leandrof/linux
1
0
Fork 0
Code Issues Pull Requests Packages Projects Releases Wiki Activity
23f591ea9b
linux/drivers/net/wireless/ath/ath10k
History
Kalle Valo 23f591ea9b ath10k: split driver info messages during device initialisation 
Earlier we printed all the info messages after a successful device
initialisation and firmware boot, but that's problematic if something goes
wrong and there's no easy way to know what firmware version was used and so on.

Split the info messages into smaller pieces and print them as soon as we have
the info available.

Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
2015-11-30 16:54:58 +02:00
..
bmi.c
bmi.h ath10k: select board data based on BMI chip id and board id 2015-10-14 08:58:35 +03:00
ce.c ath10k: remove shadow copy of CE descriptors for source ring 2015-10-29 12:59:04 +02:00
ce.h ath10k: remove shadow copy of CE descriptors for source ring 2015-10-29 12:59:04 +02:00
core.c ath10k: split driver info messages during device initialisation 2015-11-30 16:54:58 +02:00
core.h ath10k: store msdu_id instead of txbuf pointers 2015-11-23 17:12:32 +02:00
debug.c ath10k: split driver info messages during device initialisation 2015-11-30 16:54:58 +02:00
debug.h ath10k: split driver info messages during device initialisation 2015-11-30 16:54:58 +02:00
debugfs_sta.c ath10k: add support to send delba 2015-01-13 16:13:47 +02:00
hif.h ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htc.c ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htc.h ath10k: remove htc polling for tx completion 2015-10-16 15:49:41 +03:00
htt_rx.c ath10k: stop abusing GFP_DMA 2015-11-30 16:54:45 +02:00
htt_tx.c ath10k: stop abusing GFP_DMA 2015-11-30 16:54:45 +02:00
htt.c ath10k: enable raw encap mode and software crypto engine 2015-07-29 11:28:24 +03:00
htt.h ath10k: remove txmode from skb_cb 2015-11-23 17:12:22 +02:00
hw.c ath10k: add cycle/rx_clear counters frequency to hw_params 2015-08-17 16:46:21 +03:00
hw.h ath10k: adjust the RX packet pad offset at QCA99X0 4addr mode 2015-11-23 17:12:18 +02:00
Kconfig
mac.c ath10k: apply Mesh subtype when Mesh interface created. 2015-11-30 16:54:51 +02:00
mac.h ath10k: fix the wrong RX rate idx report at 11G mode 2015-11-16 21:48:53 +02:00
Makefile ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
p2p.c ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
p2p.h ath10k: implement handling of p2p noa event 2015-03-07 09:57:42 +02:00
pci.c ath10k: add support for pktlog in QCA99X0 2015-11-04 19:36:41 +02:00
pci.h ath10k: disable PCI PS for QCA988X and QCA99X0 2015-10-19 17:38:01 +03:00
rx_desc.h ath10k: add support for qca99x0 Rx descriptors 2015-07-24 10:44:55 +03:00
spectral.c ath10k: add spectral scan support for 10.4 fw 2015-08-26 11:09:12 +03:00
spectral.h ath10k: refactor phyerr event handlers 2015-08-17 17:43:29 +03:00
swap.c ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
swap.h ath10k: Add support for code swap 2015-06-30 15:12:47 +03:00
targaddrs.h ath10k: add QCA9377 chipset support 2015-10-29 13:02:33 +02:00
testmode_i.h
testmode.c ath10k: add FW API support to test mode 2015-10-29 12:48:01 +02:00
testmode.h
thermal.c ath10k: add thermal throttling support for 10.4 firmware 2015-11-04 19:31:46 +02:00
thermal.h ath10k: configure thermal throttle while powering up 2015-03-23 17:16:37 +02:00
trace.c
trace.h ath10k: add extra check for frame tracing 2015-04-17 09:33:48 +03:00
txrx.c ath10k: fix tx header parsing 2015-11-23 17:12:29 +02:00
txrx.h
wmi-ops.h ath10k: enable adaptive CCA 2015-10-28 21:33:03 +02:00
wmi-tlv.c ath10k: add abstraction layer for peer flags 2015-11-04 19:30:08 +02:00
wmi-tlv.h ath10k: add abstraction layer for peer flags 2015-11-04 19:30:08 +02:00
wmi.c ath10k: replace vdev_id and tid in skb cb 2015-11-23 17:12:30 +02:00
wmi.h ath10k: introduce new subtypes for proxy STA and Mesh 2015-11-30 16:54:50 +02:00
wow.c ath10k: fix hw reconfig on wow failure 2015-08-13 14:22:49 +03:00
wow.h ath10k: add WOW patterns support 2015-03-30 09:10:24 +03:00