forked from Minki/linux
5757aca101
The vbus-present bit in the power status register also gets set to 1 when a usb-host cable (id-pin shorted to ground) is plugged in and a 5v boost converter is supplying 5v to the otg usb bus. This causes a "disconnect or unknown or ID event" warning in dmesg as well as the extcon device to report the last detected charger cable type as being connected even though none is connected. This commit switches to checking the vbus-valid bit instead, which is only 1 when both vbus is present and the vbus-path is enabled in the vbus-path control register (the vbus-path gets disabled when a usb-host cable is detected, to avoid the pmic drawing power from the 5v boost converter). Signed-off-by: Hans de Goede <hdegoede@redhat.com> Acked-by: Chanwoo Choi <cw00.choi@samsung.com> Signed-off-by: Chanwoo Choi <cw00.choi@samsung.com> |
||
|---|---|---|
| .. | ||
| devres.c | ||
| extcon-adc-jack.c | ||
| extcon-arizona.c | ||
| extcon-axp288.c | ||
| extcon-gpio.c | ||
| extcon-max3355.c | ||
| extcon-max8997.c | ||
| extcon-max14577.c | ||
| extcon-max77693.c | ||
| extcon-max77843.c | ||
| extcon-palmas.c | ||
| extcon-qcom-spmi-misc.c | ||
| extcon-rt8973a.c | ||
| extcon-rt8973a.h | ||
| extcon-sm5502.c | ||
| extcon-sm5502.h | ||
| extcon-usb-gpio.c | ||
| extcon.c | ||
| Kconfig | ||
| Makefile | ||