Currently it66121_probe returns -EPROBE_DEFER if the there is no remote
endpoint found in the device tree which doesn't seem helpful, since this
is not going to change later and it is never checked if the next bridge
has been initialized yet. It will fail in that case later while doing
drm_bridge_attach for the next bridge in it66121_bridge_attach.
Since the bindings documentation for it66121 bridge driver states
there has to be a remote endpoint defined, its safe to return -EINVAL
in that case.
This additonally adds a check, if the remote endpoint is enabled and
returns -EPROBE_DEFER, if the remote bridge hasn't been initialized
(yet).
Fixes: 988156dc2f ("drm: bridge: add it66121 driver")
Signed-off-by: Alex Bee <knaerzche@gmail.com>
Signed-off-by: Robert Foss <robert.foss@linaro.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20210918140420.231346-1-knaerzche@gmail.com
These two arrays are populated with data read from the I2C device
through regmap_read(), and the data is then compared with hardcoded
vendor/product ID values of supported chips.
However, the return value of regmap_read() was never checked. This is
fine, as long as the two arrays are zero-initialized, so that we don't
compare the vendor/product IDs against whatever garbage is left on the
stack.
Address this issue by zero-initializing these two arrays.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
Fixes: 988156dc2f ("drm: bridge: add it66121 driver")
Reviewed-by: Neil Armstrong <narmstrong@baylibre.com>
Signed-off-by: Robert Foss <robert.foss@linaro.org>
Link: https://patchwork.freedesktop.org/patch/msgid/20210827163956.27517-1-paul@crapouillou.net
