pinctrl: pinctrl-adi2: disable IRQ when setting value

GPIO output value should be set after the GPIO interrupt is disabled.
Use BIT macro as well.

Signed-off-by: Sonic Zhang <sonic.zhang@analog.com>
[Edited commit message]
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
Sonic Zhang 2013-10-08 15:31:21 +08:00 committed by Linus Walleij
parent 010c51e189
commit d3224ed140

View File

@ -766,9 +766,9 @@ static void adi_gpio_set_value(struct gpio_chip *chip, unsigned offset,
spin_lock_irqsave(&port->lock, flags);
if (value)
writew(1 << offset, &regs->data_set);
writew(BIT(offset), &regs->data_set);
else
writew(1 << offset, &regs->data_clear);
writew(BIT(offset), &regs->data_clear);
spin_unlock_irqrestore(&port->lock, flags);
}
@ -780,12 +780,14 @@ static int adi_gpio_direction_output(struct gpio_chip *chip, unsigned offset,
struct gpio_port_t *regs = port->regs;
unsigned long flags;
adi_gpio_set_value(chip, offset, value);
spin_lock_irqsave(&port->lock, flags);
writew(readw(&regs->inen) & ~(1 << offset), &regs->inen);
writew(1 << offset, &regs->dir_set);
writew(readw(&regs->inen) & ~BIT(offset), &regs->inen);
if (value)
writew(BIT(offset), &regs->data_set);
else
writew(BIT(offset), &regs->data_clear);
writew(BIT(offset), &regs->dir_set);
spin_unlock_irqrestore(&port->lock, flags);