For some headsets CS42L42 autodetect mode is not working correctly.
They will be detected as unknown types or as headphones. According
to the CS42L42 datasheet, if the headset autodetect failed,
then the driver should switch to manual mode and perform a manual steps sequence.
These steps were missing in the current driver code. This patch will add manual
mode fallback steps in case autodetect failed. The default behavior is not affected,
manual mode runs only when autodetect failed.
Tested for regression with autodetect with all known headsets - no regression.
Tested with all headsets customers reported as false detected:
Gumdrop DropTech B1 - detected as headset OK
HUAWEI AM115 - detected as headset OK
UGREEN EP103 - detected as headset OK
HONOR AM116 - detected as headset OK
Stefan Binding (1):
ASoC: cs42l42: Implement Manual Type detection as fallback
sound/soc/codecs/cs42l42.c | 104 ++++++++++++++++++++++++++++++++-----
sound/soc/codecs/cs42l42.h | 54 +++++++++++++++++++
2 files changed, 146 insertions(+), 12 deletions(-)
--
2.25.1
If the machine driver doesn't call snd_soc_dai_set_sysclk() the
SCLK is assumed to be sample_rate * sample_bits * 2 (that is, the
rate necessary for a standard I2S frame).
But 24-bit samples can be sent in either a 24-bit slot or a 32-bit
slot. If the PLL is configured for a 24-bit slot, but a 32-bit slot is
used, cs42l42 will be overclocked.
Ultimately it is the machine driver's responsibilty to call
snd_soc_dai_set_sysclk() if SLK will be different from the standard
I2S rate. However, it is convenient to assume 32-bit slots to allow
this common case without needing special machine driver support. The
machine driver then only has to set SCLK if the slots are 24-bit, but
if it fails to do this cs42l42 won't be overclocked.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210805161111.10410-7-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
I2S always has two LRCLK phases and both CH1 and CH2 of the RX
must be enabled (corresponding to the low and high phases of LRCLK.)
The selection of the valid data channels is done by setting the DAC
CHA_SEL and CHB_SEL. CHA_SEL is always the first (left) channel,
CHB_SEL depends on the number of active channels.
Previously for mono ASP CH2 was not enabled, the result was playing
mono data would not produce any audio output.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Fixes: 621d65f3b8 ("ASoC: cs42l42: Provide finer control on playback path")
Link: https://lore.kernel.org/r/20210805161111.10410-4-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The lowest valid SCLK corresponds to 44.1 kHz at 16-bit. Sample
rates less than this would produce SCLK below the minimum when using
a normal I2S frame. A constraint must be applied to prevent this.
The constraint is not applied if the machine driver sets SCLK, to
allow setups where the host generates additional bits per LRCLK
phase to increase the SCLK frequency. In these cases the machine
driver would always have to inform this driver of the actual SCLK,
and it must select a legal SCLK.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210805161111.10410-3-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Both SCLK and PLL clocks must be running to drive the glitch-free mux
behind MCLK_SRC_SEL and complete the switchover.
This patch moves the writing of MCLK_SRC_SEL to when the PLL is started
and stopped, so that it only transitions while the PLL is running.
The unconditional write MCLK_SRC_SEL=0 in cs42l42_mute_stream() is safe
because if the PLL is not running MCLK_SRC_SEL is already 0.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Fixes: 43fc357199 ("ASoC: cs42l42: Set clock source for both ways of stream")
Link: https://lore.kernel.org/r/20210805161111.10410-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The driver was defining two ALSA controls that both change the same
register field for the wind noise filter corner frequency. The filter
response has two corners, at different frequencies, and the duplicate
controls most likely were an attempt to be able to set the value using
either of the frequencies.
However, having two controls changing the same field can be problematic
and it is unnecessary. Both frequencies are related to each other so
setting one implies exactly what the other would be.
Removing a control affects user-side code, but there is currently no
known use of the removed control so it would be best to remove it now
before it becomes a problem.
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Fixes: 2c394ca796 ("ASoC: Add support for CS42L42 codec")
Link: https://lore.kernel.org/r/20210803160834.9005-2-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
HSBIAS_SENSE_EN configures HSBIAS output current sense through
the external 2.21-k resistor. HSBIAS_SENSE is hardware feature to reduce
the potential pop noise during the headset plug out slowly. But on some
platforms ESD voltage will affect it causing test to fail, especially
with CTIA headset type. For different hardware setups, a designer might
want to tweak default behavior.
Signed-off-by: Vitaly Rodionov <vitalyr@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210511145220.125760-1-vitalyr@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
cs42l42 does not support standard burst transfers so the use_single_read
and use_single_write flags must be set in the regmap config.
Because of this bug, the patch:
commit 0a0eb567e1 ("ASoC: cs42l42: Minor error paths fixups")
broke cs42l42 probe() because without the use_single_* flags it causes
regmap to issue a burst read.
However, the missing use_single_* could cause problems anyway because the
regmap cache can attempt burst transfers if these flags are not set.
Fixes: 2c394ca796 ("ASoC: Add support for CS42L42 codec")
Signed-off-by: Richard Fitzgerald <rf@opensource.cirrus.com>
Acked-by: Charles Keepax <ckeepax@opensource.cirrus.com>
Link: https://lore.kernel.org/r/20210511132855.27159-1-rf@opensource.cirrus.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Pierre requested I have a look at some cppcheck warnings in the cs42l42
driver, since it is reassigning the ret variable without ever checking
the result. Looking a bit more broadly this happens in quite a few
legacy Cirrus parts, as they all use the same process to read the ID,
factor out a small helper so they can all share the same code. Whilst
in there fix up a couple of other trivial error path issues as well.
Thanks,
Charles
Charles Keepax (10):
ASoC: cirrus: Add helper function for reading the device ID
ASoC: cs35l32: Minor error paths fixups
ASoC: cs35l33: Minor error paths fixups
ASoC: cs35l34: Minor error paths fixups
ASoC: cs35l35: Minor error paths fixups
ASoC: cs35l35: Correct errata handling
ASoC: cs42l42: Minor error paths fixups
ASoC: cs42l73: Minor error paths fixups
ASoC: cs43130: Minor error paths fixups
ASoC: cs53l30: Minor error paths fixups
sound/soc/codecs/cirrus_legacy.h | 21 +++++++++++++++++++++
sound/soc/codecs/cs35l32.c | 34 ++++++++++++++++++----------------
sound/soc/codecs/cs35l33.c | 15 +++++++++------
sound/soc/codecs/cs35l34.c | 39 ++++++++++++++++++++++-----------------
sound/soc/codecs/cs35l35.c | 21 ++++++++++-----------
sound/soc/codecs/cs35l35.h | 1 +
sound/soc/codecs/cs42l42.c | 18 ++++++++----------
sound/soc/codecs/cs42l73.c | 30 +++++++++++++++++-------------
sound/soc/codecs/cs43130.c | 31 +++++++++++++++++++------------
sound/soc/codecs/cs53l30.c | 22 +++++++++++-----------
10 files changed, 136 insertions(+), 96 deletions(-)
create mode 100644 sound/soc/codecs/cirrus_legacy.h
--
2.11.0
snd_soc_dai_digital_mute() is internally using both
mute_stream() (1) or digital_mute() (2), but the difference between
these 2 are only handling direction.
We can merge digital_mute() into mute_stream
int snd_soc_dai_digital_mute(xxx, int direction)
{
...
else if (dai->driver->ops->mute_stream)
(1) return dai->driver->ops->mute_stream(xxx, direction);
else if (direction == SNDRV_PCM_STREAM_PLAYBACK &&
dai->driver->ops->digital_mute)
(2) return dai->driver->ops->digital_mute(xxx);
...
}
Signed-off-by: Kuninori Morimoto <kuninori.morimoto.gx@renesas.com>
Reviewed-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Link: https://lore.kernel.org/r/87r1tlwiwe.wl-kuninori.morimoto.gx@renesas.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Based on 2 normalized pattern(s):
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation #
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-only
has been chosen to replace the boilerplate/reference in 4122 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Enrico Weigelt <info@metux.net>
Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org>
Reviewed-by: Allison Randal <allison@lohutok.net>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081206.933168790@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
This structure is only stored in the ops field of a snd_soc_dai_driver
structure. That field is declared const, so snd_soc_dai_ops structures
that have this property can be declared as const also.
Signed-off-by: Gustavo A. R. Silva <garsilva@embeddedor.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
The gpiod API checks for NULL descriptors, so there is no need to
duplicate the check in the driver.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
