If a switch port is under a bridge, the offload_fwd_mark should be setup
before sending the skb towards the stack so that the bridge does not try
to flood the packet on the other switch ports.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for configuring per port unknown flooding by accepting both
BR_FLOOD and BR_MCAST_FLOOD as offloadable bridge port flags.
The DPAA2 switch does not support at the moment configuration of unknown
multicast flooding independently of unknown unicast flooding, therefore
check that both BR_FLOOD and BR_MCAST_FLOOD have the same state.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The BR_BCAST_FLOOD bridge port flag is now accepted by the driver and a
change in its state will determine a reconfiguration of the broadcast
egress flooding list on the FDB associated with the port.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for configuring the learning state of a switch port.
When the user requests the HW learning to be disabled, a fast-age
procedure on that specific port is run so that previously learnt
addresses do not linger.
At device probe as well as on a bridge leave action, the ports are
configured with HW learning disabled since they are basically a
standalone port.
At the same time, at bridge join we inherit the bridge port BR_LEARNING
flag state and configure it on the switch port.
There were already some MC firmware ABI functions for changing the
learning state, but those were per FDB (bridging domain) and not per
port so we need to adjust those to use the new MC fw command which is
per port.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Extract the code that determines the list of egress flood interfaces for
a specific flood type into a new function -
dpaa2_switch_fdb_get_flood_cfg().
This will help us to not duplicate code when the broadcast and
unknown ucast/mcast flooding domains will be individually configurable.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
In order to avoid a forward declaration in the next patches, move the
dpaa2_switch_fdb_set_egress_flood() function to the top of the file.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Now that the dpaa2-switch driver has basic I/O capabilities on the
switch port net_devices and multiple bridging domains are supported,
move the driver out of staging.
The dpaa2-switch driver is placed right next to the dpaa2-eth driver
since, in the near future, they will be sharing most of the data path.
I didn't implement code reuse in this patch series because I wanted to
keep it as small as possible.
Also, the README is removed from staging with the intention to add
proper rst documentation afterwards to actually match was is supported
by the driver.
Signed-off-by: Ioana Ciornei <ioana.ciornei@nxp.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
