forked from Minki/linux
[PATCH] skge: spelling fixes
Fix some of my bad spelling. Signed-off-by: Stephen Hemminger <shemminger@osdl.org> Signed-off-by: Jeff Garzik <jgarzik@pobox.com>
This commit is contained in:
parent
1631aef151
commit
8f3f8193a4
@ -130,7 +130,7 @@ static void skge_get_regs(struct net_device *dev, struct ethtool_regs *regs,
|
||||
regs->len - B3_RI_WTO_R1);
|
||||
}
|
||||
|
||||
/* Wake on Lan only supported on Yukon chps with rev 1 or above */
|
||||
/* Wake on Lan only supported on Yukon chips with rev 1 or above */
|
||||
static int wol_supported(const struct skge_hw *hw)
|
||||
{
|
||||
return !((hw->chip_id == CHIP_ID_GENESIS ||
|
||||
@ -170,8 +170,8 @@ static int skge_set_wol(struct net_device *dev, struct ethtool_wolinfo *wol)
|
||||
return 0;
|
||||
}
|
||||
|
||||
/* Determine supported/adverised modes based on hardware.
|
||||
* Note: ethtoool ADVERTISED_xxx == SUPPORTED_xxx
|
||||
/* Determine supported/advertised modes based on hardware.
|
||||
* Note: ethtool ADVERTISED_xxx == SUPPORTED_xxx
|
||||
*/
|
||||
static u32 skge_supported_modes(const struct skge_hw *hw)
|
||||
{
|
||||
@ -532,13 +532,13 @@ static inline u32 hwkhz(const struct skge_hw *hw)
|
||||
return 78215; /* or: 78.125 MHz */
|
||||
}
|
||||
|
||||
/* Chip hz to microseconds */
|
||||
/* Chip HZ to microseconds */
|
||||
static inline u32 skge_clk2usec(const struct skge_hw *hw, u32 ticks)
|
||||
{
|
||||
return (ticks * 1000) / hwkhz(hw);
|
||||
}
|
||||
|
||||
/* Microseconds to chip hz */
|
||||
/* Microseconds to chip HZ */
|
||||
static inline u32 skge_usecs2clk(const struct skge_hw *hw, u32 usec)
|
||||
{
|
||||
return hwkhz(hw) * usec / 1000;
|
||||
@ -1163,7 +1163,7 @@ static void bcom_phy_init(struct skge_port *skge, int jumbo)
|
||||
xm_phy_write(hw, port, PHY_BCOM_P_EXT_CTRL, ext);
|
||||
xm_phy_write(hw, port, PHY_BCOM_CTRL, ctl);
|
||||
|
||||
/* Use link status change interrrupt */
|
||||
/* Use link status change interrupt */
|
||||
xm_phy_write(hw, port, PHY_BCOM_INT_MASK, PHY_B_DEF_MSK);
|
||||
|
||||
bcom_check_link(hw, port);
|
||||
@ -1203,7 +1203,7 @@ static void genesis_mac_init(struct skge_hw *hw, int port)
|
||||
skge_write32(hw, B2_GP_IO, r);
|
||||
skge_read32(hw, B2_GP_IO);
|
||||
|
||||
/* Enable GMII interfac */
|
||||
/* Enable GMII interface */
|
||||
xm_write16(hw, port, XM_HW_CFG, XM_HW_GMII_MD);
|
||||
|
||||
bcom_phy_init(skge, jumbo);
|
||||
@ -1254,7 +1254,7 @@ static void genesis_mac_init(struct skge_hw *hw, int port)
|
||||
* that jumbo frames larger than 8192 bytes will be
|
||||
* truncated. Disabling all bad frame filtering causes
|
||||
* the RX FIFO to operate in streaming mode, in which
|
||||
* case the XMAC will start transfering frames out of the
|
||||
* case the XMAC will start transferring frames out of the
|
||||
* RX FIFO as soon as the FIFO threshold is reached.
|
||||
*/
|
||||
xm_write32(hw, port, XM_MODE, XM_DEF_MODE);
|
||||
@ -1321,7 +1321,7 @@ static void genesis_stop(struct skge_port *skge)
|
||||
port == 0 ? PA_CLR_TO_TX1 : PA_CLR_TO_TX2);
|
||||
|
||||
/*
|
||||
* If the transfer stucks at the MAC the STOP command will not
|
||||
* If the transfer sticks at the MAC the STOP command will not
|
||||
* terminate if we don't flush the XMAC's transmit FIFO !
|
||||
*/
|
||||
xm_write32(hw, port, XM_MODE,
|
||||
@ -1559,7 +1559,7 @@ static u16 gm_phy_read(struct skge_hw *hw, int port, u16 reg)
|
||||
return v;
|
||||
}
|
||||
|
||||
/* Marvell Phy Initailization */
|
||||
/* Marvell Phy Initialization */
|
||||
static void yukon_init(struct skge_hw *hw, int port)
|
||||
{
|
||||
struct skge_port *skge = netdev_priv(hw->dev[port]);
|
||||
@ -2156,7 +2156,7 @@ static int skge_up(struct net_device *dev)
|
||||
hw->intr_mask |= portirqmask[port];
|
||||
skge_write32(hw, B0_IMSK, hw->intr_mask);
|
||||
|
||||
/* Initialze MAC */
|
||||
/* Initialize MAC */
|
||||
spin_lock_bh(&hw->phy_lock);
|
||||
if (hw->chip_id == CHIP_ID_GENESIS)
|
||||
genesis_mac_init(hw, port);
|
||||
@ -2476,7 +2476,7 @@ static void yukon_set_multicast(struct net_device *dev)
|
||||
reg = gma_read16(hw, port, GM_RX_CTRL);
|
||||
reg |= GM_RXCR_UCF_ENA;
|
||||
|
||||
if (dev->flags & IFF_PROMISC) /* promiscious */
|
||||
if (dev->flags & IFF_PROMISC) /* promiscuous */
|
||||
reg &= ~(GM_RXCR_UCF_ENA | GM_RXCR_MCF_ENA);
|
||||
else if (dev->flags & IFF_ALLMULTI) /* all multicast */
|
||||
memset(filter, 0xff, sizeof(filter));
|
||||
@ -2799,7 +2799,7 @@ static void skge_error_irq(struct skge_hw *hw)
|
||||
}
|
||||
|
||||
/*
|
||||
* Interrrupt from PHY are handled in tasklet (soft irq)
|
||||
* Interrupt from PHY are handled in tasklet (soft irq)
|
||||
* because accessing phy registers requires spin wait which might
|
||||
* cause excess interrupt latency.
|
||||
*/
|
||||
@ -3233,7 +3233,7 @@ static int __devinit skge_probe(struct pci_dev *pdev,
|
||||
}
|
||||
|
||||
#ifdef __BIG_ENDIAN
|
||||
/* byte swap decriptors in hardware */
|
||||
/* byte swap descriptors in hardware */
|
||||
{
|
||||
u32 reg;
|
||||
|
||||
|
Loading…
Reference in New Issue
Block a user