linux/drivers/net/phy
Antoine Tenart 1bbe0ecc2a net: phy: mscc: macsec initialization
This patch adds support for initializing the MACsec engine found within
some Microsemi PHYs. The engine is initialized in a passthrough mode and
does not modify any incoming or outgoing packet. But thanks to this it
now can be configured to perform MACsec transformations on packets,
which will be supported by a future patch.

The MACsec read and write functions are wrapped into two versions: one
called during the init phase, and the other one later on. This is
because the init functions in the Microsemi PHY driver are called while
the MDIO bus lock is taken.

Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
2020-01-14 11:31:41 -08:00
..
adin.c net: phy: adin: implement Energy Detect Powerdown mode via phy-tunable 2019-09-16 22:02:45 +02:00
amd.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
aquantia_hwmon.c net: phy: aquantia: add hwmon support 2019-02-25 14:16:22 -08:00
aquantia_main.c net: switch to using PHY_INTERFACE_MODE_10GBASER rather than 10GKR 2020-01-05 15:05:35 -08:00
aquantia.h net: phy: Use the correct style for SPDX License Identifier 2019-11-27 11:25:48 -08:00
at803x.c net: phy: at803x: remove config_init for AR9331 2019-11-06 21:42:06 -08:00
ax88796b.c net: phy: rename Asix Electronics PHY driver 2019-06-09 13:24:17 -07:00
bcm7xxx.c net: phy: bcm7xxx: define soft_reset for 40nm EPHY 2019-10-18 10:00:07 -07:00
bcm63xx.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
bcm87xx.c net: phy: bcm87xx: improve bcm87xx_config_init and feature detection 2019-05-26 21:56:41 -07:00
bcm84881.c net: switch to using PHY_INTERFACE_MODE_10GBASER rather than 10GKR 2020-01-05 15:05:35 -08:00
bcm-cygnus.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
bcm-phy-lib.c net: phy: Prepare for moving Omega out of bcm7xxx 2019-03-21 13:41:26 -07:00
bcm-phy-lib.h net: phy: Use the correct style for SPDX License Identifier 2019-11-27 11:25:48 -08:00
broadcom.c net: phy: broadcom: add 1000Base-X support for BCM54616S 2019-10-23 20:42:52 -07:00
cicada.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
cortina.c net: phy: remove gen10g_no_soft_reset 2019-03-03 21:47:57 -08:00
davicom.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
dp83tc811.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
dp83640_reg.h
dp83640.c net: Introduce a new MII time stamping interface. 2019-12-25 19:51:33 -08:00
dp83822.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
dp83848.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
dp83867.c net: phy: dp83867: Add rx-fifo-depth and tx-fifo-depth 2019-12-09 20:19:10 -08:00
dp83869.c net: phy: dp83869: Remove unneeded semicolon 2019-12-14 16:11:40 -08:00
et1011c.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
fixed_phy.c net: phy: fixed_phy: switch to using fwnode_gpiod_get_index 2020-01-05 14:27:01 -08:00
icplus.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
intel-xway.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
Kconfig net: phy: add Broadcom BCM84881 PHY driver 2019-12-11 11:53:42 -08:00
lxt.c net: phy: provide and use genphy_read_status_fixed() 2019-12-19 12:52:34 -08:00
Makefile net: Add a layer for non-PHY MII time stamping drivers. 2019-12-25 19:51:33 -08:00
marvell10g.c net: switch to using PHY_INTERFACE_MODE_10GBASER rather than 10GKR 2020-01-05 15:05:35 -08:00
marvell.c net: phy: marvell: use genphy_check_and_restart_aneg() 2019-12-19 12:52:34 -08:00
mdio_bus.c mdio_bus: Simplify reset handling and extend to non-DT systems 2020-01-14 11:03:10 -08:00
mdio_device.c net: phy: allow for reset line to be tied to a sleepy GPIO controller 2019-10-04 18:07:45 -07:00
mdio-aspeed.c net: phy: Add mdio-aspeed 2019-08-02 17:56:28 -07:00
mdio-bcm-iproc.c phy: mdio-bcm-iproc: use devm_platform_ioremap_resource() to simplify code 2019-08-28 14:51:00 -07:00
mdio-bcm-unimac.c net: phy: mdio-bcm-unimac: remove redundant !timeout check 2019-03-27 14:27:30 -07:00
mdio-bitbang.c
mdio-boardinfo.c
mdio-boardinfo.h
mdio-cavium.c
mdio-cavium.h net: phy: Use the correct style for SPDX License Identifier 2019-11-27 11:25:48 -08:00
mdio-gpio.c
mdio-hisi-femac.c phy: mdio-hisi-femac: use devm_platform_ioremap_resource() to simplify code 2019-08-28 14:51:00 -07:00
mdio-i2c.c net: mdio-i2c: add support for Clause 45 accesses 2019-12-11 11:53:41 -08:00
mdio-i2c.h net: phy: Use the correct style for SPDX License Identifier 2019-11-27 11:25:48 -08:00
mdio-moxart.c phy: mdio-moxart: use devm_platform_ioremap_resource() to simplify code 2019-08-28 14:51:00 -07:00
mdio-mscc-miim.c
mdio-mux-bcm-iproc.c
mdio-mux-gpio.c
mdio-mux-meson-g12a.c phy: mdio-mux-meson-g12a: use devm_platform_ioremap_resource() to simplify code 2019-08-28 14:51:00 -07:00
mdio-mux-mmioreg.c
mdio-mux-multiplexer.c drivers: net: phy: mdio-mux: Add support for Generic Mux controls 2019-02-27 12:52:20 -08:00
mdio-mux.c
mdio-octeon.c
mdio-sun4i.c phy: mdio-sun4i: add missed regulator_disable in remove 2019-11-18 17:22:40 -08:00
mdio-thunder.c phy: mdio-thunder: add missed pci_release_regions in remove 2019-12-06 12:05:06 -08:00
mdio-xgene.c net: phy: xgene: use devm_platform_ioremap_resource() to simplify code 2019-08-01 13:10:34 -04:00
mdio-xgene.h net: phy: Use the correct style for SPDX License Identifier 2019-11-27 11:25:48 -08:00
meson-gxl.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
micrel.c net: phy: micrel: Update KSZ87xx PHY name 2019-10-17 16:31:52 -07:00
microchip_t1.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
microchip.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
mii_timestamper.c net: Add a layer for non-PHY MII time stamping drivers. 2019-12-25 19:51:33 -08:00
mscc_fc_buffer.h net: phy: mscc: macsec initialization 2020-01-14 11:31:41 -08:00
mscc_mac.h net: phy: mscc: macsec initialization 2020-01-14 11:31:41 -08:00
mscc_macsec.h net: phy: mscc: macsec initialization 2020-01-14 11:31:41 -08:00
mscc.c net: phy: mscc: macsec initialization 2020-01-14 11:31:41 -08:00
national.c net/phy: fix DP83865 10 Mbps HDX loopback disable function 2019-09-21 18:21:52 -07:00
nxp-tja11xx.c net: phy: tja11xx: Switch to HWMON_CHANNEL_INFO() 2019-05-29 22:02:18 -07:00
phy_device.c net: phy: Added IRQ print to phylink_bringup_phy() 2020-01-14 10:56:58 -08:00
phy_led_triggers.c net: phy: phy_led_triggers: Fix a possible null-pointer dereference in phy_led_trigger_change_speed() 2019-07-31 18:56:11 -04:00
phy-c45.c net: phy: Fix "link partner" information disappear issue 2019-10-16 13:17:01 -07:00
phy-core.c net: phy: add helpers phy_(un)lock_mdio_bus 2019-11-25 10:47:00 -08:00
phy.c net: Introduce a new MII time stamping interface. 2019-12-25 19:51:33 -08:00
phylink.c net: phy: Added IRQ print to phylink_bringup_phy() 2020-01-14 10:56:58 -08:00
qsemi.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
realtek.c net: phy: realtek: add support for configuring the RX delay on RTL8211F 2019-12-26 13:22:17 -08:00
rockchip.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
sfp-bus.c net: switch to using PHY_INTERFACE_MODE_10GBASER rather than 10GKR 2020-01-05 15:05:35 -08:00
sfp.c net: sfp: report error on failure to read sfp soft status 2019-12-19 17:26:07 -08:00
sfp.h net: sfp: add module start/stop upstream notifications 2019-12-11 11:53:41 -08:00
smsc.c net: phy: smsc: LAN8740: add PHY_RST_AFTER_CLK_EN flag 2019-10-23 21:44:44 -07:00
spi_ks8995.c spi: Micrel eth switch: declare missing of table 2019-04-23 10:44:44 -07:00
ste10Xp.c net: phy: switch drivers to use dynamic feature detection 2019-04-15 17:19:54 -07:00
swphy.c net: phy: swphy: emulate register MII_ESTATUS 2019-08-15 11:43:48 -07:00
swphy.h
teranetics.c net: phy: remove gen10g_no_soft_reset 2019-03-03 21:47:57 -08:00
uPD60620.c net: phy: use phy_resolve_aneg_pause() 2019-12-19 12:52:34 -08:00
vitesse.c net: phy: remove calls to genphy_config_init 2019-08-17 12:34:50 -07:00
xilinx_gmii2rgmii.c net: phy: gmii2rgmii: Dont use priv field in phy device 2019-09-05 12:32:06 +02:00