Add the compatible strings for the USB3 PHYs found on SM8150, SM8250
and SM8350 SoCs. These require separate subschemas due to the different
required clock entries.
Note the SM8150 and SM8250 compatibles have already been in place in
the dts as well as the driver implementation but were missing from
the documentation.
Signed-off-by: Jack Pham <jackp@codeaurora.org>
Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20210115174723.7424-2-jackp@codeaurora.org
Signed-off-by: Vinod Koul <vkoul@kernel.org>
This adds new bindings for the Goodix GT7375P touchscreen. While this
touchscreen's communications are based on the generic "i2c-over-hid"
protocol, it needs special power sequencing and thus gets its own
compatible and bindings.
Signed-off-by: Douglas Anderson <dianders@chromium.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Benjamin Tissoires <benjamin.tissoires@redhat.com>
The NPCM750 Timer/Watchdog Controller has multiple interrupt lines,
connected to multiple timers. The driver uses timer 0 for timer
interrupts, so the interrupt line corresponding to timer 0 should be
specified in DT.
I removed the mention of "flags for falling edge", because the timer
controller uses high-level interrupts rather than falling-edge
interrupts, and whether flags should be specified is up the interrupt
controller's DT binding.
Signed-off-by: Jonathan Neuschäfer <j.neuschaefer@gmx.net>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
Link: https://lore.kernel.org/r/20210108163004.492649-1-j.neuschaefer@gmx.net
Radxa ROCK Pi E is a router oriented SBC based on Rockchip's RK3328 SoC.
As the official wiki page puts it, "E for Ethernets".
It features the RK3328 SoC, gigabit and fast Ethernet RJ45 ports, both
directly served by Ethernet controllers in the SoC, a USB 3.0 host port,
a power-only USB type-C port, a 3.5mm headphone jack for audio output,
two LEDs, a 40-pin Raspberry Pi style GPIO header, and optional WiFi+BT
and PoE header.
The board comes in multiple configurations, differing in the amount of
onboard RAM, the level of WiFi+BT (none, 802.11n 2.4GHz, or 802.11ac
2.4 GHz & 5 GHz), and whether PoE is supported or not. These variants
can all share the same device tree.
The USB 2.0 OTG controller is available on the 40-pin header. This is
not enabled in the device tree, since it is possible to use it in a
host-only configuration, or in OTG mode with an extra pin from the
header as the ID pin.
The device tree is based on the one of the Rock64, with various parts
modified to match the ROCK Pi E, and some parts updated to newer styles,
such as the gmac2io node's mdio sub-node.
Add a compatible string for the new board.
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Link: https://lore.kernel.org/r/20210117100710.4857-3-wens@kernel.org
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Add support for the LTC4162-L Li-Ion battery charger. The driver allows
reading back telemetry and to set some charging options like the input
current limit.
This adds the devicetree bindings.
Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Add documentation and an example for Arrow SpeedChips XRS7000 Series
single chip Ethernet switches.
Signed-off-by: George McCollister <george.mccollister@gmail.com>
Reviewed-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
The SmartEEE feature of Atheros AR803x PHYs can cause the link to
bounce. Add DT properties to allow SmartEEE to be disabled, and to
allow the Tw parameters for 100M and 1G links to be configured.
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Document the device tree bindings for the Canaan Kendryte K210 SoC
Fully Programmable IO Array (FPIOA) pinctrl driver in
Documentation/devicetree/bindings/pinctrl/canaan,k210-fpioa.yaml. The
new header file include/dt-bindings/pinctrl/k210-fpioa.h is added to
define all 256 possible pin functions of the SoC IO pins, as well as
macros simplifying the definition of pin functions in a device tree.
Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Palmer Dabbelt <palmerdabbelt@google.com>
Document the device tree bindings for the Canaan Kendryte K210 SoC
reset controller driver in
Documentation/devicetree/bindings/reset/canaan,k210-rst.yaml. The header
file include/dt-bindings/reset/k210-rst.h is added to define all
possible reset lines of the SoC.
Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Palmer Dabbelt <palmerdabbelt@google.com>
Document the device tree bindings of the Canaan Kendryte K210 SoC
system controller driver in
Documentation/devicetree/bindings/mfd/canaan,k210-sysctl.yaml.
Signed-off-by: Damien Le Moal <damien.lemoal@wdc.com>
Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Palmer Dabbelt <palmerdabbelt@google.com>
Pull networking fixes from Jakub Kicinski:
"We have a few fixes for long standing issues, in particular Eric's fix
to not underestimate the skb sizes, and my fix for brokenness of
register_netdevice() error path. They may uncover other bugs so we
will keep an eye on them. Also included are Willem's fixes for
kmap(_atomic).
Looking at the "current release" fixes, it seems we are about one rc
behind a normal cycle. We've previously seen an uptick of "people had
run their test suites" / "humans actually tried to use new features"
fixes between rc2 and rc3.
Summary:
Current release - regressions:
- fix feature enforcement to allow NETIF_F_HW_TLS_TX if IP_CSUM &&
IPV6_CSUM
- dcb: accept RTM_GETDCB messages carrying set-like DCB commands if
user is admin for backward-compatibility
- selftests/tls: fix selftests build after adding ChaCha20-Poly1305
Current release - always broken:
- ppp: fix refcount underflow on channel unbridge
- bnxt_en: clear DEFRAG flag in firmware message when retry flashing
- smc: fix out of bound access in the new netlink interface
Previous releases - regressions:
- fix use-after-free with UDP GRO by frags
- mptcp: better msk-level shutdown
- rndis_host: set proper input size for OID_GEN_PHYSICAL_MEDIUM
request
- i40e: xsk: fix potential NULL pointer dereferencing
Previous releases - always broken:
- skb frag: kmap_atomic fixes
- avoid 32 x truesize under-estimation for tiny skbs
- fix issues around register_netdevice() failures
- udp: prevent reuseport_select_sock from reading uninitialized socks
- dsa: unbind all switches from tree when DSA master unbinds
- dsa: clear devlink port type before unregistering slave netdevs
- can: isotp: isotp_getname(): fix kernel information leak
- mlxsw: core: Thermal control fixes
- ipv6: validate GSO SKB against MTU before finish IPv6 processing
- stmmac: use __napi_schedule() for PREEMPT_RT
- net: mvpp2: remove Pause and Asym_Pause support
Misc:
- remove from MAINTAINERS folks who had been inactive for >5yrs"
* tag 'net-5.11-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/netdev/net: (58 commits)
mptcp: fix locking in mptcp_disconnect()
net: Allow NETIF_F_HW_TLS_TX if IP_CSUM && IPV6_CSUM
MAINTAINERS: dccp: move Gerrit Renker to CREDITS
MAINTAINERS: ipvs: move Wensong Zhang to CREDITS
MAINTAINERS: tls: move Aviad to CREDITS
MAINTAINERS: ena: remove Zorik Machulsky from reviewers
MAINTAINERS: vrf: move Shrijeet to CREDITS
MAINTAINERS: net: move Alexey Kuznetsov to CREDITS
MAINTAINERS: altx: move Jay Cliburn to CREDITS
net: avoid 32 x truesize under-estimation for tiny skbs
nt: usb: USB_RTL8153_ECM should not default to y
net: stmmac: fix taprio configuration when base_time is in the past
net: stmmac: fix taprio schedule configuration
net: tip: fix a couple kernel-doc markups
net: sit: unregister_netdevice on newlink's error path
net: stmmac: Fixed mtu channged by cache aligned
cxgb4/chtls: Fix tid stuck due to wrong update of qid
i40e: fix potential NULL pointer dereferencing
net: stmmac: use __napi_schedule() for PREEMPT_RT
can: mcp251xfd: mcp251xfd_handle_rxif_one(): fix wrong NULL pointer check
...
The bmc150-accel-i2c.c driver has an "_accel" suffix for the
compatibles of BMC150 and BMI055. This is necessary because BMC150
contains both accelerometer (bosch,bmc150_accel) and magnetometer
(bosch,bmc150_magn) and therefore "bosch,bmc150" would be ambiguous.
However, the binding documentation suggests using "bosch,bmc150".
Add the "_accel" suffix for BMC150 and BMI055 so the binding docs
match what is expected by the driver.
Fixes: 6259551cf1 ("iio: accel: bmc150-accel: Add DT bindings")
Signed-off-by: Stephan Gerhold <stephan@gerhold.net>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Reviewed-by: Rob Herring <robh@kernel.org>
Cc: Linus Walleij <linus.walleij@linaro.org>
Link: https://lore.kernel.org/r/20201202083551.7753-1-stephan@gerhold.net
Signed-off-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Pull sound fixes from Takashi Iwai:
"Here are some piled fixes, hopefully the last big one for 5.11.
All changes are device-specific small fixes, and majority of commits
are for ASoC while USB-audio got a bit large changes for addressing
the regression for devices with quirks"
* tag 'sound-5.11-rc4' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound: (31 commits)
ALSA: hda/hdmi - enable runtime pm for CI AMD display audio
ALSA: firewire-tascam: Fix integer overflow in midi_port_work()
ALSA: fireface: Fix integer overflow in transmit_midi_msg()
ALSA: hda/tegra: fix tegra-hda on tegra30 soc
clk: tegra30: Add hda clock default rates to clock driver
ALSA: doc: Fix reference to mixart.rst
ALSA: usb-audio: Fix implicit feedback sync setup for Pioneer devices
ALSA: usb-audio: Annotate the endpoint index in audioformat
ALSA: usb-audio: Avoid unnecessary interface re-setup
ALSA: usb-audio: Choose audioformat of a counter-part substream
ALSA: usb-audio: Fix the missing endpoints creations for quirks
ALSA: hda/realtek: fix right sounds and mute/micmute LEDs for HP machines
ASoC: AMD Renoir - add DMI entry for Lenovo ThinkPad X395
ASoC: amd: Replacing MSI with Legacy IRQ model
ASoC: AMD Renoir - add DMI entry for Lenovo ThinkPad E14 Gen 2
ASoC: meson: axg-tdm-interface: fix loopback
ASoC: meson: axg-tdmin: fix axg skew offset
ASoC: max98373: don't access volatile registers in bias level off
ASoC: rt711: mutex between calibration and power state changes
ASoC: Intel: haswell: Add missing pm_ops
...
