solos: Clean up firmware loading code

We no longer try to load firmware while the ATM is up and running.
However, this means that we _do_ make init_module() wait for it, and it
takes a long time for now (since we're using ultra-conservative code in
the FPGA for that too).

The inner loop which uses swahb32p() was by Simon Farnsworth.

Simon has patches which migrate us to request_firmware_nowait(), for
which we'll actually need to take down the ATM devices, do the upgrade,
then reregister them.

Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
This commit is contained in:
David Woodhouse 2009-01-27 14:16:12 +11:00
parent 7c4015bdff
commit fa755b9f2b

View File

@ -93,7 +93,7 @@ struct solos_card {
spinlock_t cli_queue_lock;
struct sk_buff_head tx_queue[4];
struct sk_buff_head cli_queue[4];
int flash_chip;
wait_queue_head_t fw_wq;
};
#define SOLOS_CHAN(atmdev) ((int)(unsigned long)(atmdev)->phy_data)
@ -112,11 +112,7 @@ module_param(firmware_upgrade, int, 0444);
module_param(fpga_upgrade, int, 0444);
static int opens;
static struct firmware *fw;
static int flash_offset;
void flash_upgrade(struct solos_card *);
void flash_write(struct solos_card *);
static void fpga_queue(struct solos_card *card, int port, struct sk_buff *skb,
struct atm_vcc *vcc);
static int fpga_tx(struct solos_card *);
@ -202,129 +198,73 @@ static ssize_t console_store(struct device *dev, struct device_attribute *attr,
static DEVICE_ATTR(console, 0644, console_show, console_store);
void flash_upgrade(struct solos_card *card){
static int flash_upgrade(struct solos_card *card, int chip)
{
const struct firmware *fw;
const char *fw_name;
uint32_t data32 = 0;
int blocksize = 0;
int numblocks = 0;
dev_info(&card->dev->dev, "Flash upgrade started\n");
if (card->flash_chip == 0) {
if (request_firmware((const struct firmware **)&fw,
"solos-FPGA.bin",&card->dev->dev))
{
dev_info(&card->dev->dev,
"Failed to find firmware\n");
return;
}
int offset;
if (chip == 0) {
fw_name = "solos-FPGA.bin";
blocksize = FPGA_BLOCK;
} else {
if (request_firmware((const struct firmware **)&fw,
"solos-Firmware.bin",&card->dev->dev))
{
dev_info(&card->dev->dev,
"Failed to find firmware\n");
return;
}
fw_name = "solos-Firmware.bin";
blocksize = SOLOS_BLOCK;
}
numblocks = fw->size/blocksize;
dev_info(&card->dev->dev, "Firmware size: %d\n", fw->size);
if (request_firmware(&fw, fw_name, &card->dev->dev))
return -ENOENT;
dev_info(&card->dev->dev, "Flash upgrade starting\n");
numblocks = fw->size / blocksize;
dev_info(&card->dev->dev, "Firmware size: %zd\n", fw->size);
dev_info(&card->dev->dev, "Number of blocks: %d\n", numblocks);
dev_info(&card->dev->dev, "Changing FPGA to Update mode\n");
iowrite32(1, card->config_regs + FPGA_MODE);
data32 = ioread32(card->config_regs + FPGA_MODE);
/*Set mode to Chip Erase*/
if (card->flash_chip == 0) {
dev_info(&card->dev->dev,
"Set FPGA Flash mode to FPGA Chip Erase\n");
} else {
dev_info(&card->dev->dev,
"Set FPGA Flash mode to Solos Chip Erase\n");
}
iowrite32((card->flash_chip * 2), card->config_regs + FLASH_MODE);
flash_offset = 0;
/* Set mode to Chip Erase */
dev_info(&card->dev->dev, "Set FPGA Flash mode to %s Chip Erase\n",
chip?"Solos":"FPGA");
iowrite32((chip * 2), card->config_regs + FLASH_MODE);
iowrite32(1, card->config_regs + WRITE_FLASH);
return;
}
wait_event(card->fw_wq, !ioread32(card->config_regs + FLASH_BUSY));
void flash_write(struct solos_card *card){
int block;
int block_num;
int blocksize;
int i;
uint32_t data32 = 0;
for (offset = 0; offset < fw->size; offset += blocksize) {
int i;
/*Clear write flag*/
iowrite32(0, card->config_regs + WRITE_FLASH);
/*Set mode to Block Write*/
/*dev_info(&card->dev->dev, "Set FPGA Flash mode to Block Write\n");*/
iowrite32(((card->flash_chip * 2) + 1), card->config_regs + FLASH_MODE);
/*When finished programming flash, release firmware and exit*/
if (fw->size - flash_offset == 0) {
//release_firmware(fw); /* This crashes for some reason */
/* Clear write flag */
iowrite32(0, card->config_regs + WRITE_FLASH);
iowrite32(0, card->config_regs + FPGA_MODE);
iowrite32(0, card->config_regs + FLASH_MODE);
dev_info(&card->dev->dev, "Returning FPGA to Data mode\n");
return;
}
if (card->flash_chip == 0) {
blocksize = FPGA_BLOCK;
} else {
blocksize = SOLOS_BLOCK;
}
/*Calculate block size*/
if ((fw->size - flash_offset) > blocksize) {
block = blocksize;
} else {
block = fw->size - flash_offset;
}
block_num = flash_offset / blocksize;
//dev_info(&card->dev->dev, "block %d/%d\n",block_num + 1,(fw->size/512/8));
/*Copy block into RAM*/
for(i=0;i<block;i++){
if(i%4 == 0){
//dev_info(&card->dev->dev, "i: %d\n", i);
data32=0x00000000;
}
switch(i%4){
case 0:
data32 |= 0x0000FF00 &
(*(fw->data + i + flash_offset) << 8);
break;
case 1:
data32 |= 0x000000FF & *(fw->data + i + flash_offset);
break;
case 2:
data32 |= 0xFF000000 &
(*(fw->data + i + flash_offset) << 24);
break;
case 3:
data32 |= 0x00FF0000 &
(*(fw->data + i + flash_offset) << 16);
break;
/* Set mode to Block Write */
/* dev_info(&card->dev->dev, "Set FPGA Flash mode to Block Write\n"); */
iowrite32(((chip * 2) + 1), card->config_regs + FLASH_MODE);
/* Copy block to buffer, swapping each 16 bits */
for(i = 0; i < blocksize; i += 4) {
uint32_t word = swahb32p((uint32_t *)(fw->data + offset + i));
iowrite32(word, RX_BUF(card, 3) + i);
}
if (i%4 == 3) {
iowrite32(data32, RX_BUF(card, 3) + i - 3);
}
}
i--;
if (i%4 != 3) {
iowrite32(data32, RX_BUF(card, 3) + i - (i%4));
/* Specify block number and then trigger flash write */
iowrite32(offset / blocksize, card->config_regs + FLASH_BLOCK);
iowrite32(1, card->config_regs + WRITE_FLASH);
wait_event(card->fw_wq, !ioread32(card->config_regs + FLASH_BUSY));
}
/*Specify block number and then trigger flash write*/
iowrite32(block_num, card->config_regs + FLASH_BLOCK);
iowrite32(1, card->config_regs + WRITE_FLASH);
// iowrite32(0, card->config_regs + WRITE_FLASH);
flash_offset += block;
return;
release_firmware(fw);
iowrite32(0, card->config_regs + WRITE_FLASH);
iowrite32(0, card->config_regs + FPGA_MODE);
iowrite32(0, card->config_regs + FLASH_MODE);
dev_info(&card->dev->dev, "Returning FPGA to Data mode\n");
return 0;
}
static irqreturn_t solos_irq(int irq, void *dev_id)
@ -337,10 +277,10 @@ static irqreturn_t solos_irq(int irq, void *dev_id)
//Disable IRQs from FPGA
iowrite32(0, card->config_regs + IRQ_EN_ADDR);
/* If we only do it when the device is open, we lose console
messages */
if (1 || opens)
if (card->atmdev[0])
tasklet_schedule(&card->tlet);
else
wake_up(&card->fw_wq);
//Enable IRQs from FPGA
iowrite32(1, card->config_regs + IRQ_EN_ADDR);
@ -354,17 +294,6 @@ void solos_bh(unsigned long card_arg)
uint32_t card_flags;
uint32_t tx_mask;
uint32_t rx_done = 0;
uint32_t data32;
data32 = ioread32(card->config_regs + FPGA_MODE);
if (data32 != 0) {
data32 = ioread32(card->config_regs + FLASH_BUSY);
if (data32 == 0) {
flash_write(card);
}
return;
}
card_flags = ioread32(card->config_regs + FLAGS_ADDR);
@ -749,6 +678,7 @@ static int fpga_probe(struct pci_dev *dev, const struct pci_device_id *id)
return -ENOMEM;
card->dev = dev;
init_waitqueue_head(&card->fw_wq);
err = pci_enable_device(dev);
if (err) {
@ -794,15 +724,13 @@ static int fpga_probe(struct pci_dev *dev, const struct pci_device_id *id)
card->nr_ports = 2; /* FIXME: Detect daughterboard */
err = atm_init(card);
if (err)
goto out_unmap_both;
pci_set_drvdata(dev, card);
tasklet_init(&card->tlet, solos_bh, (unsigned long)card);
spin_lock_init(&card->tx_lock);
spin_lock_init(&card->tx_queue_lock);
spin_lock_init(&card->cli_queue_lock);
/*
// Set Loopback mode
data32 = 0x00010000;
@ -832,24 +760,33 @@ static int fpga_probe(struct pci_dev *dev, const struct pci_device_id *id)
//dev_dbg(&card->dev->dev, "Requesting IRQ: %d\n",dev->irq);
err = request_irq(dev->irq, solos_irq, IRQF_DISABLED|IRQF_SHARED,
"solos-pci", card);
if (err)
if (err) {
dev_dbg(&card->dev->dev, "Failed to request interrupt IRQ: %d\n", dev->irq);
goto out_unmap_both;
}
// Enable IRQs
iowrite32(1, card->config_regs + IRQ_EN_ADDR);
if(firmware_upgrade != 0){
card->flash_chip = 1;
flash_upgrade(card);
} else {
if(fpga_upgrade != 0){
card->flash_chip = 0;
flash_upgrade(card);
}
}
if (fpga_upgrade)
flash_upgrade(card, 0);
if (firmware_upgrade)
flash_upgrade(card, 1);
err = atm_init(card);
if (err)
goto out_free_irq;
return 0;
out_free_irq:
iowrite32(0, card->config_regs + IRQ_EN_ADDR);
free_irq(dev->irq, card);
tasklet_kill(&card->tlet);
out_unmap_both:
pci_set_drvdata(dev, NULL);
pci_iounmap(dev, card->config_regs);
out_unmap_config:
pci_iounmap(dev, card->buffers);