbus monitoring - Export the detection result through a power_supply class device Signed-off-by: Stephan Gerhold <stephan@gerhold.net> Co-developed-by: Hans de Goede <hdegoede@redhat.com> Signed-off-by: Hans de Goede <hdegoede@redhat.com> Link: https://lore.kernel.org/r/20220213130524.18748-10-hdegoede@redhat.com Signed-off-by: Vinod Koul <vkoul@kernel.org> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| Makefile | ||
| phy-am654-serdes.c | ||
| phy-da8xx-usb.c | ||
| phy-dm816x-usb.c | ||
| phy-gmii-sel.c | ||
| phy-j721e-wiz.c | ||
| phy-omap-control.c | ||
| phy-omap-usb2.c | ||
| phy-ti-pipe3.c | ||
| phy-tusb1210.c | ||
| phy-twl4030-usb.c | ||