forked from Minki/linux
4d7cb45ee8
As part of Common Clk Framework (CCF) the clk_enable() operation was split into a clk_prepare() which could sleep, and a clk_enable() which should never sleep. Similarly the clk_disable() was split into clk_disable() and clk_unprepare(). This was needed to handle complex cases where in a clk gate/ungate would require a slow and a fast part to be implemented. None of the clocks below seem to be in the 'complex' clocks category and are just simple clocks which are enabled/disabled through simple register writes. Most of the instances also seem to be called in non-atomic context which means its safe to move all of those from using a clk_enable() to clk_prepare_enable() and clk_disable() to clk_disable_unprepare(). For some others, mainly the ones handled through the hwmod framework there is a possibility that they get called in either an atomic or a non-atomic context. The way these get handled below work only as long as clk_prepare is implemented as a no-op (which is the case today) since this gets called very early at boot while most subsystems are unavailable. Hence these are marked with a *HACK* comment, which says we need to re-visit these once we start doing something meaningful with clk_prepare/clk_unprepare like doing voltage scaling or something that involves i2c. This is in preparation of OMAP moving to CCF. Based on initial changes from Mike Turquette. Signed-off-by: Rajendra Nayak <rnayak@ti.com> Signed-off-by: Paul Walmsley <paul@pwsan.com> |
||
|---|---|---|
| .. | ||
| alpha | ||
| arm | ||
| avr32 | ||
| blackfin | ||
| c6x | ||
| cris | ||
| frv | ||
| h8300 | ||
| hexagon | ||
| ia64 | ||
| m32r | ||
| m68k | ||
| microblaze | ||
| mips | ||
| mn10300 | ||
| openrisc | ||
| parisc | ||
| powerpc | ||
| s390 | ||
| score | ||
| sh | ||
| sparc | ||
| tile | ||
| um | ||
| unicore32 | ||
| x86 | ||
| xtensa | ||
| .gitignore | ||
| Kconfig | ||