Return -EBUSY if the queue is full or -ENOMEM if we failed to allocate
memory (or map a scatterlist). Also use GFP_ATOMIC to allocate the
nvme_bio and move the locking to the callers of nvme_submit_bio_queue().
In nvme_make_request(), don't permit an I/O to jump the queue -- if the
congestion list already has an entry, just add to the tail, rather than
trying to submit.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Add two reserved registers in the middle of the BAR to match the 1.0
spec plus ECN 0002.
Also rename IMC and ISC to INTMC and INTSC to conform with the spec.
We still don't need to use them :-)
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
In order to not overrun the sg array, we have to merge physically
contiguous pages into a single sg entry.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
We were passing the nvme_queue to access the q_dmadev for the
dma_alloc_coherent calls, but since we moved to the dma pool API,
we really only need the nvme_dev.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Add a second memory pool for smaller I/Os. We can pack 16 of these on a
single page instead of using an entire page for each one.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Calling dma_free_coherent from interrupt context causes warnings.
Using the DMA pools delays freeing until pool destruction, so avoids
the problem.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
There are too many things called 'info' in this driver. This data
structure is auxiliary information for a struct bio, so call it nvme_bio,
or nbio when used as a variable.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Add a pointer to the nvme_req_info to hold a new data structure
(nvme_prps) which contains a list of the pages allocated to this
particular request for holding PRP list entries. nvme_setup_prps()
now returns this pointer.
To allocate and free the memory used for PRP lists, we need a struct
device, so we need to pass the nvme_queue pointer to many functions
which didn't use to need it.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
For multipage BIOs, we were always using sg[0] instead of advancing
through the list. Oops :-)
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
If POISON_POINTER_DELTA isn't defined, ensure they're in page 0 which
should never be mapped.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
In the bio completion handler, check for bios on the congestion list
for this NVM queue. Also, lock the congestion list in the make_request
function as the queue may end up being shared between multiple CPUs.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
In addition to recording the completion data for each command, record
the anticipated completion time. Choose a timeout of 5 seconds for
normal I/Os and 60 seconds for admin I/Os.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
If we're sharing a queue between multiple CPUs and we cancel a sync I/O,
we must have the queue locked to avoid corrupting the stack of the thread
that submitted the I/O. It turns out this is the same locking that's needed
for the threaded irq handler, so share that code.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
If the adapter completes a command ID that is outside the bounds of
the array, return CMD_CTX_INVALID instead of random data, and print a
message in the sync_completion handler (which is rapidly becoming the
misc completion handler :-)
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Set the context value to CMD_CTX_COMPLETED, and print a message in the
sync_completion handler if we see it.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
I have plans for other special values in sync_completion. Plus, this
is more self-documenting, and lets us detect bogus usages.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
We're currently calling bio_endio from hard interrupt context. This is
not a good idea for preemptible kernels as it will cause longer latencies.
Using a threaded interrupt will run the entire queue processing mechanism
(including bio_endio) in a thread, which can be preempted. Unfortuantely,
it also adds about 7us of latency to the single-I/O case, so make it a
module parameter for the moment.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
We can't have preemption disabled when we call schedule(). Accept the
possibility that we'll get preempted, and it'll cost us some cacheline
bounces.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
If the user sends a fatal signal, sleeping in the TASK_KILLABLE state
permits the task to be aborted. The only wrinkle is making sure that
if/when the command completes later that it doesn't upset anything.
Handle this by setting the data pointer to 0, and checking the value
isn't NULL in the sync completion path. Eventually, bios can be cancelled
through this path too. Note that the cmdid isn't freed to prevent reuse.
We should also abort the command in the future, but this is a good start.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Because I wasn't setting driverfs_dev, the devices were showing up under
/sys/devices/virtual/block. Now they appear underneath the PCI device
which they belong to.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
In case the card has been left in a partially-configured state,
write 0 to the Enable bit.
Signed-off-by: Shane Michael Matthews <shane.matthews@intel.com>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Call pci_enable_device_mem() at initialisation and pci_disable_device
at exit.
Signed-off-by: Shane Michael Matthews <shane.matthews@intel.com>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Factor out most of nvme_identify() into a new nvme_submit_user_admin_command()
function. Change nvme_get_range_type() to call it and change nvme_ioctl to
realise that it's getting back all 64 ranges.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Generalise the code from nvme_identify() that sets PRP1 & PRP2 so that
it's usable for commands sent by nvme_submit_bio_queue().
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Add prp1, prp2 and the metadata prp to the common command, since the
fields are generally used this way.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
The admin IRQ is supposed to use the pin-based (or single message MSI)
interrupt. Accomplish this by filling in entry[0]'s vector with the
INTx irq number.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
Two callers with an almost identical long string of arguments, and
introducing a third soon. Time to factor out the commonalities.
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
When Xen is enabled, using BIOVEC_PHYS_MERGEABLE in a module
causes xen_biovec_phys_mergeable to be referenced, so it needs
to be exported.
Acked-by: Jens Axboe <axboe@kernel.dk>
Signed-off-by: Matthew Wilcox <matthew.r.wilcox@intel.com>
* git://git.infradead.org/iommu-2.6:
intel-iommu: fix superpage support in pfn_to_dma_pte()
intel-iommu: set iommu_superpage on VM domains to lowest common denominator
intel-iommu: fix return value of iommu_unmap() API
MAINTAINERS: Update VT-d entry for drivers/pci -> drivers/iommu move
intel-iommu: Export a flag indicating that the IOMMU is used for iGFX.
intel-iommu: Workaround IOTLB hang on Ironlake GPU
intel-iommu: Fix AB-BA lockdep report
Commit 4b239f458 ("x86-64, mm: Put early page table high") causes a S4
regression since 2.6.39, namely the machine reboots occasionally at S4
resume. It doesn't happen always, overall rate is about 1/20. But,
like other bugs, once when this happens, it continues to happen.
This patch fixes the problem by essentially reverting the memory
assignment in the older way.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Cc: <stable@kernel.org>
Cc: Rafael J. Wysocki <rjw@sisk.pl>
Cc: Yinghai Lu <yinghai.lu@oracle.com>
[ We'll hopefully find the real fix, but that's too late for 3.1 now ]
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
