PCI: Run ACPI _OSC method on root bridges only

According to the PCI Firmware Specification Revision 3.0 section 4.5, _OSC
should only be called on a root brdige.  Here is the relevant passage: "The
_OSC interface defined in this section applies only to Host Bridge ACPI
devices that originate PCI, PCI-X, or PCI Express hierarchies". Changed the
code to find the parent root bridge of the device and call _OSC on that.

Signed-off-by: Andrew Patterson <andrew.patterson@hp.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
This commit is contained in:
Andrew Patterson 2008-01-22 17:18:27 -07:00 committed by Greg Kroah-Hartman
parent d8634ddd37
commit 3c75e23784

View File

@ -31,23 +31,13 @@ int aer_osc_setup(struct pcie_device *pciedev)
{
acpi_status status = AE_NOT_FOUND;
struct pci_dev *pdev = pciedev->port;
acpi_handle handle = DEVICE_ACPI_HANDLE(&pdev->dev);
struct pci_bus *parent;
acpi_handle handle = 0;
while (!handle) {
if (!pdev || !pdev->bus->parent)
break;
parent = pdev->bus->parent;
if (!parent->self)
/* Parent must be a host bridge */
handle = acpi_get_pci_rootbridge_handle(
pci_domain_nr(parent),
parent->number);
else
handle = DEVICE_ACPI_HANDLE(
&(parent->self->dev));
pdev = parent->self;
}
/* Find root host bridge */
while (pdev->bus && pdev->bus->self)
pdev = pdev->bus->self;
handle = acpi_get_pci_rootbridge_handle(
pci_domain_nr(pdev->bus), pdev->bus->number);
if (handle) {
pcie_osc_support_set(OSC_EXT_PCI_CONFIG_SUPPORT);