forked from Minki/linux
57e104864b
This patch add a new quirk to add a s/w timer to notify the driver to terminate current transfer and report a data timeout to the core, if DTO interrupt does NOT come within the given time. dw_mmc call mmc_request_done func to finish transfer depends on DTO interrupt. If DTO interrupt does not come in sending data state, the current transfer will be blocked. We got the reply from synopsys: There are two counters but both use the same value of [31:8] bits. Data timeout counter doesn't wait for stop clock and you should get DRTO even when the clock is not stopped. Host Starvation timeout counter is triggered with stop clock condition. This means that host should get DRTO and DTO interrupt. But this case really exists, when driver reads tuning data from card on RK3288-pink2 board. I measured waveforms by oscilloscope and found that card clock was always on and data lines were always holded high level in sending data state. There are two possibility that data over interrupt doesn't come in reading data state on RK3X SoCs: - get command done interrupt, but doesn't get any data-related interrupt. - get data error interrupt, but doesn't get data over interrupt. Signed-off-by: Addy Ke <addy.ke@rock-chips.com> Signed-off-by: Heiko Stuebner <heiko@sntech.de> Signed-off-by: Jaehoon Chung <jh80.chung@samsung.com> |
||
|---|---|---|
| .. | ||
| card | ||
| core | ||
| host | ||
| Kconfig | ||
| Makefile | ||