Some SPI-NAND chips do not have a proper on-die ECC engine providing
error correction/detection. This is particularly an issue on embedded
devices with limited resources because all the computations must
happen in software, unless an external hardware engine is provided.
These external engines are new and can be of two categories: external
or pipelined. Macronix is providing both, the former being already
supported. The second, however, is very SoC implementation dependent
and must be instantiated by the SPI host controller directly.
An entire subsystem has been contributed to support these engines which
makes the insertion into another subsystem such as SPI quite
straightforward without the need for a lot of specific functions.
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Reviewed-by: Mark Brown <broonie@kernel.org>
Link: https://lore.kernel.org/linux-mtd/20220202144536.393792-1-miquel.raynal@bootlin.com
Fix the following waring:
drivers/spi/spi-mxic.c: In function ‘mxic_spi_mem_exec_op’:
drivers/spi/spi-mxic.c:401:3: warning: this ‘if’ clause does not guard... [-Wmisleading-indentation]
if (op->data.dir == SPI_MEM_DATA_IN)
^~
drivers/spi/spi-mxic.c:403:4: note: ...this statement, but the latter is misleadingly indented as if it were guarded by the ‘if’
if (op->data.dtr)
^~
Signed-off-by: Yang Yingliang <yangyingliang@huawei.com>
Reviewed-by: Zhengxun Li <zhengxunli@mxic.com.tw>
Link: https://lore.kernel.org/r/20210810142405.2221540-1-yangyingliang@huawei.com
Signed-off-by: Mark Brown <broonie@kernel.org>
In xSPI mode, flashes expect 2-byte opcodes. The second byte is called
the "command extension". There can be 3 types of extensions in xSPI:
repeat, invert, and hex. When the extension type is "repeat", the same
opcode is sent twice. When it is "invert", the second byte is the
inverse of the opcode. When it is "hex" an additional opcode byte based
is sent with the command whose value can be anything.
So, make opcode a 16-bit value and add a 'nbytes', similar to how
multiple address widths are handled.
Some places use sizeof(op->cmd.opcode). Replace them with op->cmd.nbytes
The spi-mxic and spi-zynq-qspi drivers directly use op->cmd.opcode as a
buffer. Now that opcode is a 2-byte field, this can result in different
behaviour depending on if the machine is little endian or big endian.
Extract the opcode in a local 1-byte variable and use that as the buffer
instead. Both these drivers would reject multi-byte opcodes in their
supports_op() hook anyway, so we only need to worry about single-byte
opcodes for now.
The above two changes are put in this commit to keep the series
bisectable.
Signed-off-by: Pratyush Yadav <p.yadav@ti.com>
Reviewed-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Link: https://lore.kernel.org/r/20200623183030.26591-3-p.yadav@ti.com
Signed-off-by: Mark Brown <broonie@kernel.org>
We should get 'driver_data' from 'struct device' directly. Going via
platform_device is an unneeded step back and forth.
Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
