i.MX8MQ/MN/MM/MP platforms typically have 2 AUDIO PLLs being
configured to handle 8kHz and 11kHz series audio rates.
The patch implements the functionality to select at runtime
the appropriate AUDIO PLL as function of audio file rate.
As the clock parent may be changed, need to probe txclk
according to sample rate again.
Signed-off-by: Viorel Suman <viorel.suman@nxp.com>
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1656667961-1799-3-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There are some new registers added on i.MX8ULP, they are
the SPDIF transmit Professional C channel registers,
192bit SPDIF receive C channel registers, and 192bit SPDIF
transmit C channel registers.
There are two output lines, SPDIF_OUT1 and SPDIF_OUT2, the
original REG_SPDIF_STCSCH and REG_SPDIF_STCSCL are used for
SPDIF_OUT1, the new REG_SPDIF_STCSPH and REG_SPDIF_STCSPL
are used for SPDIF_OUT2, the 192bit SPDIF C channel registers
are used for both.
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1647408538-2982-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Implement SPDIF bypass mode. It implies internal SoC
routing of SPDIF input signal to SPDIF output signal. The
test bed requires two boards: B1 configured in bypass mode,
and B2 to feed B1 SPDIF RX port and read B1 SPDIF TX port:
B2 TX -> B1 RX,
B2 RX <- B1 TX.
The test procedure:
a) Boot both boards
b) B2: start "arecord <spdifcard> -r 48kHz | aplay <local DAC>"
c) B2: start "aplay <spdifcard> -r 48kHz <2ch 48kHz audio file>"
d) B1: enable bypass mode:
amixer -cimxspdif cset numid=8,iface=PCM,name='Bypass Mode' on
e) B2: check DAC audio, make sure the same sample rate is used at
steps b) and c), in example above the rate is 48kHz.
f) B1: try to run "aplay" or "arecord" on imxspdif card while in
bypass mode - both must fail until bypass mode is disabled
g) B1: disable bypass mode:
amixer -cimxspdif cset numid=8,iface=PCM,name='Bypass Mode' off
h) B1: check the usual playback and capture on imxspdif card.
During this test try to set bypass mode - must not be allowed
while playback or capture is running.
Signed-off-by: Viorel Suman <viorel.suman@nxp.com>
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1632649760-1651-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
There is no defer probe when adding platform component to
snd_soc_pcm_runtime(rtd), the code is in snd_soc_add_pcm_runtime()
snd_soc_register_card()
-> snd_soc_bind_card()
-> snd_soc_add_pcm_runtime()
-> adding cpu dai
-> adding codec dai
-> adding platform component.
So if the platform component is not ready at that time, then the
sound card still registered successfully, but platform component
is empty, the sound card can't be used.
As there is defer probe checking for cpu dai component, then register
platform component before cpu dai to avoid such issue.
Fixes: a2388a498a ("ASoC: fsl: Add S/PDIF CPU DAI driver")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1630665006-31437-5-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
When system enter suspend, the machine driver suspend callback
function will be called, then the cpu driver trigger callback
(SNDRV_PCM_TRIGGER_SUSPEND) be called, it would disable the
interrupt.
But the machine driver suspend and cpu dai driver suspend order
maybe changed, the cpu dai driver's suspend callback is called before
machine driver's suppend callback, then the interrupt is not cleared
successfully in trigger callback.
So need to clear interrupts in cpu dai driver's suspend callback
to avoid such issue.
Fixes: 9cb2b3796e ("ASoC: fsl_spdif: Add pm runtime function")
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Reviewed-by: Fabio Estevam <festevam@gmail.com>
Link: https://lore.kernel.org/r/1624365084-7934-1-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
When there is power domain bind with core clock,
The call flow:
devm_regmap_init_mmio_clk
- clk_prepare()
- clk_pm_runtime_get()
cause the power domain of clock always be enabled after
regmap_init(). which impact the power consumption.
So use devm_regmap_init_mmio instead of
devm_regmap_init_mmio_clk,but explicitly enable
clock when it is used.
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1616579928-22428-3-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
In IEC958 spec, "The validity bit is logical "0" if the
information in the main data field is reliable, and it
is logical "1" if it is not".
The default value of "ValCtrl" is zero, which means
"Outgoing Validity always set", then all the data is not
reliable, then some spdif sink device will drop the data.
So set "ValCtrl" to 1, that is to clear "Outgoing Validity"
in default.
Signed-off-by: Shengjiu Wang <shengjiu.wang@nxp.com>
Link: https://lore.kernel.org/r/1594112066-31297-2-git-send-email-shengjiu.wang@nxp.com
Signed-off-by: Mark Brown <broonie@kernel.org>
We don't need dev_err() messages when platform_get_irq() fails now that
platform_get_irq() prints an error message itself when something goes
wrong. Let's remove these prints with a simple semantic patch.
// <smpl>
@@
expression ret;
struct platform_device *E;
@@
ret =
(
platform_get_irq(E, ...)
|
platform_get_irq_byname(E, ...)
);
if ( \( ret < 0 \| ret <= 0 \) )
{
(
-if (ret != -EPROBE_DEFER)
-{ ...
-dev_err(...);
-... }
|
...
-dev_err(...);
)
...
}
// </smpl>
While we're here, remove braces on if statements that only have one
statement (manually).
Cc: Liam Girdwood <lgirdwood@gmail.com>
Cc: Mark Brown <broonie@kernel.org>
Cc: Jaroslav Kysela <perex@perex.cz>
Cc: Takashi Iwai <tiwai@suse.com>
Cc: alsa-devel@alsa-project.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
Signed-off-by: Stephen Boyd <swboyd@chromium.org>
Link: https://lore.kernel.org/r/20190730181557.90391-50-swboyd@chromium.org
Signed-off-by: Mark Brown <broonie@kernel.org>
According to RM SPDIF STC SYSCLK_DF field is 9-bit wide, values
being in 0..511 range. Use a proper type to handle sysclk_df.
Signed-off-by: Viorel Suman <viorel.suman@nxp.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Add suffix ULL to constant 64 in order to give the compiler complete
information about the proper arithmetic to use.
Notice that such constant is used in a context that expects an
expression of type u64 (64 bits, unsigned) and the following
expression is currently being evaluated using 32-bit arithmetic:
rate[index] * txclk_df * 64
Addresses-Coverity-ID: 1222129 ("Unintentional integer overflow")
Signed-off-by: Gustavo A. R. Silva <gustavo@embeddedor.com>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Adopt the SPDX license identifier headers to ease license compliance
management.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Don't populate the const arrays rate on the stack, instead make them
static. Makes the object code smaller by 220 bytes:
Before:
text data bss dec hex filename
24385 9776 128 34289 85f1 sound/soc/fsl/fsl_spdif.o
After:
text data bss dec hex filename
24005 9936 128 34069 8515 sound/soc/fsl/fsl_spdif.o
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
This structure is only stored in the ops field of a snd_soc_dai_driver
structure. That field is declared const, so snd_soc_dai_ops structures
that have this property can be declared as const also.
Signed-off-by: Gustavo A. R. Silva <garsilva@embeddedor.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Same as commit ce492b3b8f
Subject: drm/fsl-dcu: use flat regmap cache
Using flat regmap cache instead of RB-tree to avoid the following
lockdep warning on driver load:
WARNING: CPU: 0 PID: 1 at kernel/locking/lockdep.c:2871 lockdep_trace_alloc+0x104/0x128
DEBUG_LOCKS_WARN_ON(irqs_disabled_flags(flags))
The RB-tree regmap cache needs to allocate new space on first
writes. However, allocations in an atomic context (e.g. when a
spinlock is held) are not allowed. The function regmap_write
calls map->lock, which acquires a spinlock in the fast_io case.
Since the driver uses MMIO, the regmap bus of type regmap_mmio
is being used which has fast_io set to true.
Signed-off-by: Marek Vasut <marex@denx.de>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
SPDIF need to enable the spba clock, when sdma is using share peripheral
script. In this case, there is two spba master port is used, if don't
enable the clock, the spba bus will have arbitration issue, which may
cause read/write wrong data from/to SPDIF registers.
Signed-off-by: Shengjiu Wang <shengjiu.wang@freescale.com>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
STL and STR registers are writable and not readable. So they are non volatile.
Remove them from volatile list, and add default register value for them.
Signed-off-by: Zidan Wang <zidan.wang@freescale.com>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
For i.MX6 SoloX, there is a mode of the SoC to shutdown all power source of
modules during system suspend and resume procedure. Thus, SPDIF needs to save
all the values of registers before the system suspend and restore them after
the system resume.
The SRPC register should be volatile, LOCK bit is set by the hardware.
Signed-off-by: Zidan Wang <zidan.wang@freescale.com>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
There are too much noise about the typos for fsl's drivers. So I fix
all the typos here in this patch in almost every file I touched.
Signed-off-by: Xiubo Li <lixiubo@cmss.chinamobile.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
We need "i" to be signed or it leads to a forever loop in the error
handling.
Fixes: fa3be9208d ('ASoC: fsl: fsl_spdif: Check for clk_prepare_enable() error')
Signed-off-by: Dan Carpenter <dan.carpenter@oracle.com>
Acked-by: Nicolin Chen <nicoleotsuka@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
