ASoC: Updates for v5.18
Quite a quiet release for ASoC, lots of work on drivers and platforms
but nothing too groundbreaking but not much on the core itself:
- Start of moving SoF to support multiple IPC mechanisms.
- Use of NHLT ACPI table to reduce the amount of quirking required for
Intel systems.
- Some building blocks for use in forthcoming Intel AVS driver for
legacy Intel DSP firmwares.
- Support for AMD PDM, Atmel PDMC, Awinic AW8738, i.MX cards with
TLV320AIC31xx, Intel machines with CS35L41 and ESSX8336, Mediatek
MT8181 wideband bluetooth, nVidia Tegra234, Qualcomm SC7280, Renesas
RZ/V2L, Texas Instruments TAS585M
In preparation for the addition of PM runtime support move the test
key out of the register patches themselves. This is necessary to
allow the test key to be held during cache synchronisation, which is
required by the OTP settings which were unpacked from the device and
written by the driver.
Also whilst at it, the driver uses a mixture of accessing the test key
register by name and by address, consistently use the name.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20220107160636.6555-2-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
ASoC and HDA systems require the same errata patches, so
move it to the shared code using a function the correctly
applies the patches by revision
Also, move CS35L41_DSP1_CCM_CORE_CTRL write to errata
patch function as is required to be written at boot,
but not in regmap_register_patch sequence as will affect
waking up from hibernation
Signed-off-by: Lucas Tanure <tanureal@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211217115708.882525-5-tanureal@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Higher speeds are only supported when PLL is enabled, but
the current driver doesn't enable PLL outside of stream
use cases, so better to set the lowest SPI speed accepted
by the entire device.
Move the current frequency set to the spi sub-driver so
the whole device can benefit from that speed.
spi-max-frequency property could be used, but ACPI systems don't
support it, so by setting it in the spi sub-driver probe
both Device Trees and ACPI systems are supported.
Signed-off-by: Lucas Tanure <tanureal@opensource.cirrus.com>
Reviewed-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211123163149.1530535-2-tanureal@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Currently the internal monitor sources are input widgets, which means
if the card is set to fully routed these will not enable unless connected
to something in the machine driver. However, all these are internal
monitor signals so it makes no sense to connect them to something in the
machine driver. As such switch them to siggen widgets which will have
the same behaviour except not require external linkage on a fully routed
card.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Signed-off-by: David Rhodes <drhodes@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20211029214028.401284-1-drhodes@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The loop checking PDN_DONE doesn't check the return value from
regmap_read, nor does it initialise val. This means if regmap_read fails
val will be checked for the PDN_DONE bit whilst being uninitialised.
Fix this up by switching to regmap_read_poll_timeout which tidies up the
code and avoids the uninitialised variable.
Signed-off-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210914141349.30218-1-ckeepax@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
