clk: shmobile: rcar-gen2: fix lb/sd0/sd1/sdh clock parent to pll1

The clock generator for rcar-gen2 has the lb, sdh, sd0 and sd1 clocks
parented to pll1_div2 where the hardware diagram shows these to be
directly fed from pll1.

This fixes the initial rate for sdh0 clock to be 97.5MHz instead of
the reported 48MHz where the manual says the default register values
are for 97.5MHz.

Signed-off-by: Ben Dooks <ben.dooks@codethink.co.uk>
Acked-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Mike Turquette <mturquette@linaro.org>
This commit is contained in:
Ben Dooks 2014-03-31 15:50:34 +01:00 committed by Mike Turquette
parent e5ca8fb4cc
commit 365b01869b

View File

@ -210,22 +210,22 @@ rcar_gen2_cpg_register_clock(struct device_node *np, struct rcar_gen2_cpg *cpg,
parent_name = "main";
mult = config->pll3_mult;
} else if (!strcmp(name, "lb")) {
parent_name = "pll1_div2";
parent_name = "pll1";
div = cpg_mode & BIT(18) ? 36 : 24;
} else if (!strcmp(name, "qspi")) {
parent_name = "pll1_div2";
div = (cpg_mode & (BIT(3) | BIT(2) | BIT(1))) == BIT(2)
? 8 : 10;
} else if (!strcmp(name, "sdh")) {
parent_name = "pll1_div2";
parent_name = "pll1";
table = cpg_sdh_div_table;
shift = 8;
} else if (!strcmp(name, "sd0")) {
parent_name = "pll1_div2";
parent_name = "pll1";
table = cpg_sd01_div_table;
shift = 4;
} else if (!strcmp(name, "sd1")) {
parent_name = "pll1_div2";
parent_name = "pll1";
table = cpg_sd01_div_table;
shift = 0;
} else if (!strcmp(name, "z")) {