typo fixes: occuring -> occurring

Signed-off-by: Adrian Bunk <bunk@stusta.de>

Documentation/memory-barriers.txt

@@ -602,7 +602,7 @@ Consider the following sequence of events:
 
 This sequence of events is committed to the memory coherence system in an order
 that the rest of the system might perceive as the unordered set of { STORE A,
-STORE B, STORE C } all occuring before the unordered set of { STORE D, STORE E
+STORE B, STORE C } all occurring before the unordered set of { STORE D, STORE E
 }:
 
 	+-------+       :      :

arch/i386/mm/fault.c

@@ -389,7 +389,7 @@ fastcall void __kprobes do_page_fault(struct pt_regs *regs,
 	/* When running in the kernel we expect faults to occur only to
 	 * addresses in user space.  All other faults represent errors in the
 	 * kernel and should generate an OOPS.  Unfortunatly, in the case of an
-	 * erroneous fault occuring in a code path which already holds mmap_sem
+	 * erroneous fault occurring in a code path which already holds mmap_sem
 	 * we will deadlock attempting to validate the fault against the
 	 * address space.  Luckily the kernel only validly references user
 	 * space from well defined areas of code, which are listed in the

arch/m32r/mm/fault.c

@@ -148,7 +148,7 @@ asmlinkage void do_page_fault(struct pt_regs *regs, unsigned long error_code,
 	/* When running in the kernel we expect faults to occur only to
 	 * addresses in user space.  All other faults represent errors in the
 	 * kernel and should generate an OOPS.  Unfortunatly, in the case of an
-	 * erroneous fault occuring in a code path which already holds mmap_sem
+	 * erroneous fault occurring in a code path which already holds mmap_sem
 	 * we will deadlock attempting to validate the fault against the
 	 * address space.  Luckily the kernel only validly references user
 	 * space from well defined areas of code, which are listed in the

arch/powerpc/platforms/powermac/cpufreq_32.c

@@ -268,7 +268,7 @@ static int pmu_set_cpu_speed(int low_speed)
 
 	/* Make sure the decrementer won't interrupt us */
 	asm volatile("mtdec %0" : : "r" (0x7fffffff));
-	/* Make sure any pending DEC interrupt occuring while we did
+	/* Make sure any pending DEC interrupt occurring while we did
 	 * the above didn't re-enable the DEC */
 	mb();
 	asm volatile("mtdec %0" : : "r" (0x7fffffff));

arch/powerpc/platforms/pseries/eeh_driver.c

@@ -175,7 +175,7 @@ static void eeh_report_failure(struct pci_dev *dev, void *userdata)
  *
  * pSeries systems will isolate a PCI slot if the PCI-Host
  * bridge detects address or data parity errors, DMA's
- * occuring to wild addresses (which usually happen due to
+ * occurring to wild addresses (which usually happen due to
  * bugs in device drivers or in PCI adapter firmware).
  * Slot isolations also occur if #SERR, #PERR or other misc
  * PCI-related errors are detected.

arch/x86_64/mm/fault.c

@@ -418,7 +418,7 @@ asmlinkage void __kprobes do_page_fault(struct pt_regs *regs,
 	/* When running in the kernel we expect faults to occur only to
 	 * addresses in user space.  All other faults represent errors in the
 	 * kernel and should generate an OOPS.  Unfortunatly, in the case of an
-	 * erroneous fault occuring in a code path which already holds mmap_sem
+	 * erroneous fault occurring in a code path which already holds mmap_sem
 	 * we will deadlock attempting to validate the fault against the
 	 * address space.  Luckily the kernel only validly references user
 	 * space from well defined areas of code, which are listed in the

drivers/infiniband/hw/ipath/ipath_intr.c

@@ -397,7 +397,7 @@ static void handle_errors(struct ipath_devdata *dd, ipath_err_t errs)
 		if ((dd->ipath_maskederrs & ~dd->ipath_ignorederrs) &
 		    ~(INFINIPATH_E_RRCVEGRFULL | INFINIPATH_E_RRCVHDRFULL))
 			ipath_dev_err(dd, "Disabling error(s) %llx because "
-				      "occuring too frequently (%s)\n",
+				      "occurring too frequently (%s)\n",
 				      (unsigned long long)
 				      (dd->ipath_maskederrs &
 				       ~dd->ipath_ignorederrs), msg);

drivers/message/fusion/mptbase.c

@@ -5592,7 +5592,7 @@ mpt_HardResetHandler(MPT_ADAPTER *ioc, int sleepFlag)
 
 	/* The SCSI driver needs to adjust timeouts on all current
 	 * commands prior to the diagnostic reset being issued.
-	 * Prevents timeouts occuring during a diagnostic reset...very bad.
+	 * Prevents timeouts occurring during a diagnostic reset...very bad.
 	 * For all other protocol drivers, this is a no-op.
 	 */
 	{

drivers/net/wireless/ipw2100.c

@@ -5358,7 +5358,7 @@ static int ipw2100_set_key(struct ipw2100_priv *priv,
 		     idx, keylen, len);
 
 	/* NOTE: We don't check cached values in case the firmware was reset
-	 * or some other problem is occuring.  If the user is setting the key,
+	 * or some other problem is occurring.  If the user is setting the key,
 	 * then we push the change */
 
 	wep_key->idx = idx;

drivers/serial/pxa.c

@@ -390,7 +390,7 @@ static int serial_pxa_startup(struct uart_port *port)
 
 	/*
 	 * Finally, enable interrupts.  Note: Modem status interrupts
-	 * are set via set_termios(), which will be occuring imminently
+	 * are set via set_termios(), which will be occurring imminently
 	 * anyway, so we don't enable them here.
 	 */
 	up->ier = UART_IER_RLSI | UART_IER_RDI | UART_IER_RTOIE | UART_IER_UUE;

include/asm-arm/thread_info.h

@@ -116,7 +116,7 @@ extern void iwmmxt_task_release(struct thread_info *);
 
 /*
  * We use bit 30 of the preempt_count to indicate that kernel
- * preemption is occuring.  See include/asm-arm/hardirq.h.
+ * preemption is occurring.  See include/asm-arm/hardirq.h.
  */
 #define PREEMPT_ACTIVE	0x40000000
 

include/asm-ia64/sn/tioca_provider.h

@@ -27,7 +27,7 @@
 #define PV908234 (1 << 1)
   /* CA:AGPDMA write request data mismatch with ABC1CL merge */
 #define PV895469 (1 << 1)
-  /* TIO:CA TLB invalidate of written GART entries possibly not occuring in CA*/
+  /* TIO:CA TLB invalidate of written GART entries possibly not occurring in CA*/
 #define PV910244 (1 << 1)
 
 struct tioca_dmamap{

kernel/cpuset.c

@@ -1064,7 +1064,7 @@ static int update_flag(cpuset_flagbits_t bit, struct cpuset *cs, char *buf)
 }
 
 /*
- * Frequency meter - How fast is some event occuring?
+ * Frequency meter - How fast is some event occurring?
  *
  * These routines manage a digitally filtered, constant time based,
  * event frequency meter.  There are four routines: