* pci/enumeration:
PCI: Warn periodically while waiting for non-CRS ("device ready") status
PCI: Wait up to 60 seconds for device to become ready after FLR
PCI: Factor out pci_bus_wait_crs()
PCI: Add pci_bus_crs_vendor_id() to detect CRS response data
PCI: Always check for non-CRS response before timeout
PCI: Avoid race while enabling upstream bridges
PCI: Mark Broadcom HT2100 Root Port Extended Tags as broken
* pci/endpoint:
tools: PCI: Add a missing option help line
misc: pci_endpoint_test: Enable/Disable MSI using module param
misc: pci_endpoint_test: Avoid using hard-coded BAR sizes
misc: pci_endpoint_test: Add support to not enable MSI interrupts
misc: pci_endpoint_test: Add support to provide aligned buffer addresses
misc: pci_endpoint_test: Add support for PCI_ENDPOINT_TEST regs to be mapped to any BAR
PCI: designware-ep: Do not disable BARs during initialization
PCI: dra7xx: Reset all BARs during initialization
PCI: dwc: designware: Provide page_size to pci_epc_mem
PCI: endpoint: Remove the ->remove() callback
PCI: endpoint: Add support to poll early for host commands
PCI: endpoint: Add support to use _any_ BAR to map PCI_ENDPOINT_TEST regs
PCI: endpoint: Do not reset *command* inadvertently
PCI: endpoint: Add "volatile" to pci_epf_test_reg
PCI: endpoint: Add support for configurable page size
PCI: endpoint: Make ->remove() callback optional
PCI: endpoint: Add an API to get matching "pci_epf_device_id"
PCI: endpoint: Use of_dma_configure() to set initial DMA mask
* pci/host-vmd:
iommu/vt-d: Prevent VMD child devices from being remapping targets
x86/PCI: Use is_vmd() rather than relying on the domain number
x86/PCI: Move VMD quirk to x86 fixups
MAINTAINERS: Add Jonathan Derrick as VMD maintainer
PCI: vmd: Remove IRQ affinity so we can allocate more IRQs
PCI: vmd: Free up IRQs on suspend path
PCI: vmd: Assign vector zero to all bridges
PCI: vmd: Reserve IRQ pre-vector for better affinity
* pci/host-rockchip:
PCI: rockchip: Fix platform_get_irq() error handling
PCI: rockchip: Umap IO space if probe fails
PCI: rockchip: Remove IRQ domain if probe fails
PCI: rockchip: Disable vpcie0v9 if resume_noirq fails
PCI: rockchip: Clean up PHY if driver probe or resume fails
PCI: rockchip: Factor out rockchip_pcie_deinit_phys()
PCI: rockchip: Factor out rockchip_pcie_disable_clocks()
PCI: rockchip: Factor out rockchip_pcie_enable_clocks()
PCI: rockchip: Factor out rockchip_pcie_setup_irq()
PCI: rockchip: Use gpiod_set_value_cansleep() to allow reset via expanders
PCI: rockchip: Use PCI_NUM_INTX
PCI: rockchip: Explicitly request exclusive reset control
dt-bindings: phy-rockchip-pcie: Convert to per-lane PHY model
dt-bindings: PCI: rockchip: Convert to per-lane PHY model
arm64: dts: rockchip: convert PCIe to use per-lane PHYs for rk3339
PCI: rockchip: Idle inactive PHY(s)
phy: rockchip-pcie: Reconstruct driver to support per-lane PHYs
PCI: rockchip: Add per-lane PHY support
PCI: rockchip: Factor out rockchip_pcie_get_phys()
PCI: rockchip: Control optional 12v power supply
dt-bindings: PCI: rockchip: Add vpcie12v-supply for Rockchip PCIe controller
* pci/host-rcar:
PCI: rcar: Add device tree support for r8a7743/5
PCI: rcar: Fix memory leak when no PCIe card is inserted
PCI: rcar: Fix error exit path
* pci/host-qcom:
PCI: qcom: Add support for IPQ8074 PCIe controller
dt-bindings: PCI: qcom: Add support for IPQ8074
PCI: qcom: Use block IP version for operations
PCI: qcom: Explicitly request exclusive reset control
PCI: qcom: Use gpiod_set_value_cansleep() to allow reset via expanders
* pci/host-mediatek:
PCI: mediatek: Use PCI_NUM_INTX
PCI: mediatek: Add MSI support for MT2712 and MT7622
PCI: mediatek: Use bus->sysdata to get host private data
dt-bindings: PCI: Add support for MT2712 and MT7622
PCI: mediatek: Add controller support for MT2712 and MT7622
dt-bindings: PCI: Cleanup MediaTek binding text
dt-bindings: PCI: Rename MediaTek binding
PCI: mediatek: Switch to use platform_get_resource_byname()
PCI: mediatek: Add a structure to abstract the controller generations
PCI: mediatek: Rename port->index and mtk_pcie_parse_ports()
PCI: mediatek: Use readl_poll_timeout() to wait for Gen2 training
PCI: mediatek: Explicitly request exclusive reset control
* pci/host-layerscape:
PCI: layerscape: Add support for ls1088a
PCI: layerscape: Add support for ls2088a
PCI: artpec6: Stop enabling writes to DBI read-only registers
PCI: layerscape: Remove unnecessary class code fixup
PCI: dwc: Enable write permission for Class Code, Interrupt Pin updates
PCI: dwc: Add accessors for write permission of DBI read-only registers
PCI: layerscape: Disable outbound windows configured by bootloader
PCI: layerscape: Refactor ls1021_pcie_host_init()
PCI: layerscape: Move generic init functions earlier in file
PCI: layerscape: Add class code and multifunction fixups for ls1021a
PCI: layerscape: Move STRFMR1 access out from the DBI write-enable bracket
PCI: layerscape: Call dw_pcie_setup_rc() from ls_pcie_host_init()
* pci/host-designware:
PCI: dwc: Clear MSI interrupt status after it is handled, not before
PCI: qcom: Allow ->post_init() to fail
PCI: qcom: Don't unroll init if ->init() fails
PCI: dwc: designware: Handle ->host_init() failures
PCI: dwc: designware: Test PCIE_ATU_ENABLE bit specifically
PCI: dwc: designware: Make dw_pcie_prog_*_atu_unroll() static
Apparently the PCIe capability is at address 0x40 in config space of X-Gene
v1 Root Ports. Add a definition of that and use the generic PCI_EXP_RTCTL
offset into the capability. No functional change intended.
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
When platform_get_irq() fails we should propagate the real error value
instead of always returning -EINVAL.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Duc Dang <dhdang@apm.com>
When platform_get_irq() fails we should propagate the real error value
instead of always returning -EINVAL.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Michal Simek <michal.simek@xilinx.com>
When platform_get_irq() fails we should propagate the real error value
instead of always returning -EINVAL.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Shawn Lin <shawn.lin@rock-chips.com>
platform_get_irq() returns a negative number on failure, so adjust the
logic to detect such condition and propagate the real error value on
failure.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Ley Foon Tan <lftan@altera.com>
platform_get_irq() returns a negative number on failure, so adjust the
logic to detect such condition and propagate the real error value on
failure.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Pratyush Anand <pratyush.anand@gmail.com>
platform_get_irq() returns a negative number on failure, so adjust the
logic to detect such condition and propagate the real error value on
failure.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Niklas Cassel <niklas.cassel@axis.com>
platform_get_irq() returns a negative number on failure, so adjust the
logic to detect such condition and propagate the real error value on
failure.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Cc: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
When platform_get_irq() fails we should propagate the real error value
instead of always returning -EINVAL.
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Kishon Vijay Abraham I <kishon@ti.com>
platform_get_irq() returns a negative number on failure, so adjust the
logic to detect such condition and propagate the real error value on
failure.
Reported-by: Bjorn Helgaas <helgaas@kernel.org>
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Jingoo Han <jingoohan1@gmail.com>
PCI_EXP_CAP is an iProc-specific value, so rename it to IPROC_PCI_EXP_CAP
to make it obvious that it's not related to the generic values like
PCI_EXP_RTCTL, etc. No functional change intended.
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
