linux/arch/powerpc/configs/corenet64_smp_defconfig

147 lines
3.1 KiB
Plaintext
Raw Normal View History

CONFIG_PPC64=y
CONFIG_PPC_BOOK3E_64=y
# CONFIG_VIRT_CPU_ACCOUNTING is not set
CONFIG_SMP=y
CONFIG_NR_CPUS=2
CONFIG_EXPERIMENTAL=y
CONFIG_SYSVIPC=y
CONFIG_BSD_PROCESS_ACCT=y
CONFIG_IRQ_DOMAIN_DEBUG=y
CONFIG_NO_HZ=y
CONFIG_HIGH_RES_TIMERS=y
CONFIG_IKCONFIG=y
CONFIG_IKCONFIG_PROC=y
CONFIG_LOG_BUF_SHIFT=14
CONFIG_BLK_DEV_INITRD=y
CONFIG_EXPERT=y
CONFIG_KALLSYMS_ALL=y
CONFIG_MODULES=y
CONFIG_MODULE_UNLOAD=y
CONFIG_MODULE_FORCE_UNLOAD=y
CONFIG_MODVERSIONS=y
# CONFIG_BLK_DEV_BSG is not set
CONFIG_PARTITION_ADVANCED=y
CONFIG_MAC_PARTITION=y
CONFIG_P5020_DS=y
powerpc/85xx: Add support for P5040DS board Add support for the Freescale P5040DS Reference Board ("Superhydra"), which is similar to the P5020DS. Features of the P5040 are listed below, but not all of these features (e.g. DPAA networking) are currently supported. Four P5040 single-threaded e5500 cores built Up to 2.4 GHz with 64-bit ISA support Three levels of instruction: user, supervisor, hypervisor CoreNet platform cache (CPC) 2.0 MB configures as dual 1 MB blocks hierarchical interconnect fabric Two 64-bit DDR3/3L SDRAM memory controllers with ECC and interleaving support Up to 1600MT/s Memory pre-fetch engine DPAA incorporating acceleration for the following functions Packet parsing, classification, and distribution (FMAN) Queue management for scheduling, packet sequencing and congestion management (QMAN) Hardware buffer management for buffer allocation and de-allocation (BMAN) Cryptography acceleration (SEC 5.0) at up to 40 Gbps SerDes 20 lanes at up to 5 Gbps Supports SGMII, XAUI, PCIe rev1.1/2.0, SATA Ethernet interfaces Two 10 Gbps Ethernet MACs Ten 1 Gbps Ethernet MACs High-speed peripheral interfaces Two PCI Express 2.0/3.0 controllers Additional peripheral interfaces Two serial ATA (SATA 2.0) controllers Two high-speed USB 2.0 controllers with integrated PHY Enhanced secure digital host controller (SD/MMC/eMMC) Enhanced serial peripheral interface (eSPI) Two I2C controllers Four UARTs Integrated flash controller supporting NAND and NOR flash DMA Dual four channel Support for hardware virtualization and partitioning enforcement Extra privileged level for hypervisor support QorIQ Trust Architecture 1.1 Secure boot, secure debug, tamper detection, volatile key storage Signed-off-by: Timur Tabi <timur@freescale.com> Signed-off-by: Kumar Gala <galak@kernel.crashing.org>
2012-07-26 15:08:54 +00:00
CONFIG_P5040_DS=y
# CONFIG_PPC_OF_BOOT_TRAMPOLINE is not set
CONFIG_BINFMT_MISC=m
CONFIG_IRQ_ALL_CPUS=y
CONFIG_PCIEPORTBUS=y
CONFIG_PCI_MSI=y
CONFIG_RAPIDIO=y
CONFIG_FSL_RIO=y
CONFIG_NET=y
CONFIG_PACKET=y
CONFIG_UNIX=y
CONFIG_XFRM_USER=y
CONFIG_NET_KEY=y
CONFIG_INET=y
CONFIG_IP_MULTICAST=y
CONFIG_IP_ADVANCED_ROUTER=y
CONFIG_IP_MULTIPLE_TABLES=y
CONFIG_IP_ROUTE_MULTIPATH=y
CONFIG_IP_ROUTE_VERBOSE=y
CONFIG_IP_PNP=y
CONFIG_IP_PNP_DHCP=y
CONFIG_IP_PNP_BOOTP=y
CONFIG_IP_PNP_RARP=y
CONFIG_NET_IPIP=y
CONFIG_IP_MROUTE=y
CONFIG_IP_PIMSM_V1=y
CONFIG_IP_PIMSM_V2=y
CONFIG_ARPD=y
CONFIG_INET_ESP=y
# CONFIG_INET_XFRM_MODE_BEET is not set
# CONFIG_INET_LRO is not set
CONFIG_IPV6=y
CONFIG_IP_SCTP=m
CONFIG_UEVENT_HELPER_PATH="/sbin/hotplug"
CONFIG_DEVTMPFS=y
CONFIG_MTD=y
CONFIG_MTD_CMDLINE_PARTS=y
CONFIG_MTD_CHAR=y
CONFIG_MTD_BLOCK=y
CONFIG_MTD_CFI=y
CONFIG_MTD_CFI_AMDSTD=y
CONFIG_MTD_PHYSMAP_OF=y
CONFIG_MTD_M25P80=y
CONFIG_MTD_NAND=y
CONFIG_MTD_NAND_FSL_ELBC=y
CONFIG_MTD_NAND_FSL_IFC=y
CONFIG_PROC_DEVICETREE=y
CONFIG_BLK_DEV_LOOP=y
CONFIG_BLK_DEV_RAM=y
CONFIG_BLK_DEV_RAM_SIZE=131072
CONFIG_EEPROM_LEGACY=y
CONFIG_ATA=y
CONFIG_SATA_FSL=y
CONFIG_SATA_SIL24=y
CONFIG_NETDEVICES=y
CONFIG_DUMMY=y
CONFIG_INPUT_FF_MEMLESS=m
# CONFIG_INPUT_MOUSEDEV is not set
# CONFIG_INPUT_KEYBOARD is not set
# CONFIG_INPUT_MOUSE is not set
CONFIG_SERIO_LIBPS2=y
CONFIG_SERIAL_8250=y
CONFIG_SERIAL_8250_CONSOLE=y
CONFIG_SERIAL_8250_MANY_PORTS=y
CONFIG_SERIAL_8250_DETECT_IRQ=y
CONFIG_SERIAL_8250_RSA=y
CONFIG_I2C=y
CONFIG_I2C_CHARDEV=y
CONFIG_I2C_MPC=y
CONFIG_SPI=y
CONFIG_SPI_GPIO=y
CONFIG_SPI_FSL_SPI=y
CONFIG_SPI_FSL_ESPI=y
# CONFIG_HWMON is not set
CONFIG_VIDEO_OUTPUT_CONTROL=y
CONFIG_USB_HID=m
CONFIG_USB=y
CONFIG_USB_MON=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_EHCI_FSL=y
CONFIG_USB_STORAGE=y
CONFIG_MMC=y
CONFIG_MMC_SDHCI=y
CONFIG_EDAC=y
CONFIG_EDAC_MM_EDAC=y
CONFIG_DMADEVICES=y
CONFIG_FSL_DMA=y
CONFIG_EXT2_FS=y
CONFIG_EXT3_FS=y
CONFIG_ISO9660_FS=m
CONFIG_JOLIET=y
CONFIG_ZISOFS=y
CONFIG_UDF_FS=m
CONFIG_MSDOS_FS=m
CONFIG_VFAT_FS=y
CONFIG_NTFS_FS=y
CONFIG_PROC_KCORE=y
CONFIG_TMPFS=y
CONFIG_HUGETLBFS=y
# CONFIG_MISC_FILESYSTEMS is not set
CONFIG_NFS_FS=y
CONFIG_NFS_V4=y
CONFIG_ROOT_NFS=y
CONFIG_NFSD=m
CONFIG_NLS_ISO8859_1=y
CONFIG_NLS_UTF8=m
CONFIG_CRC_T10DIF=y
CONFIG_FRAME_WARN=1024
CONFIG_MAGIC_SYSRQ=y
CONFIG_DEBUG_FS=y
CONFIG_DEBUG_SHIRQ=y
CONFIG_DETECT_HUNG_TASK=y
CONFIG_DEBUG_INFO=y
CONFIG_CRYPTO_NULL=y
CONFIG_CRYPTO_PCBC=m
CONFIG_CRYPTO_MD4=y
CONFIG_CRYPTO_SHA256=y
CONFIG_CRYPTO_SHA512=y
CONFIG_CRYPTO_AES=y
# CONFIG_CRYPTO_ANSI_CPRNG is not set
CONFIG_CRYPTO_DEV_FSL_CAAM=y